statistic energy analysis 中文意思是什麼
statistic energy analysis
解釋
統計能量分析-
Based on many references, a evaluating function is proposed with performance index of hall call waiting time ( hwt ), people number in a car, energy consuming. the statistic approximation algorithm for hwt is introduced, based on the analysis of elevator traffic state, the calculation of traveling distance and stop number is explained in detail in the thesis. according to the characteristics of the elevator, a group of elevator teaching signals are constructed, by which the weight coefficients are trained according to the widrow - hoff rule
本文在借鑒了大量的文獻基礎上，提出以平均等候時間、轎廂人數、能源消耗為性能指標的評價函數；詳細介紹了乘客待梯時間hwt的統計近似演算法；基於對電梯交通狀況的分析，對停層次數和運行距離這兩個重要參數的計算進行了詳盡的介紹；依據電梯運行特性參數，構造一組電梯運行教師信號，並採用神經網路的widrow - hoff學習規則訓練權系數。 -
Aimed at some problems such as short spraying distance, electricity - leaking and reverse ionization among electrostatic nozzles existing in the country, a induction charging and pneumatic energy electrostatic nozzle was designed. the basic designing theories, structure and working process of this nozzles were theoretically specified in the paper. and then the atomization quality and charge performances of this nozzle and its affecting factors were studied by carrying out performance experiment and statistic analysis. result of the studies indicate : ( 1 ) some progress were made in solving the problems list above ; ( 2 ) from this nozzle, droplet were minute and uniform, and higher charge - mass ratio can be obtained under lower electrostatic voltage, thus the atomization quality and charge performance of this nozzle were both better ; ( 3 ) within the experiment extend, air pressure at 0. 2mpa, electrostatic voltage at 2400v were the most suitable parameters for the nozzle ; ( 4 ) the regression equations for describing droplet size, intensity of spray current and charge - mass ratio of this nozzle obtained from the experiment data had higher forecast precision ; ( 5 ) cross - effect of all factors were not significant, the atomization quality and charge performance were relative dependency affected by the factors
諸試驗因素中，充電電壓和噴孔直徑對霧滴荷質比均有極顯著的影響；氣體壓力和液體流量對霧滴荷質比的影響均不顯著；影響霧滴荷質比的主要因素依次為充電電壓和噴孔直徑; （ 8 ）在300v 、 600v 、 1200y 、 1800y 、 2400v 、 3000v六種充電電壓t ，霧滴荷質比先隨充電電壓的增加而增大， 2400v后荷質比減小，推測:對于所研製的噴頭可能存在一個最佳充電電壓; （ 9 ）由充電電壓和噴孔直徑的不同搭配所得霧滴荷質比不同這一結果，可看出，較大充電電壓需配備較大噴孔直徑以增強霧滴荷電效果; （ 10 ） td3 . 6和td3 . 4兩噴頭的霧滴荷質比曲線趨于重合，說明噴孔直徑大於滬3
分享友人