supply temperature 中文意思是什麼

supply temperature 解釋
供給溫度
  • supply : vt （ plied） 供給；供應；配給；補充，填補，彌補（不足、損失等）。 Cows supply us （with） milk ...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. As a mix - mode chip, the application - specific controller including analog signal and digital signal processing block can be applied to receiving, amplifying, processing, controlling signals of pir, and offer a wide application in some fields. in analog circuits, by sub - threshold mosfet, a self - bias current source is presented, which has a high power supply restrain ratio and a complementary to absolute temperature characters

    這款晶元是一款數模混合晶元，包括模擬信號處理（含模數介面模塊）和數字信號處理兩大模塊，完整實現對紅外信號的接收、放大、處理、控制，產生有效數字電平驅動繼電器、可控硅等負載，應用於自動燈等多種場合。
  2. With many years experience in this field, we can help customer empolder or supply nontoxic, non - yellowing, hydrolysis resistance and high temperature resistance top grade colorant or especially machining product etc

    基於行業內多年的經驗和技術實力，公司可以根據客戶的要求協助其開發或提供環保型、不黃變、耐水解、耐高溫等各類高檔色漿和特殊加工產品。
  3. In this paper, using phoenics software to compute and analyze the variety rule of the convecting transfer heat at the basis of computing and analyzing the temperature and velocity field of one underfloor supply air room with a focus hot source, and concluding that the number of the hot source and the supply air outlet > the intensity of the hot source and the volume of supply air will influence convecting transfer heat, and obtained its correlativity formula

    本文針對一下部有集中熱源的地板送風空調小室，利用phoenics軟體，在計算分析小室內氣流的速度場及溫度場的基礎上，對對流熱轉移量的變化規律做了計算分析，最後得出對于下送風小室的對流熱轉移量與熱源的個數、送風口個數、熱源強度、送風量等因素有關，並且得出了其相關關系式。
  4. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  5. A high-temperature cut-out isolates power supply to the heater.

    高溫斷流器切斷給通往熱器的電源。
  6. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下，當裝置穩態功率變化時，冷卻劑平均溫度與蒸汽壓都保持不變，與通常採用的冷卻劑平均溫度恆定運行方案相比，有效地改善了核動力裝置的總體運行性能，特別是在低負荷運行時，可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件，這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  7. Combined with temperature sensing head, paper cutter, controlling board, power supply, paper holder frame, machine frame together, which being convenient for installing in various machine cabinets

    集熱敏頭、切紙刀、控制板、電源、托紙架、機架於一體，方便安裝到各種機櫃內。
  8. Modbus transducer is the key device in the system and is used to offer power supply of pressure and temperature sensor, to collect signal, to linearizate and compensate temperature, to calculate density, volume and mass, to transmit data to modbus network, and display the data. so the modbus transducer is a multi - parament measurement, intelligent control device which can manage multi - signal

    變送器是系統的核心設備，其作用是為油罐溫度、壓力、液位、可燃氣濃度等傳感器供電，採集傳感器信號並進行線性化、溫度補償等處理，完成密度、體積和質量等參數計算，將數據輸出到modbus現場總線測控網路，根據需要現場顯示計測量參數。
  9. The reheat coil adjusts supply air temperature to offset building heat losses due to transmission.

    再熱盤管調節送風溫度，以補償因傳熱造成的建築熱損失。
  10. Three parameters, the fractional temperature coefficient, the sensitivity of transconductance to voltage supply and improvement factor, are introduced

    在分析中，本論文引入並使用了跨導的相對溫度系數、跨導對電源電壓的敏感度、跨導穩定性改善因子三項指標。
  11. Summarize : multi - input, can be used cooperate with various sensors / transducers, measure 、 display and alarm control the physical quantities such as temperature 、 humidity 、 liquid level and flux # 118alues and transform them to export, can read and write all parameters via the computer through serial communication, besides it can offer 24vdc power supply for 2 - wire transducers, four - bit led displaying, the multi - segment curve correcting function is selectable, one meter can equip four alarm relay outputs 、 one transform ( or communication ) output and one equipped power supply outputs

    萬能輸入，可與各類傳感器、變送器配合使用，實現溫度、濕度、壓力、液位、流量等物理量的測量、顯示、報警控制和變送輸出；通過串列通信口，可在上位計算機中實現全部儀表參數的讀寫；還可為兩線制變送器提供24vdc電源； 4位高亮度led數字顯示；對輸入信號有多段折線修正功能可選；一臺儀表最多可配4個報警繼電器輸出、一路變送（或通信）輸出和一路配電輸出。
  12. In order to supervise the quality of coal and control heat supply of cement manufacture, more and more cement factories apply invariable temperature calorimeter to measure calorific value of coal to stabilize production of cement and decrease consumption of energy

    為了對進廠煤質進行監控並指導水泥生產配熱，達到穩定水泥產品質量，降低能源消耗的目的，越來越多的水泥企業開始應用恆溫式氧彈儀測定煤炭的發熱量。
  13. Ahu coil design shall be based on 6. 7 degrees centigrade chilled water supply temperature

    空氣調節裝置卷設計應該在6 . 7攝氏度冷卻水供應溫度的基礎上。
  14. Thirdly, radiator performance test - bed thermal system control modeling and rule self - organizing fuzzy control simulation were studied. the water supply temperature, radiator inlet temperature, test room temperature based on water temperature regulation, air supply average temperature and test room temperature based on air temperature regulation total five controlled processes transfer function were set. finally, rule self - organizing fuzzy control simulation for two

    通過試驗，辨識了散熱器實驗臺熱工系統中供水溫度、散熱器進水溫度、基於熱水系統調節的測試室溫度、送風平均溫度及基於送風系統調節的測試室溫度共5個被控過程的傳遞函數，並對基於熱水系統調節和基於送風系統調節的測試室溫度響應過程進行了規則自組織模糊控制模擬。
  15. Water supply temperature, indoor design temperature, distance of embedded pipe, diameter of embedded pipe and material of ground floor are important factors influencing cooling and heating radiation floor system

    摘要影響冷暖輻射地板系統的幾個重要因素有供水溫度、室內設計溫度、埋管管距、埋管管徑和地面層材料。
  16. Control principle : for the high inertia for changing of the supply temperature and for the auto - controlled behaviour within certain limits, a usual control strategy does not make sense

    控制原理：對輸送溫度的較大慣性和一定范圍內的自我調控特性，通常的控制方法滿足不了這種要求。
  17. The experimental results showed that : in the summer operating mode, the refrigerating capacity and coefficient of performance of the system decreased with the increase of the temperature difference between supply and return ground - water and the water supply temperature ; in the winter operating mode, the refrigerating capacity and coefficient of performance of the system increased with the decrease of the temperature difference between supply and return ground - water and the increase of the water supply temperature. it also showed that, change the are of heat exchanger has great influence of refrigeration system

    本課題通過實驗測試井水進口溫度、進出口溫差以及在不同溫差下換熱器面積匹配對系統性能的影響。實驗結果表明，夏季工況下，隨著井水進口溫度的升高，進出口溫差的增大，系統製冷量減小，機組cop降低，系統運行性能惡化。冬季工況下，隨著井水進口溫度的升高，進出口溫差的減小，系統的制熱量增加，機組cop提高，系統運行性能優化。
  18. In this paper, it emphasized on the influence of the supply temperature of the ground - water, the temperature difference between supply and return ground - water, the flow - rate of the well on the system, the difference area of heat exchangers

    為了解決上述問題，我們建立了地下水源熱泵系統實驗臺，採用實驗和模擬相結合的方法，對系統的性能特性進行研究分析。
  19. Energy consumption of the building is monitored by the annual effective energy audit, and saving has been achieved with the introduction of various energy saving measures such as trimming fresh air supply for the air - conditioning system and raising chilled water supply temperature to 8 or 9 degree c during cooler seasons, etc

    港大每年為大樓進行能源效益評核，所採取的節能措施效益顯著，包括減少鮮風的供應量及在寒冷季節提高冷水供應的溫度至攝氏8度或9度等。
  20. For this reason, we propose a control of the supply temperature by the average temperature of the last 24 hours

    因此，我們建議，用頭一天24小時的平均溫度作為控制溫度。
分享友人
分享到 Line

分享到臉書