stationary temperature 中文意思是什麼

stationary temperature 解釋
不變的溫度。

  • stationary : adj. 不動的，靜止的，不變的；不增不減的，固定的，裝定的。n. 1. 不動的人，固定物。2. 〈pl. 〉駐軍。n. -ariness
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. No conformity was found between the measured values and the calculated stationary temperature field.

    人們發現實測值和預測的穩態溫度場之間並不相符。
  2. Up to now, we have treated the stationary temperature field under the influence of lateral changes of thermal conductivities in the underground.

    截至目前為止，我們討論的一直是處于地下熱導率側向變化影響下的穩定溫度場。
  3. Based on the relaxation constitutive theory of viscosity - elasticity under non - constant temperature, the equation of thermal conduction in solids, and the finite element method, the non - stationary thermal stress in low carbon steel thick hollow sphere is calculated

    摘要基於變溫粘彈性鬆弛型本構理論、熱傳導方程和有限元方法，對低破鋼厚壁球的非定常熱應力進行了分析。
  4. Except for types of stationary phase, components of mobile phase and types of detectors, other prescribed conditions under each type, such as internal radius and length of chromatographic column, brand of stationary phase, carrier granularity, flow speed of mobile phase, as well as proportion, column temperature, volume of incoming samples of different components of mixed mobile phase and sensitivity of detector can be appropriately changed to accommodate different chromatographic system and reach requirements for applicable test of the system

    各品種項下規定的條件除固定相種類、流動相組成、檢測器類型不得任意改變外，其餘如色譜柱內徑、長度、固定相牌號、載體粒度、流動相流速、混合流動相各組成的比例、柱溫、迸樣量、檢測器的靈敏度等，均可適當改變，以適應具體的色譜系統並達到系統適用性試驗的要求。
  5. When the theory of temperature in solids 、 the equivalent tension - relaxation curve of final temperature, and the equivalent shear - relaxation curve is known, then the non - stationary stress is calculated

    在非定常熱應力計算時只要確定物體內部各點的溫度歷史，及其終態溫度等效拉伸鬆弛曲線、等效剪切鬆弛曲線，便可計算出物體內各點的瞬態熱應力。
  6. Change in force transducer s zero signal referred to the characteristic value, as a result of a change in ambient temperature by 10 k within a defined temperature range after adjustment of stationary states

    每10k零點信號的溫度影響穩態調節以後，規定溫度范圍內周圍溫度變化10k時力傳感器根據特徵值的零點信號產生的變化。
  7. In order to resolve the friction between rotating and stationary parts of steam turbine unit, the boundary condition and temperature field of them should be known

    為了解決汽輪機動靜間隙的碰磨問題，需要計算汽缸和轉子的溫度場。
  8. Finally, after calculating iron loss and copper loss with the magnetic field analysis, use it as a heat source, and conduct a non - stationary analysis independently with the three dimensional thermal analysis which concentrates on the effect of the heat transfer coefficient on the temperature rise. in this paper, a bipolar switched reluctance machine system model is also established with an h bridge converter as its power circuit topology

    另外，本文還建立了雙極型sr電機系統模型，採用了h橋式功率主電路，詳細分析了其工作原理，並在磁場、損耗等方面與採用不對稱半橋變換器的傳統單極型sr電機系統進行了對比。
  9. Wavelengths or scales of surface heterogeneity are less than 20km. simulation results show that cbls do reach a quasi - stationary state correspondent to specified surfaces, after a long enough evolution. in this transition process and after that, horizontal statistics, i. e. mean potential temperature and vertical heat - flux, show profiles little differences to those over homogeneous flat surface. main effect of surface heterogeneity is to increase kinetic energy in cbl and the increase concentrates in the direction of surface heterogeneity. the time of cbl spent to reach its first peak of mean kinetic energy,

    模擬結果表明，在充分長的時間后，邊界層達到一種適合於地面條件的準定常態。這種準定常態和向其過渡的過程中，水平平均的邊界層廓線性質，如平均位溫廓線垂直熱通量廓線等幾乎與平坦均勻地面的結果相同，或差異極小。地面非均勻性的主要作用是使邊界層動能增大，並以地面非均勻性變化方向的動能增加為主。
  10. In this system, the soft hardware complex - compensate technique is adopted to enhance the precision of temperature control, the analog pi controller, whose parameters are adjusted by analog fuzzy controller, is designed to enhance the stationary response

    該溫度控制系統利用軟硬體復合補償的方法提高溫度控制的精度，利用模糊參數可調的模擬pi控制器提高系統的穩態響應。
  11. Relative change in the characteristic value of the force transducer as a result of a change in ambient temperature by 10 k within a defined temperature range after adjustment of stationary states

    穩態調節以後，當周圍溫度在規定溫度范圍內變化10k時，力轉換器的特徵值的相應變化。
  12. High temperature combustion process results in nitrogen oxides emissions including nitrogen dioxide, which may come from stationary sources such as power stations, and mobile sources such as motor vehicles

    當燃燒工序以高溫進行時會排放氮氧化合物包括二氧化氮。發電廠及車輛排出的廢氣是二氧化氮的主要來源。
  13. High temperature combustion process results in nitrogen oxides emissions ( including nitrogen dioxide ), which may come from stationary sources such as power stations, and mobile sources such as motor vehicles

    來源當燃燒工序以高溫進行時會排放氮氧化合物（包括二氧化氮） 。發電廠及車輛排出的廢氣是二氧化氮的主要來源。
分享友人
分享到 Line

分享到臉書