step calibration 中文意思是什麼

step calibration 解釋
步進校準
  • step : vi （ pp ）1 走；跨步。2 踩，踏上 （on）。3 跳舞，輕快地走，合著步調走。4 跨入，踏進。5 走上。vt ...
  • calibration : n. 1. 測定口徑。2. 刻度，標度，劃度數。3. 校準；標準化。
  1. In the self - calibration scheme, the thesis emphasizes the accuracy of camera intrinsic and extrinsic parameters. we presents an accurate f method based on corresponding point adjustment. the method adjusts coresponding points according to the fixedness of projective transformed cross ratio, then calculates f matrix accurately through linear and non - linear methods. when computing intrinsic parameter, a matrix, we simplify the step, and stress on the two important parameters of a. the result will be getten through solving kruppa equation based on svd decomposition. in order to compute extrinsic parameters, we use linear method to get initial r and t, then apply non - linear method to accurate them

    提出了基於匹配點調整的f求精方法，先根據攝影交比不見性對手工選擇的匹配點進行調整，再用線性、非線性結合的方法求精f矩陣；在計算內部參數a中，進行了一定的簡化，把重心放在a中重要的兩個參數上，用svd分解法計算kruppa方程；在計算外部參數時，首先用線性法求解r 、 t ，然後再用非線性法迭代求精。
  2. Dynamic weighted fit method in step calibration for ultra - broadband and very - broadband seismometer

    超寬與甚寬頻帶地震計階躍標定的加權動態擬合法
  3. The laboratory offers calibration service for watchesstop watches with internal crystal and step motor. the calibration of watchesstop watches includes the measurement of its relative frequency accuracy

    計時表本所為石英及機械表提供校正服務，包括測量計時表內部頻率的準確度。
  4. Analysis of the transition time of step - function signals in the dynamic calibration of systems

    系統動態校準中輸入階躍信號過渡時間參數分析
  5. 100kn pneumatic impulse negative step force calibration system

    氣動助推式負階躍力校準裝置
  6. 7. based on our crsi and algorithm and double lcslm, an adaptive optical hardware system which c & n be used to model arbitrary complicated wavefront and the compensation of the wavefront can be accomplished was built. and according to the characteristic of a crs interferogram of a step wavefront produced by an lctv, the pixel - level calibration of this system is implemented

    七、採用已建立的空間相位調制環路徑向剪切干涉儀及其波前重建演算法，和位相調制持性已知的兩塊液晶空間光調制器，創建了一套用於模擬產生任意畸變波前並加以檢測和反饋控制的自適應光學硬體系統，並通過臺階波前對該系統實現了像素級校準。
  7. The laboratory offers calibration service for coaxial fixed and step attenuators. the frequency range covers 300 khz to 18 ghz and attenuation range of 0 to 70 db

    本所可為同軸的固定及階調衰減器提供校正服務。頻段由300khz至18ghz ；衰減幅度由0至70db 。
  8. For the key step of the proposed method, the camera calibration adopts the nonlinear, multi - step and optimized process, which does not need to know the relative positions between different target images and can satisfy simple and feasible calibration demands on the outdoor road

    對其中的關鍵環節車載攝像機的標定採用了非線性分步優化的過程，該過程不需要知道不同取向的靶標圖像的變動情況，能適應室外道路簡便、快速的標定要求。
  9. At first, the algorithms for " nose - to - nose " calibration technology acquiring the parameters are introduced, including the algorithms for acquiring the impulse response, the step response, the rise time, the amplitude response and the phase response

    首先，介紹了「 nose - to - nose 」校準技術獲取示波器沖激響應、階躍響應、過渡時間、幅頻特性和相頻特性的各種演算法。
  10. In the first chapter, we introduce linear camera model and some general knowledge and several traditional methods of camera calibration, such as direct linear transformation and two - step method etc. in the second chapter, we talk about the method for camera self - calibration through translation movement of the camera

    全文分為以下四章（其中第二、三和四章是本人的工作） ：第一章介紹了線性攝像機模型以及攝像機定標的一般性知識和幾種常見的傳統定標方法，比如直接線性變換方法和兩步法等。
  11. Camera calibration, depth maps recovering and constructing representation scheme are important issues in ibr, on which our research is concentrating. camera calibration is the preliminary step towards deriving metric information from the images

    相機定標、圖像深度信息提取和建立圖像模型是圖像繪制技術的重要研究內容，本文著重對這些問題開展研究。
  12. Step - by - step self - calibration algorithm of digital camera based on kruppa equations

    方程的相機分步自標定方法
  13. The theoretical basis and the solving procedure of the proposed calibration technique were presented, and the comparative experiments among the new method, linear calibration method and the two - step method were performed

    給出了標定方法的理論依據和求解過程，並將其與線性標定方法和兩步法進行了對比實驗。
  14. The main sources of uncertainty come from non - linear calibration models and pre - processing step of samples

    測量誤差的主要來源是樣品校正曲線擬合誤差、樣品測定重復性標準偏差。
  15. A linear three - step approach for camera calibration

    攝像機線性三步定標方法研究
分享友人
分享到 Line

分享到臉書