suction unit 中文意思是什麼

suction unit 解釋
吸揚設備
  • suction : n. 1. 吸，吸引，吸入；吸力。2. 吸氣，吸氣通風；【物理學】空吸。3. 〈英國〉喝酒。4. 吸水管。
  • unit : n 1 個體，一個，一人。2 （計值、組織、機構）單位；單元；小組，分部；【軍事】部隊；分隊。3 【機械...
  1. Auto fatness measuring system, fat measure, hearing aid. gas pressure gauge of measure, digital woman thermometer, electronic infrared high - power massager, eye massager, suction unit, refractor, film box. diagnostic set, head mirror. magnetic acupuncture suction cup

    全自動身高體重計、體脂肪測定器、助聽器、氧氣流量表、電子體溫計、電子婦女基礎體溫計、紅外線電動按摩器、眼部按摩器、吸引機、視力檢查器、看片箱、喉頭鏡、檢耳鏡、額頭反射鏡、哈慈五行針
  2. Seal off internal suction damper hole with adhesive on the asr esp hydraulic unit

    密封asr esp液壓單元內置減震器安裝孔
  3. Air suction mode spinning unit has wide application, strong impurities discharge and good quality of yarn, easy maintainance

    1抽氣式氣流紡紗機，敞開式紡紗器設計，具有排雜效果好，成紗質量優良的特點，便於維護保養。
  4. Electric abortion suction unit

    電動流產吸引器
  5. Abortion suction unit

    流產吸引器
  6. As an inlet structure, the forbay is an important part of the pumping station. the pressurized forbay, close in top structure, is a kind of particular forbay in which water is pressurized. based on the integral hydraulic model test of shanghai changqiao waterwork ' s water - transport pumping station, some research on the hydraulic characteristics of the pressurized forbay has been done in the paper. the main content is listed as follows : l. the hydraulic characteristics of the pressurized forbay in different water supply combination and different pump unit combination without divertion measure, and the reason of the poor flow state. 2. the hydraulic characteristics of the pressurized forbay with diversion pier, and the reason why the flow state can be improved. 3. the experimental research on the critical air suction condition of the pressurized forbay

    本文基於上海長橋自來水廠改造工程送水泵站整體水力模型試驗，對有壓前池的水力特性進行了研究，研究的主要內容如下： 1 、無導流措施的有壓前池在不同供水組合及不同機組開機組合條件下的水力特性，並分析了流態較差的原因； 2 、加設導流墩後有壓前池的水力特性，以及加設導流墩流態改善的原因; 3 、有壓前池進氣臨界條件的試驗研究； 4 、水泵進氣以後水泵性能的討論。
  7. Studies on the stripping unit with air suction

    氣吸式割前摘脫裝置的研究
  8. The base shall be of adequate height to provide suitable clearance between the pump suction elbow and the mounting floor and of sufficient strength to accept all forces imposed by the pump unit

    這個基座應該具有適當的高度，使得泵吸入彎頭與安裝地面具有適當的間隙，並有足夠的強度承受泵設備所產生的所有壓力。
  9. Development of a portable suction unit for first - aid use

    微型急救吸引器的研製
  10. Continuous suction unit

    連續吸引器
分享友人
分享到 Line

分享到臉書