structural form 中文意思是什麼

structural form 解釋
構成形式
  • structural : adj. 構造上的，結構上的，組織上的。adv. -ly
  • form : n 1 形態；形狀；樣子，外貌；【哲學】形式 （opp content）。2 人影，物影。3 格式；表格紙 （＝ 〈美...
  1. There are intensive structural and magmatic hydrothermal movement with obvious zonal surface shape alterations, which are demonstrated by silicified function, sericitization, potassium, epidotization, hornstone, etc. the ore structural fabric mainly behaves in form of filling action with minerals such as pyrite, chalcopyrite, salenite, blende and electrum, which typomorphic feature shows a hypothermal pattern of metallogeny

    呈面型蝕變，分帶特徵明顯。礦區內礦體規模巨大，礦石組構主要為以充填交代作用為主，礦石礦物主要為黃鐵礦、黃銅礦、閃鋅礦、方鉛礦和銀金礦。而且礦物的標型特徵顯示了低溫成礦的特點。
  2. At last, compartmentalization settlement index value according to structural form and design running speed respectively

    並分別按照施工結構形式和計算行車速度重新劃分工后沉降標準值。
  3. The method is described as follows : the velocity of the moving part and the gas chamber pressure were measured with a dynamic test measurement system ; a dynamic model was built on force analysis of the moving part ; the total kinetic resistance replaced the horizontal friction and water resistance ; then the resistance - velocity relation curves at moving stages were obtained ; with the empirical formula of the gas chamber pressure and the resistance - velocity relation curves, the preliminary dynamic characteristics were analyzed and the structural form and key parameters of an underwater assault rifle were determined

    具體方法為：由動力學測量系統測得活動件速度和氣室壓力；分析活動件的受力，建立動力學模型；以運動總阻力代替水平方向上的摩擦阻力和水阻力，獲得各運動階段的阻力速度關系曲線；利用氣室壓力經驗公式和阻力速度關系曲線，對水下突擊步槍進行初步的動力學分析，確定其構造型式及主要參數。
  4. Modify above model along with altering structural form or the constitution of the bridge, such as different standard, steel ratio, steel pipe diameter, concrete module, brace allocation, the length of concrete of the main ribs, suspending pole mode and cable local vibrations, calculate the variety of dynamic character, analyze this factors which will affect. 2

    對斜拉拱橋自振特性進行參數分析，分別考慮了不同規范、含鋼率、拱肋鋼管直徑、混凝土彈性模量、橫撐布置、拱肋段混凝土長度、吊桿形式對自振特性的影響，最後考慮了斜拉索局部振動對自振特性的影響。
  5. Its structural form was rib arch with simple hole and frame supporting

    結構型式為單孔肋拱、排架支承渡槽。
  6. 5 the structural form of the single lane psb shall be pin - connected panels

    單車道鋼架橋的機構形式為拼裝式。
  7. Influence of the structural form of sound absorbing material on the behavior of sound absorption

    吸聲材料構造形式對吸聲效果的影響
  8. Concrete filled steel tube ( cfst ) arch bridge is a new type of bridge which is widely applied in china recently, and it is a relatively ideal structural form for long span arch bridge. with the background of the practice of liantuo bridge, in the view of point of feasible in technology and reasonable in economy, the key techniques and difficulties in the construction of cfst arch bridge are analyzed and discussed in the thesis. the disadvantages in the current design and construction and the improvement method are also indicated

    本文以蓮沱特大橋工程實踐為背景，以主拱施工研究為主線，對鋼管混凝土拱橋重難點施工工藝，從技術上可行、經濟上合理的角度出發，詳細的進行了分析闡述，並指出了設計施工中存在的不足和今後需改進的方向；通過對鋼管混凝土拱橋施工過程中內力的計算，確定了拱肋施工最不利荷載工況下加載重量、壓重順序和張拉臨時預應力束等一系列施工措施，並將計算結果與現場監測觀測數據進行了比較分析，為今後進一步研究這類結構提供了參考。
  9. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  10. To carry out structural scheme design report ( ssdr ) for all new projects with the issue of studying the use of alternative material, improved construction method or structural form

    為所有新工程項目擬定結構設計方案報告，包括研究使用替代材料，改善建造方法或結構模式。
  11. 3. as to the vibration analysis of ground under lightway train load, it is different to railway and subway since its structural form generally is viaduct, whose load is time depending and located in some stationary position

    3 、對輕軌列車荷載作用下的地基土的振動分析，考慮到輕軌的結構形式一般為高架橋，與普通鐵路和地鐵不同。
  12. Space grid structures consist of latticed frame and reticulated shell, latticed frame and reticulated shell have many structural form, those forms will be developed and innovated continuously

    空間網格結構包括網架和網殼。網架和網殼結構的種類較多，且不斷發展創新。
  13. The structural form, inner pore distribution, and burning behavior of pulverized coal with different particle size have been tested

    摘要對不同粒度煤粉的結構形態、內孔分佈和燃燒特性進行了試驗。
  14. With the development of the economy, the structural form and function of residence put forward the new request for load and resistance. adjusting equilibrium level of reliability between economy and security has become a problem to resolve urgently

    隨著經濟水平的提高，住宅結構的形式和功能對結構荷載和抗力的分析提出了新的要求，同時使安全與經濟平衡的可靠度水平調整成為了一個急需解決的問題。
  15. Because of cold formed thin - walled light steel structure ' s special construction, if draws the mechanics model according to the rigid connection frame, that will be over - evaluated the bearing capacity of the structure ; and if draws mechanics model according to the pinned connection frame, when the foot also adopts this kind of structural form according to the frame connections, that will form organization, and the calculation will be unable to go on

    由於冷彎薄壁輕鋼龍骨結構體系的特殊構造，如果按節點剛接的框架提取力學模型，將高估結構的承載能力；而如果按節點鉸接的排架提取力學模型，當柱腳也採用此種構造形式時，又會形成機構，使計算無法進行。
  16. Research on structural form for bionics architecture of scallop form

    海洋貝類仿生建築的結構形體研究
  17. Through the structural form transformation of the system of our ownership, see the reform of state enterprise property

    由我國所有制結構形式的變化看國有企業的產權變革
  18. The characteristics and requitements of the seal of vessel stem tube shaft is introduced and structural form and actual effect of packing seal of vessel stem tube shaft is analyzed, based on comparison, test and screening of seal packing materials, two braiding forms of synthetic fiber compounded packing arc adopted and are tested in real vessels, and good sealing effect is obtained

    摘要介紹了艦船艉軸密封的特點和要求，分析了艦船艉軸填料密封的結構形式和實效，在比較、試驗和篩選密封填料材料的基礎上，採用了兩種編織形式的合成纖維復合填料，並通過實船試驗，取得了良好的密封效果。
  19. This paper uses the three meta - functions in systemic functional grammar to analyze some verses of two famous ancient chinese poems, in order to disclose some unique features of chinese poems in the realization from structural form to semantic expression

    摘要本文通過用系統功能語法的三大功能理論對兩首著名古詩詞中若干詩句的分析，揭示了古漢語詩詞的語法形式在體現語義表達上的某些獨到的特徵。
  20. Under the same working pressure and flow rate, the flow passage length and cross - section area of the seven different emitters were compared. according to those results, the anti - clogging ability of emitters was analyzed and several good structural form of flow passage were obtained. in addition, regression model describing the relationship among flow rate, the length of flow passage and work pressure was set up

    比較了不同結構形式滴頭的流態指數和相同工作壓力和流量下的流道長度與流道截面積，分析了其抗堵塞性能，得出了較佳的幾種流道結構，並建立了描述滴頭流量與工作壓力及流道長度之間關系的函數模型。
分享友人
分享到 Line

分享到臉書