switch blade 中文意思是什麼

switch blade 解釋
電門閘刀
  • switch : n 1 (樹上折下的)細樹枝;軟鞭子;鞭打。2 假發;(尾巴上的)毛簇。3 〈美國〉【鐵道】道岔扳子,軌...
  • blade : n 1 (殼、草等的)葉片,葉身,葉。2 刀片;(安全)剃刀刀片 (= razor blade); 刀口,刃;刀,劍;...
  1. Down chiang minus shan wheel switch position exorbitance, go back to floor behind has not on down blade hand in will inner

    下強減單輪開關位置過高,歸樓后未在上下刀片交會內
  2. Lower pole limit yi switch position exorbitance, lower pole limit yi switch position has got to under photoelectric blade above down hand in will place

    下極限之開關位置過高,下極限之開關位置必須低於光電刀片之上下交會處。
  3. Openarchitect ha, a layered application for dual switch chassis, provides a high - speed, fault - tolerant, end - to - end " ip transparent " failover solution for " hot - swappable " ethernet - based payload blades on a switch - to - switch, vlan - to - vlan, or port - to - port basis. the zx5000 gigabit ethernet base interface enables significant capacity for control plane throughput, and when configured for full redundancy, traffic can switch to a backup blade, enabling high availability of platform service

    Openarchitect ha ,一個支持雙交換系統的分層管理軟體,為"可熱插拔"的基於以太網協議的單板計算機在交換到交換或vlan到vlan或端到端基礎上提供了一個高速容錯點到點的"與ip無關的"錯誤切換解決方案。
  4. Simple points for underground tracks with spring switch blade ; 30 m radius, 1 : 6 inclination, 600 mm gauge ; compilation

    半徑為30米斜度1 : 6軌距600毫米的帶彈性開
  5. Simple points for underground tracks with spring switch blade ; 50 m radius, 1 : 7 inclination, 600 mm gauge ; compilation

    半徑為50米斜度1 : 7軌距600毫米的帶彈性開
  6. Simple points for underground tracks with spring switch blade ; 20 m radius, 1 : 5 inclination, 600 mm gauge ; compilation

    半徑為20米斜度1 : 5軌距600毫米的帶彈性開
  7. Down chiang minus shan wheel switch position kuo low, go back to floor behind has not on down blade hand in will inner

    下強減單輪開關位置過低,歸樓后未在上下刀片交會內。
  8. Ceiling margin yi switch position kuo low, ceiling margin yi switch position has got to higher than photoelectric blade above down hand in will place

    上極限之開關位置過低,上極限之開關位置必須高於光電刀片之上下交會處。
  9. Photoelectric blade position has by mistake or photoelectric switch breakdown

    光電刀片位置有誤或光電開關故障。
分享友人