swelling ratio 中文意思是什麼

swelling ratio 解釋
泡脹率
  • swelling : n. 腫脹;增大;腫瘤;隆起,膨脹;隆起部。
  • ratio : n. (pl. ratios)1. 比,比率,比值;比例;系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達;求出…的比值;使…成比例。2. 將(相片)按比例放大或縮小。
  1. Unbound and hydraulically bound mixtures - test method for the determination of california bearing ratio, immediate bearing index and linear swelling

    鬆散的和液力粘合的混合料.測定加利福尼亞承載率瞬時承載指數和線性膨脹的試驗方法
  2. In this article, the micromorphological structure of pva - copper gradient composite film ( mpgcf ) obtained from the electrochemical reduction of a swelling cathode films ( scfs ) was studied by the scaning electronic microscope and the relationship between the micromorphological structure of the composite film and the electrochemical conditions such as the weight ratio of pva to cuc12, the material of the electrode, the concentration of the medium solution, the dring time of scf, the power voltage, the time of the electochemical reaction etc, investigated

    本文採用「溶液還原法」制備了一種新型的聚合物基金屬梯度復合材料( mpgcf ) ? pva /銅梯度復合膜。通過掃描電子顯微鏡觀察了梯度復合膜的形態結構並研究了其形態結構與電化學條件之間的關系。然後在此基礎上,探討了梯度復合膜的形態結構與力學性能之間的關系。
  3. Swelling ratio of clays

    粘土膨脹倍數
  4. When mechanical doping 5 % co, the discharge specific capacity is 225mah / g, the ratio of active material utilization is 78 %. the addition of zn can prevent the swelling of nickel electrode and prolong the cyclic life, decrease the existence of y - niooh when over - charged

    隨著co摻雜量的增加,鎳電極的放電比容量明顯提高,機械混合摻雜5 co時鎳電極的放電比容量為225mah g ,活性物質的利用率達到78 ,循環性能比較穩定。
  5. Conventional building - mortar is usually blent into in the construction local, which possesses many defects such as low accuracy of mixture ratio, poor stability of quality, contractility of bigness, broad fluctuation of felted strength, anti - penetrability of feebleness, collapse of easiness and ect, and it is vital reason, resulting in lots of engineering quality accidents as following : crack in the wall, swelling, penetration, and collapse. mortar made in the local is at the cost of wasting materials and contaminating environment

    傳統的建築砂漿都是在施工現場拌制,現場拌制的砂漿各組分計量準確度低、質量穩定性差、收縮性大、粘結強度波動大、抗滲性差、易剝落,是建築工程墻面開裂、起殼、滲漏、甚至墻體倒塌等質量事故發生的主要原因;現場拌制砂漿還會造成材料浪費和污染施工環境。
  6. Because of their excellent characteristics, superabsorbents are widely used in health, agriculture and horticulture applications. based on the influencing factors, such as type of structural layer, interlayer charge, interlayer distance, cation exchange capability, surface area and ratio of swelling, kaolinite, sercite and bentonite are choosed as the mineral fillers to synthesize the superabsorbent composite

    本文從粘土的結構層型、層電荷、層間距、陽離子交換容量、比表面積和膨脹率等各方面綜合比較研究粘土礦物的性質,選擇了高嶺土、膨潤土和絹雲母這三種粘土礦物作為無機填料,制備粘土?有機聚合物超吸水性復合材料。
  7. The conclusion of swelling experiment is that elastomer swelling of compound alcohol fuels is stronger than that of gasoline and elastomer swelling is more stronger when more bigger blend ratio

    溶脹作用實驗結果表明,甲醇與汽油的混合燃料對橡膠件的溶脹作用比純汽油的強,並且隨著摻燒甲醇比例的增大,甲醇汽油混合燃料對橡膠件的溶脹作用是逐漸增大的。
  8. During the swelling capacity test of the reinforced soils under load, three different reinforcement ratio samples are tested in order to reduce their expansion of the soils

    在加筋土有荷載膨脹量試驗中,取三種不同加筋率的試樣進行試驗求其膨脹率。
  9. Unbound and hydraulically bound mixtures - part 47 : test method for the determination of california bearing ratio, immediate bearing index and linear swelling ; german version en 13286 - 47 : 2004

    鬆散的和液力粘合的混合料.第47部分:測定加利福尼亞
  10. Unbound and hydraulically bound mixtures - part 47 : test method for the determination of california bearing ratio, immediate bearing index and linear swelling

    鬆散的和液力粘合的混合料.第47部分:測定加利福尼亞承載率瞬時承載指數和線性膨脹的試驗方法
  11. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜( scf )中的溶劑與電解液中的溶劑相同都是水,克服了以前膜內外不同溶劑之間擴散的問題,結果使得電流最終趨於一種穩態,因此可以更好實現用電化學條件來控制mpgcf的形態結構;硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜( scf )與電極表面的結合以及膜的剝離,因此是作為陰極的理想材料;電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移,從而對mpgcf的形態結構造成較大的影響;而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
分享友人