static thrust 中文意思是什麼
static thrust
解釋
靜推力-
Radial - thrust floating - ring hybrid bearing, which can not only sustain the radial load but also the axial load, colligate the strongpoints of pure dynamic and static bearings
徑?推聯合浮環動靜壓軸承自二十世紀七十年代經提出后，已進行了較為系統的研究。 -
Small craft - static thrust measurement for outboard motors
舷外機的靜推力測定 -
Small crafts - outboard motors - static thrust measurement
小艇.外置馬達.靜態推力的測量 -
Brush - holders for electrical machines ; guide to the measurement of the static thrust applied to brushes
電機用刷握.作用於電刷的靜推力的測量指南 -
B ) equivalent circuit method and finite element analysis ( fea ) to compute the static force are presented, the results obtained by each method are compared one with the other. c ) the results of dynamic simulation by means of the software, ansoft show the hlfm " s characteristics when the motor works in the special frequency and single stroke and the conditions used for position control. d ) the measured static thrust - displacement characteristics and the dynamic characteristics during starting show good correlation with the calculated results
在設計並製作了實驗樣機的基礎上所做的研究內容包括； （ 1 ）分別用能量法和麥克斯韋張量法推導電磁力的計算公式，並討論他們的不同應用范圍； （ 2 ）分別用等效磁路法和有限元法作直線力電機的靜特性分析，並比較分析它們的計算結果； （ 3 ）用有限元模擬軟體做直線力電機動態特性的模擬，分別分析直線力電機的頻率特性、動子開合閘特性和開環位置控制的工作特性； （ 4 ）做直線力電機的靜推力?位移特性實驗和動子開合閘的動態實驗，並將實驗結果與計算結果進行對比，實驗驗證了計算模型及計算方法的正確性。 -
A cascaded architecture is adopted, where desired propeller rate of revolution is generated by solving a static 2nd order equation with a parameter of desired thrust force, which is the input of the speed / position tracking control
在推進器動態模型的基礎上，採用滑模控制的方法，由速度位置誤差獲得期望推力，再通過求解包括來流速度的二次方程得到期望螺旋槳轉速。 -
In the test, static - dynamic method is used to measure the stiffness, the eight stiffness coefficients of the radial part and the two stiffness coefficients of the thrust part can be obtained though loading slowly to the testing bearing which is in a equilibrium position
首先，對處于平衡位置的測試軸承分別沿水平方向、鉛垂方向及軸向緩慢施加載荷，根據靜動法原理求得各個轉速下測試軸承徑向部分內、外膜8個剛度系數以及推力部分內、外膜2個剛度系數。 -
Computation formulas of pressure distribution and dynamic and static characteristics of radius - thrust float ring hybrid bearing are deduced
建立了數學模型，推導出相應的reynolds方程和動靜特性系數表達式。 -
This paper is a part of the research project named the static and dynamic characteristic research of the radial - thrust floating ring hybrid bearing which is supported by the natural science and technology research foundation of the nation
本文完成的工作是國家自然科學基金項目「徑向?推力聯合浮環動靜壓軸承靜、動特性研究」中的一部分。 -
The results indicate that with decrease of exit area of secondary nozzle, the bypass ratio is decreasing, and the static pressure in integrated ejector combustor is increasing, and mixing condition becomes better. there exists an optimal exit area of secondary nozzle to get maximum thrust of rocket ejector
結果表明：引射能力隨著二次噴管出口面積的減小而減小；整體式引射燃燒室壓強隨著二次噴管出口面積的減小而上升，混合隨之更為充分；存在一個最優的二次噴管出口面積，使發動機推力最大。
分享友人