test wedge 中文意思是什麼

test wedge 解釋
三角試片
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  • wedge : n 1 楔，尖劈，楔形物；【幾】楔形。2 【冶金】高壓頂點。3 〈比喻〉可以逐漸擴大作用的開端。vt 用楔子...
  1. Later it was taken that the optimized design for geometry parameters of longitudinal and transverse array ulpa wedges, and the principles for the optimized design of wedges " angles and the distance from piezocrystal center along wedge surface to test surface were deduced

    隨后進行了縱向和橫向兩種線陣楔塊的幾何優化設計，推導出楔塊角度以及晶片中心沿楔塊表而到探測而距離的優化設計原則。
  2. By using 5000kn pressure - bent testing machine, the specimens of boulder concrete and crushed stone concrete were tested through three - point - bending method and wedge - split tensile method, the scale division of the index dial of pressure - bent testing machine is larger, whereas the predicted test - load is lesser, so the velocity of exerted load is controlled through observing the reading of the multimeter which is connected with the collecting systerm in order to continuously exert test - load

    本文使用5000kn壓彎實驗機，對不同強度等級的卵石混凝土和碎石混凝土試件分別進行了三點彎曲試驗和楔入劈拉試驗。試驗過程中，由於實驗機噸位較大，而試驗荷載預計較小，為了能夠有效地控制加載大小和加載速度，採用通過觀察與荷載傳感器相連的萬用表讀數控制加載速度的方法，連續加載。
  3. Imaging media - determination of brittleness of photographic film - wedge brittleness test

    成象煤體-攝影膠片的脆性的測定.楔入脆性試驗
  4. Aerospace ; structural adhesives ; wedge test

    航空航天.結構粘合劑.楔形粘合試驗
  5. Wedge splitting test ： the specific feature of this testing method is the determination of fracture mechanical parameters at high temperatures ( 1100 to 1250 )

    楔劈實驗：這種測試方式用於在高溫時（ 1100到1250 ）確定火磚的斷裂機械參數。
  6. Photographic films and papers - wedge test for brittleness

    照相膠片和相紙脆性楔式試驗方法
  7. Standard test method for residual embrittlement in metallic coated, externally threaded articles, fasteners, and rod - inclined wedge method

    金屬鍍覆的外螺紋製品緊固件和棒的殘留脆變的標準試驗方法.傾斜楔入法
  8. The following two chapters make of the third part. chapter five analyses the failure factors of test model and identifies the valid scope of two - part wedge theory. chapter six extends the valid scope of two - part wedge theory, and puts forward integer slide theory, then uses the extended theory calculating a concrete project, seismic design suggestions are proposed finally

    第三部分包括第五章和第六章，第五章對試驗模型的破壞影響因素進行數值分析，確定了「雙滑楔體」理論的適用范圍，並對各種破壞因素進行了分析；第六章拓廣「雙滑楔體」理論適用范圍，補充介紹了整體滑動理論，應用拓廣后的理論計算實際工程，為實際工程的基坑邊坡設計提供參考依據。
  9. Chapter one and two which introduce two - part wedge theory put forward by hoe i ling are included in part one, and regarded as the theory foundation of model test

    第一部分包括第一章和第二章，主要介紹美國哥倫比亞大學hoeiling教授提出的「雙滑楔體」破壞理論，為模型試驗奠定了理論基礎。
  10. Is a wedge test specimen utilized for chill or analysis control

    是否用楔型試塊進行分析控制
  11. A solid - waste containment system can be simplified as a slope which contains a layer of geomembrane ( which is simplified as interlayer slope in the rest part ). shaking table model test and numerical analysis have been done to study the seismic stability of interlayer slope based on the two - part wedge theory in this paper. many factors which affect the slope stability ratio, including horizontal seismic coefficient, slope angle, soil - geomembrane interaction coefficient, slope length, layer thickness and soil character, have been took into consideration

    填埋場防滲基坑的邊坡可以簡化成含土工膜夾層的土坡（以下簡稱夾層土坡） ，本文根據「雙滑楔體」理論思想，對夾層土坡的地震穩定性問題進行了較為系統的模型試驗和數值分析，著重考慮了水平地震系數、夾層土坡坡角、土工膜與覆蓋層土體摩擦系數、夾層邊坡長度和厚度、夾層土坡覆蓋層土體性質等因素對土坡安全系數的影響，並對地震作用下夾層土坡的永久變形進行了初步的研究，給出了對實際工程設計有參考價值的結論。
  12. Standard test method for adhesive - bonded surface durability of aluminum wedge test

    用膠粘劑粘結的鋁表面耐久性的標準試驗方法
  13. Structural adhesives - qualitative assessment of durability of bonded assemblies - wedge rupture test

    結構膠粘劑.粘合組件耐久性的定性評定.楔形破裂試驗
  14. Structural adhesives - qualitative assessment of durability of bonded assemblies - wedge rupture test iso 10354 : 1992 modified ; german version en 14444 : 2005

    結構膠粘劑.粘合組件耐久性的定性評定.楔形破裂試驗
  15. Metallic and other inorganic coatings - test for residual embrittlement in both metallic - coated and uncoated externally - threaded articles and rods - inclined wedge method

    金屬和其它無機覆層.金屬覆層和非塗層外螺紋件和棒材殘余脆性試驗
  16. Adhesives - characterization of durability of structural - adhesive - bonded assemblies - wedge rupture test

    膠粘劑.結構粘結組件耐久性的特性.楔形破裂試驗
  17. By comparing the fracture toughness ( kic ), the fracture energy ( gf ) and the crack tip opening displacement ( ctod ) of the same strength grade concrete, it is found that the values of the fracture toughness ( kic ), the fracture energy ( gf ) and the crack tip opening displacement ( ctod ), tested by three - point - bending method and wedge - split tensile method approach, so it is proved that the fracture toughness ( kic ), the fracture energy ( gf ) and the crack tip opening displacement ( ctod ) are related to its own properties such as material, specimen size, and crack size, but unrelated to the test - method

    通過比較三點彎曲法和楔入劈拉法測定的相同強度等級混凝土的斷裂韌度k _ （ ic ） 、斷裂能g _ f以及裂縫的尖端開口位移ctod ，發現兩種試驗方法測定的斷裂韌度k _ （ ic ）斷裂能g _ f以及裂縫的尖端開口位移ctod的數值接近，從而證明混凝土斷裂韌度、斷裂能、 ctod的值僅與材料、試件尺寸、裂縫尺寸等試件自身的性質有關，而與試驗方法無關。
  18. Imaging materials - photographic films and papers - wedge test for brittleness

    成像材料.攝影膠片和相紙.加楔的脆性試驗
  19. Test method for formability of attached organic coatings with impact - wedge bend apparatus

    用沖擊邊緣彎曲儀測定附加有機塗層可成形性的試驗方法
分享友人
分享到 Line

分享到臉書