tensile resistance 中文意思是什麼

tensile resistance 解釋
抗拉力
  • tensile : adj 張力[拉力]的；抗張的；能伸長的。 tensile force 【物理學】張力。 tensile strain 【物理學】張應...
  • resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
  1. The results showed that the addition of boracic acid can increase the oxidation resistance and tensile strength of the flexible graphite, however, it has few effect on the other properties of the flexible graphite

    實驗表明，添加劑硼酸使柔性石墨材料在抗氧化性方面具有明顯的優越性，抗拉強度有所增加，而對其它性能的影響不大。
  2. The boracic acid was used to prepare flexible graphite and the effect of amount of boracic acid addition on expanded volume, oxidation resistance, specific resistance and tensile strength of the fexible graphite obtained were analysed

    摘要初步探討了製造柔性石墨材料過程中加入添加劑硼酸的方法，並就硼酸的加入量對其膨脹倍數、抗氧化性、電阻率、抗拉強度等的影響進行了比較和分析。
  3. It canbe determined the enhancing effect of new steel fiber to shear resistance of beams by the test of tensile strength of steel fiber reinforced concrete, it is important to reduce test cose and increase research efficiency

    可以通過鋼纖維混凝土抗拉強度試驗來確定新品種鋼纖維對梁斜截面上混凝土受剪承載力的增強作用，這對于降低試驗成本和提高研究效率具有重要工程價值。
  4. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  5. Hypereutectic al - si alloys are known to be suitable for wear - resistance material because of its low density, high tensile properties and low coefficient of thermal expansion

    高硅鋁合金的耐磨性好，強度高，密度低，熱膨脹系數小。
  6. The resistance of the nonwoven to tensile rupture is the sum of two resistances in parallel.

    非紡織物對拉伸斷裂的阻力是兩個並聯阻力之和。
  7. It has minimun outgassing, good abrasion resistance and high tensile and dimensional strength

    釋放很少量氣體，耐磨性，不易折斷及不易拉扯。
  8. Abstract : by means of metallographical examination and sem, the microstructure characteristics, macro - and microfractographs of the brittle broken wheel hull bolt of bj212 automobile have been studied. the results show that the thin - headed screw, with excessively deep carbonitriding layer and hardening layer, has less resistance to brittle fracture in the thin area of its head. at the root of the head connecting the stem, a tensile stress may emerge owing to the non - even quenching stress. those are the two reasons for low torque fracture of bolt

    文摘:藉助金相、掃描電鏡等手段對低扭矩脆斷的bj212汽車輪殼螺栓的金相組織特徵，宏觀和微觀斷口形貌等進行了研究，結果表明：這種頭部薄的螺栓，滲層和淬透層過深，使頭部薄區脆斷抗力降低，在頭部與桿的根部，由於淬火應力不均勻導致根部產生拉應力，均是導致螺栓低扭矩斷裂的原因。
  9. Products function : put our “ sun shine ” brand carbon steel fiber evenly seep into concrete to form steel fiber reinforced concrete and it can decrease the thickness of reinforced concrete by half, it not only shorten the project time, save the material and manpower expense, bring distinct economic benefit, but also increase the performance of crack resistance, percussion resistance, tensile strength, bend resistance. scosspr resostamce amd wear resistance of the reinforced base materials. if the weight ratio of 2 % steel fiber seep into the concrete, it can solve the brittleness problem of the concrete, in the condition of 60 % ralative air humidity, after 21days air - dry, even 520 days air - dry, it ' s difficult to find any crack by eyesight, the bend resistance for the steel fiber concrete is 140 times stronger than the concrete without steel fiber, the capability of impact resistance increase 10 times

    產品功能：將本公司「雙興」牌碳鋼纖維系列產品均勻地摻入混凝土中，形成鋼纖維增強混凝土，可使工程中鋼筋混凝土的施工厚度降低一半，不僅縮短了施工工期，節省了材料和人工費用，帶來顯著的經濟效益，且增強了基體的抗裂、抗沖擊、抗彎、抗剪、耐磨擦等性能，如摻入本公司2 %鋼纖維的混凝土，不僅解決了混凝土的脆性問題，在空氣相對濕度60 %的條件下風干21天後，甚至在風干520天，肉眼很難發現裂縫，摻入鋼纖維后的增強混凝土比不摻鋼纖維的混凝土抗彎強度提高140倍，耐沖擊荷載提高10倍。
  10. Testing methods for chemical resistance of plastics under constant tensile deformation

    在恆定拉伸變形下塑料耐化學作用的試驗方法
  11. Cu - zn - cr - zr conducting bar alloy and cu - cr - zr end ring alloys used for superpower asynchronous traction motor rotor were prepared by ingot metallurgy. using hardness measurement, tensile test at room and higher temperature, electrical resistance test at room and higher temperature, optical microscopy, xrd, sem, and tem, the mechanical and electric properties and the microstructure of above alloys at different treatment were studied. them were also analysed and explained in theory

    採用鑄錠冶金法制備了大功率異步牽引電動機轉子用導條合金和端環合金，通過硬度測試、室溫拉伸、高溫拉伸、電導率測定、金相分析、 xrd 、 sem 、 tem等方法研究了不同加工工藝和熱處理工藝對上述合金力學性能、導電性能及其組織結構的影響和變化規律，並從理論上進行了分析和解釋。
  12. Special new outer plate construction with strong impact resistance force, high rigidity and high tensile strength design of tank chain, providing better outer plates performance than traditional ones

    全新特殊結構外鏈片設計、具有強化抗沖力、高鋼性、高拉力多元性能設計坦克鏈、並具有高於傳統外鏈片性能、特性。
  13. The membrane layer is formed by the vacuum forming technology. by controlling the weight and the ratio of long path of ceramics fiber, changing the operation factor reasonably of vacuum forming, we can obtain the ceramic fiber composite membrane layer, which has pore diameters of about 5 to about 30um, porosity i s 50 - 80 %, and tensile strength is about 4. 1to 18. 1mpa and thickness of membrane layer is 0. 5 - 2 mm, has the good thermal shock resistance and peal off

    膜層採用真空抽濾成型工藝，通過控制膜組分中陶瓷纖維長徑比、纖維加入量、成型時料漿濃度、成型壓力及成型時間等可以獲得膜孔徑5 ? 30 m 、氣孔率50 ? 80 、抗折強度4 . 3 ? 18mpa 、膜層厚度0 . 5 ? 2mm 、具有良好熱性能和耐剝離性能的陶瓷纖維復合微濾膜材料。
  14. Standard methods of static load test for combined tensile and transverse load resistance of paneled wall systems in building construction

    房屋構造中隔墻系統耐拉伸與橫向結合荷載用靜荷載試驗的標準方法
  15. Tensile strength and elongation, weight, elasticity, resistance to flammability and high heat levels, moisture - transport capabilities, durability, and weatherability are some examples of attributes that could be included in a technical textile performance specification

    拉伸強度、抗張伸展率、重量、彈性、耐燃性、耐高熱水平、水分輸送能力、耐久性和耐候性都包括在技術紡織的性能規范中。
  16. Polypropylene fiber reinforced concrete ( ppfrc ), steel fiber reinforced concrete ( sfrc ) and mixed fiber reinforced concrete used in plate of bridge are studied. the performances of concrete with different fiber content, such as compression strength, tension strength, splitting tensile strength, frost resistance, shrinkage, early shrinkage and chloride ion diffusion coefficient ( dcl - ) are studied

    分別研究了改性聚丙烯纖維、鋼纖維和混摻纖維對橋面板用混凝土性能的影響，研究了不同纖維摻量混凝土的抗壓強度、抗折強度、劈裂強度及抗凍性、干縮性能、早期開裂和氯離子擴散系數進行了試驗研究。
  17. Steel strip sheaths for prestressing tendons - test methods - determination of tensile load resistance

    預應力鋼絲索用鋼帶護套.試驗方法.抗拉負荷力的測定
  18. The research works and conclusions of this paper as following : 1. besed on the test results published over the word of reinforced concrete beams without web reinforcements and with stirrups, the systematically statistical analysis is carried out to set up the fomula of shear resistance of reinforced concrete beams using the uniaxial tensile strength of concrete. it provided the basis of strtistical analysis for shear resistance of steel fiber reinforced concrete beams

    根據收集到的國內外對鋼筋混凝土無腹筋梁和鋼筋混凝土有腹筋梁的斜截面承載力試驗研究成果，進行了比較系統的綜合統計分析，提出了採用混凝土軸心抗拉強度研究成果，進行了比較系統的綜合統計分析，提出了採用混凝土軸心抗拉強度指標的鋼筋混凝土梁斜截面承載力計算公式，為鋼筋鋼纖維混凝土梁受剪承載力試驗結果的統計分析提供了基礎。
  19. The bags have good lateral and longitudinal tensile strength, have high temperature resistance, and wont swell even after being boiled

    2香菇袋-具有橫縱向拉力好耐高溫蒸煮不膨脹熱切封
  20. Because short fibers have higher tensile resistance and ordinary concrete has higher compressive strength in the process of loading, every technical property of fiber reinforced concrete is improved greatly. accordingly steel fiber reinforced concrete has better stressing properties such as crack resistance, bending resistance, anti - fatigue, anti - friction and high toughness. so it has brilliant future in highway surface, road surface of aerodrome and architectural construction

    在受力過程中，短鋼纖維發揮其抗拉強度高，而混凝土發揮其抗壓強度高的各自優勢，從而使其具有優良的抗裂、抗彎、耐疲勞、耐磨耗、韌性高等力學性能，在公路路面、機場道面及建築結構的應用上有著廣闊的前景。
分享友人
分享到 Line

分享到臉書