static x 中文意思是什麼
static x
解釋
靜電-
For additional information on how to configure a dynamic - to - static vpn tunnel between the pix and asa, refer to pix / asa 7. x pix - to - pix dynamic - to - static ipsec with nat and vpn client configuration example
也就是說，如果靜態圖和動態圖混用的時候，應該將動態圖放在前面，否則就會出現我遇到的問題。 -
Thermal decomposition of ferrous oxalate dihydrate was investigated using in situ x - ray diffraction ( xrd ) analysis and thermogravimetry in static self - generated air
摘要用原位xrd技術和熱重法分析了二水草酸亞鐵的熱分解過程，並進行了動力學研究。 -
Based on the pull - out tests data between geogrids and expansive soil / sands arranged by the orthogonal table l9 ( 34 ), the following conclusions are reached : 1 ) the displacement - properties of pullout tests depend on the pullout speed. the law of factors " affecting degree, which influences the parameters between geogrids and soils in the pulling - out procedure, is obtained. with the concept of " equivalent pull - out displacement ( x ) " brought forward, the whole process of pull out tests is divided into two process - " main process ( when x 1. 0 ) " and " residual process ( when x 1. 0 ) ", and three stages - static friction resistance stage, slip friction resistance stage, and residual friction resistance stage
基於正交設計表l9 （ 3 ~ 4 ）分別安排了影響因素與土工格柵膨脹土或砂土界面相互作用參數的拉拔試驗數據，獲悉： 1 ）拉拔試驗位移特性主要取決于影響因素中拉拔速率；通過分析並獲取影響因素對筋土界面相互作用參數的影響程度及其在拉拔試驗過程中的變化規律，提出了當量拉拔位移（ x ）的概念，並據此將拉拔試驗全過程劃分成「主過程（ x 1 . 0 ） 」和「殘余過程（ x 1 . 0 ） 」 ；且將影響因素對拉拔力或摩擦阻力系數的影響程度分成三階段（靜摩擦阻力階段、滑動摩擦阻力階段，殘余摩擦阻力階段） ； 2 ）不同（規范）定義的筋土界面摩擦阻力系數數值相差較大，但影響因素對摩擦阻力系數影響程度及其變化規律不會因不同（規范）定義而受到影響。 -
A series of static and fatigue experiments which include lots of specimens are performed on bolted composite laminates that include different sizes, different lay orientations and different torques. dye - enhanced x - radiography is used to check the progressive damage process as evaluation techniques, which can be made nondestructively. finally, the ultimate strength and fatigue life of composite bolted joints in static tension and
層合板接頭的試驗研究考慮了多種幾何尺寸、多種鋪層及不同擰緊力矩對其靜強度及疲勞性能的影響，同時使用滲透劑增強的x射線圖象技術對靜載和疲勞損傷擴展及累積過程進行了無損檢測，並對其進行了分析探討。 -
The procedure of the test is as follows : first, the piezoelectric stack has been examined to test the performance parameters of the piezoelectric material ; second, the 2 - x actuator has been functioned with different static voltage to test its capability ; last, function the 2 - x actuator with voltage with different frequencies to test its dynamic properties. all the output of the actuator has been measured by the laser vibration measurement
首先對壓電堆進行試驗，驗證壓電材料的性能參數;再對推挽式雙x驅動器施加不同的靜電壓驅動它，驗證作動器的驅動能力，最後對推挽式雙x驅動器輸入不同頻率的電壓驅動，測量該驅動機構的動態特性，試驗均採用激光測試儀測量推挽式雙x驅動器的輸出特性。 -
At last, a test for the 2 - x actuator has been performed, in which the static and dynamic output of the actuator has been tested to examine the design
對推挽式雙x驅動器進行了原理性試驗研究，測試推挽式雙x驅動器的靜態和動態輸出，檢驗設計方案的合理性。 -
After that, the static and dynamic properties of the actuator has been studied, the dynamic equation has been modeled. through the analysis, we can see the 2 - x actuator can provide the bidirectional force and displacement
對于推挽式雙x驅動器，初步分析了其靜態和動態力學性能，建立相應的動力學方程，從理論上求證了推挽式雙x驅動器能夠提供雙向的作用力和位移輸出。 -
How does the localhost design process differ to that of a static ( x ) html web page
在本地的設計模板的過程和設計靜態的（ x ） html網頁有啥不同？ -
In the traditional way, the servo valve static characteristics tests are done by the signal generator and the x - y recorder
傳統的靜態性能試驗通過信號發生器產生測試信號， x - y記錄儀繪特性曲線完成。 -
Study on the impact of x - tail on static stability for an uav
型尾翼布局對無人機靜穩定性的影響 -
Quasi - static - state gain in ne - like ar capillary discharge pumped x - ray laser
光激光中的準穩態增益 -
In fundamental theory, adaptive optics, electrostatic actuation, flexure beam theory and squeeze film damping are researched ; in fabrication, bulk micro fabrication process and surface micro fabrication process are researched and compared, then the structure parameters and layout of a 8 x 8 micromirror array are designed using summit foundry ; in analysis, analytical and numerical method are used to perform static analysis, modal analysis, transient analysis, frequency analysis and to characterize the farfield performance of this 8x8 micromirror array. finally, in order to realize large scale micromirror array with lower snap down voltage, advices are given for further research
在基本理論方面，通過對自適應光學，靜電力驅動，彈性梁理論和擠壓薄膜阻尼的研究，確定了微變形鏡的配置方案；在加工方面對體加工工藝， mumps工藝和summit工藝進行了研究與比較，並選用殘余應力小，表面質量好的summit工藝對8 8的微變形鏡陣列原型進行了結構設計與版圖設計；在分析方面主要對微變形鏡單元的靜態特性，模態特性，瞬態響應，頻率響應和8 8規模的微變形鏡陣列的遠場光學模型進行了研究，確定了微變形鏡的性能參數。
分享友人