stopband 中文意思是什麼
stopband
解釋
不透明帶-
Thirdly, two kinds of the methods to improve the performance of filter stopband has been discussed. these methods are used to cleared up the influence of the parasitical passband. through the simulation and test result shows that these methods " s performance is expected
第三，論了2種對濾波器阻帶抑制進行改善的方法，以消除寄生通帶的影響，通過模擬和實際製作濾波器的測試結果。 -
There is always a smooth transition between passband and stopband
通頻帶和抑止頻帶之間總是存在一個「平滑切換點」 。 -
The main work of the system can be divided into four main parts as the following : ( 1 ) 10. 5ghz bandpass filter the main contradiction of filter is caused by its function of dividing frequencies. in order to properly divide frequencies, not only need passband ’ s attenuation to be as small as possible and stopbands ’ as big as possible, but also need a sharp and quick change between the attenuation of passband and stopband, thus to make their diversity obvious
這四個功能模塊分別是: （一） 10 . 5ghz帶通濾波器濾波器的主要矛盾是由它分隔頻率的功能決定的，為了使分隔理想，一方面要求通帶的衰減盡可能小，阻帶衰減盡可能大，亦即通帶和阻帶的衰減差值要盡量大;另一方面要求通帶和阻帶之間衰減的變化應盡可能快，最好是陡峭的跳變，使阻帶和通帶的分隔十分明顯。 -
This method can not only minimize the stopband energy of the prototype filter, but also determines the inter symbol interference power and the transition band energy, which can be used to design prototype filters for both the critically sampled fmt system and the non - critically sampled fmt system
該方法不僅可以最小化原型濾波器的阻帶能量，還界定了符號干擾功率、過渡帶能量，適用於嚴格采樣和非嚴格采樣濾波多音調制系統。 -
The specification is that the cutoff frequency must be more than 15mhz, the maximum passband ripple must be 0. 2db and the minimum stopband attenuation must be 40db
該濾波器要求截止頻率大於15mhz ，通帶最大紋波為0 . 2db ，阻帶最小衰減為40db 。 -
The research productions of this thesis have much reference value on the filter miniaturization, improve the performance of filter stopband and improve the efficiency of the filter design
該課題的研究成果對于濾波器的微型化，濾波器阻帶抑制的改善，以及提高設計效率等方面都有較大參考價值。
分享友人