tension compression loading 中文意思是什麼

tension compression loading 解釋
拉壓載荷
  • tension : n 1 拉緊；伸張。2 （精神、局勢等）緊張。3 【物理學】張力，拉力，牽力；（彈性體的）應力；（蒸氣等...
  • compression : n. 1. 壓縮；壓緊；濃縮，緊縮。2. 加壓；壓抑。3. （表現的）簡練。4. 應壓試驗。
  • loading : n. 1. 裝貨。2. 裝載量；重量；載荷；（船隻等的）貨載。 3. 填充物，填料。4. 額外人壽保險。
  1. Abstract : based on the data obtained from field observations and deformation monitoring, this paper deals with the deformation and failure of a double - decked slope composed of soft rock strata in its lower part and hard - brittle rock strata in its upper part. it is demonstrated that the deformation of this kind of slopes is always initiated by the non - homogeneous rheological compression of the lower soft rock strata, leading to the tension fracture and toppling of the upper hard rock strata, and at last the sliding of the whole deformed body will be caused by the shear failure along the stress - concentration zone in the lower soft rock mass under the actions of the gravitational loading and infiltration water

    文摘:以現場考察和變形監測資料為依據，探討一個下部有軟弱基座，上部為硬脆性坡體的「二元結構」邊坡的變形破壞問題，揭示這類邊坡的變形總是以下部軟弱巖體的不均勻壓縮流變為先導，進而引起上部硬脆性坡體的拉裂與傾倒，最終通過滲入水的作用，使下部承載狀況已進一步惡化了的軟弱巖體，沿剪應力集中帶發生剪切破壞而導致整個變形坡體的下滑。
  2. In this dissertation, the effect of texture, heat - treatment, and hydrogen on the lcf behavior of zircaloy - 4 and the cyclic deformation behavior for zircaloy - 4, n18 alloy and n36 alloy have been investigated systematically using fully - reversed tension - compression loading under strain control ( r = min / max = - 1 ), while the evolvement of the friction and back stresses versus the number of repeated working cycles and the plastic strain amplitude has been studied, and the thorough discussion combined with the analysis result of fatigue sub - structure, friction and back stresses, and fatigue fracture has been given to the mechanism underlying the lcf behavior of alloys

    本文採用對稱拉壓循環變形方法（ r _ = _ （ min ） _ （ max ） = - 1 ） ，系統研究了織構、熱處理狀態、氫對zr - 4合金低周疲勞性能的影響， zr - 4合金、 n18合金和n36合金的循環變形行為，並研究了摩擦應力、背應力隨循環周次、塑性應變幅的變化規律。結合疲勞亞結構和疲勞斷口的分析結果，深入探討了影響合金低周疲勞行為的作用機制。
  3. Merely the fatigue strength in uniaxial tension or compression under constant - amplitude cyclic loading is given in the existing design code. the design result by using the fatigue strength in the code is apt to conservative under variable - amplitude or triaxial cyclic compression loadings, but sometimes apt to dangerous in uniaxial or triaxial tension - compression fatigue loadings

    現行規范中，僅有混凝土單軸、等幅波動拉伸和抗壓強度指標，採用這些指標進行設計，會導致設計結果有時偏於保守，如變幅及多軸壓疲勞；而有時又偏於危險，如單軸及多軸波動拉-壓疲勞。
  4. Damage model for tension - compression fatigue loading of concrete and its verification

    壓疲勞損傷模型及其驗證
分享友人
分享到 Line

分享到臉書