test for blank 中文意思是什麼
test for blank
解釋
空白區檢查-
Spatial resolution deficit pattern, after administration for 10 days, water maze test was adapted to train mice for successive 5 days. a blank control group received ip of equivalent normal saline, the remaining 5 groups received ip of 15mg / kg pentobarbital sodium at 30min before training everyday, mice were administrated 1 time during training
空間分辨障礙小鼠，連續給藥10天後，採用水迷宮法連續訓練5天，每天y ！ i練前30ndn ，腹腔注射戊巴比妥鈉15mg kg 。訓練過程中每天給藥1次。 -
Brushed with the thickness of 1. 5 ~ 2. 0mm. it can improve the impermeability pressure up 3 times that of blank samples ; the crystalline reaction can continuously carry out, sealing the crack and waterproofing for ever if water is existent ; very good environmental adaptability, and can be used as normal at ph 3. 0 ~ 12. 0 ; moreover, the contrast tests of the performance of pt coating with two kinds of widely used waterproofing coating xypex and coprox were also carried out in this paper. test results show that the properties such as impermeability, self - rehabilitating ability and corrosion resistance are superior to those of the counterparts
試驗結果表明， pt防水塗料具有如下的性能特點：具有良好的防水性能，塗刷厚度1 . 5 2 . 0mm ，抗滲壓力可提高3倍以上；在有水的條件下，結晶反應可以不斷進行，能實現自愈合、永久性防水；具有很強的環境適應性，在ph值3 . 0 12 . 0條件下均可正常使用；此外，本文還進行了pt防水塗料與同類型防水材料xypex和防水寶（二者都是目前應用廣泛的防水塗料）的性能對比試驗。 -
At this background, though coupling beams with the small ratio of the span to depth have no sufficient test results, in order to satisfy the needs of engineering design, the code for design of reinforced concrete high - rise structure ( jgj3 - 2002 ) still adopt the design method of decreasing the maximum shear force and increasing the quantity of stirrups. but in china code for design of concrete structures ( gb 50010 - 2002 ) the content of seismic design methods for these kinds of coupling beams continue to be blank
在這一背景下， 《高層建築混凝土結構技術規程》 （ jgj3 - 2002 ）為了滿足工程設計需要，對小跨高比連梁在沒有充分試驗結果的情況下，仍採用降低最大作用剪力和提高箍筋用量的設計方法（雖然這種方法已被國外試驗證明在跨高比小於1 . 50的連梁中是肯定不能保證延性要求的） ，而《混凝土結構設計規范》 （ gb50010 - 2002 ）則把這部分內容繼續留作空缺。 -
Fixed capacitors for use in electronic equipment. part 4 : sectional specification : aluminium electrolytic capacitors with solid or non - solid electrolyte. selection of methods of test and general requirements. blank detail specification : aluminium electrolyte capacitors with solid electrolyte. assessment level e
電子設備用固定電容器.第4部分:分規范:固體或非固體電解質鋁電解電容器.第2節:空白詳細規范:固體電解質鋁電解電容器. e級評定
分享友人