steady-state method 中文意思是什麼

steady-state method 解釋
穩態法
  • steady : adj 1 穩固的,平穩的,穩定的,不變的(腳步、努力等)。2 堅定的,扎實的,牢靠的(船等)。3 有規則...
  • state : n 1 〈常作 S 〉國,國家;〈通例作 S 〉(美國、澳洲的)州;〈the States〉 美國。2 國務,政權,政府...
  • method : n 1 方法,方式;順序。2 (思想、言談上的)條理,規律,秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Standard test method for measuring the steady - state thermal transmittance of fenestration systems using hot box methods

    隔熱箱法測定主窗設計系統的穩態熱傳遞系數的標準試驗方法
  2. The method can eliminate the conventional fuzzy control system ' s steady - state errors and flutters. and, the method of forward feed control is used to reduce the tracing errors during glide slope phase

    在此基礎上,採用帶優化修正函數無量化的模糊控制方法,設計飛機的微波著陸控制系統,並進行了閉環模擬。
  3. Test method for measuring steady - state primary photocurrent

    測量穩態原始光電流的標準試驗方法
  4. With this understanding, the advancing analysis method of the steady - state voltage stability integrated the continuation power flow analysis, the system jacobi matrix eigenvalue structure analysis and the correlative sensitivity analysis, provided the comprehensive and veracious informations about the steady - state voltage stability of power system under the future operating state, these informations - included the margin of stability, the weak buses, the crucial branch and the crucial generator

    提出了將連續潮流演算法與系統jacobi矩陣特徵結構分解法以及相關的靈敏度方法相結合的靜態電壓穩定預測分析方法,這種方法可以提供關于系統在未來運行狀態下的靜態穩定性信息:系統穩定裕度、系統中的薄弱區域、關鍵支路與關鍵發電機。
  5. For a class of series - wound active power line conditioner the design approach law of a new fuzzy integral sliding mode variable structure control is presented. this method adjusts power electronic switch in order to achieve anticipated balance volt, finally makes active power line conditioner not only possess good robustness of variable - structure control and decrease vibration to the most but also increase the steady state precision. series - wound aplc adopted this control method possesses good dynamic and steady state performance

    針對串聯型有源電網調節器運用變結構控制策略,調節電力電子開關模式,以獲得預期的平衡電壓,對串聯型有源電網調節器提出了模糊積分變結構控制方法,使串聯型有源電網調節器既保持了常規滑模控制強魯棒性的優點,又減弱了滑模控制的抖振,提高了系統的穩態精度,使系統具有良好的動態和靜態性能,模擬試驗表明該控制策略是一種十分有效的控制方法。
  6. Determination of steady - state thermal transmission properties - hot box method

    穩定狀態熱傳輸特性的測定.熱盒方法
  7. The dynamic model of misaligned rotor - bearing system equipped with a flexible laminated membrane coupling was developed by using the method of lumped parameter in this dissertation, and the dynamic behavior, such as the nature characteristics, stability, steady state response of the system, etc. was analyzed based on the theory of linear vibration

    本文根據集總參數法建立了膜片聯軸器耦合的不對中轉子?軸承系統的動力學模型。基於線性振動理論分析了系統的固有特性、穩定性和不平衡響應。
  8. Standard test method for steady - state heat flux measurements and thermal transmission properties by means of the guarded - hot - plate apparatus

    用護熱板法測定穩態熱通量和傳導性的標準試驗方法
  9. The explicit finite element method ( fem ) based on the varying time - step was selected to analyse the dynamic roll - pass process ; the nodes on the leading face of the steady - state elements set was extracted and projected onto a plane to give the required mesh, also called the origin mesh ; the implicit fem was selected to analyses the inter - pass transient thermal process ; a geometric part from the mesh was generated and meshed by using the quadrilateral elements, a heat transfer analysis was selected to transfer the node temperature data ; a new model was created by using hexahedral elements, mapping the node temperature and the equivalent plastic strain on the integration points

    利用基於變步長中心差分格式的顯式積分方法分析瞬態軋制過程;提取穩態單元集節點形成截面網格;利用隱式積分方法分析軋制道次間隙瞬態溫度場;對型鋼斷面進行平面四邊形網格劃分並映射節點溫度數據;利用六面體單元構建有限元分析模型,映射單元節點的溫度、積分點的等效塑性應變,進行數值分析。
  10. The method can not only reduce the system steady - state error, but also soften control

    該方法與飽和特性平滑策略相結合,可使系統既能滿足穩態誤差的要求,又能滿足平滑控制量的要求。
  11. Solving 2 - d inverse heat transfer problems with multi - variables in steady - state via conjugate gradient method based on second - order sensitivity

    基於二階敏度的共軛梯度法求解多宗量穩態傳熱反問題
  12. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念,對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成電流閉環系統的穩態誤差,並用根軌跡法對轉子位移控制系統的校正環節進行了研究。
  13. 3. for the two - region model of one - dimensional solute transport through heterogeneous soils considering scale - dependent dispersion and immobile region under steady state flow, the numerical model is obtained by characteristic finite element method

    對于穩態水流條件下,非均質土壤中考慮水動力彌散尺度效應以及不動水體存在時,一維溶質運移的兩區模型,建立了相應的特徵有限元數值模型。
  14. The main research work of the thesis is summarized as follows : 1. the improved fuzzy logic control method the phenomenon of steady - state errors and flutter exists in the traditional fuzzy controller. an improved fuzzy controller without quantilizing is presented

    地形跟隨飛行控制律設計針對某型飛機應用控制航跡角法和控製法向加速度法對不同的反饋信號分別設計了pi控制器和模糊控制器,並做了模擬比較與魯棒性驗證。
  15. Fuzzy control is a simple and practical control method that had been developed in recent years. it has some adaptive ability for process parameter changes, but its steady - state accuracy is unsatisfactory

    模糊控制是近年來發展起來的一種簡單實用的控制方法,對被控過程參數變化有一定的適應能力,但它的穩態精度較差。
  16. And then we bring forward an approach to get the probability of steady - state based on gauss - seidel method and dynamic row - column techniques for the application of simulation in safety " analysis, sampling techniques for sparse events are discussed, and importance sampling method is brought forward to increase sampling efficiency

    論文提出了基於gauss - seidel方法與動態行列技術的分析方法。在模擬方面,主要探討了安全性定量分析中稀有事件問題的抽樣技術,並提出採用重要性抽樣法,以提高抽樣效率。
  17. Diesel engine - exhaust smoke measurement method at steady state

    柴油機穩態排氣煙度及測定方法
  18. Ph linearization method is employed to solve a nonlinear reynolds equation for a steady state and micro - scale flow field, and the approximate function expressions of gas dynamic pressure and velocity in the spiral groove are obtained

    摘要應用ph線性化方法、迭代法,近似求解了螺旋槽內穩態微尺度流動場的非線性雷諾方程,求得了氣體動壓和速度分佈的解析解。
  19. Application of wu method in solving for all the steady - state power flow solutions

    吳消元法在精確求解電力系統潮流方程中的應用
  20. Using the steady - state productivity equation, a conventional method, is difficult to theoretically deal with the randomly dispersed natural fractures

    用等值滲流阻力法解決了這個難題,建立了裂縫性低滲透油藏穩態滲流的理論模型。
分享友人