testing condition 中文意思是什麼

testing condition 解釋
試驗狀態
  • testing : 測試系統
  • condition : n 1 狀態，狀況，情形；品質。2 〈pl 〉外界狀況，周圍情形。3 地位，身分。4 條件；【語法】條件子句。...
  1. And rock triaxial serve testing system is used, through model test involving bedded planes and a set of joint normal to the bedded planes in rock mass, multiple sliding failure affected by properties of joints and confining pressure is analysed, the condition triggering multiple sliding failure and characteristics of failure plane are given, under the co - action of inclination of connective joints ( bedded planes ), interlocking conditions of critical joints and confining pressure

    並在室內利用巖石三軸剛性伺服機，通過模型試驗對巖體的層面和一組與層面正交的節理的情況進行模擬研究，分析了結構面性狀和圍壓對復合式滑移破壞的影響，給出了在貫通性結構面（層面）傾角、非貫通性結構面以及圍壓等因素共同作用下，節理化巖體發生復合式滑移破壞的條件以及破壞面特徵。
  2. The multi - work condition declivitous impact testing system was introduced which has variable impacting angle, rigidity, and length of stroke, and has elastic booster to increase impacting intensity

    摘要論述了多工況斜面沖擊試驗新系統，具有碰撞角度和壁障剛度可調，斜面沖程和沖擊角度可選，並裝有彈性助力系統以提高沖擊強度等特點。
  3. This paper describes the principle and method for testing pile bottom force - hearing layer and pile body force - bearing declivity, deals with results of standard component test and inclined model pile test under the condition of inclination, and also gives some practical examples of engineeing application

    摘要闡述了樁底持力層與樁身傾斜度測試原理及方法，列舉了傾斜情況下的標準件試驗及傾斜模型樁試驗結果與工程應用實例。
  4. Using french chalk which was dried by the 120 air as the normal air model, the quality which the fabric contains particle can be test. considering the fabric ' s reusing, the author has washed the fabric in many ways and compared the washed and unwashed fabrics " purifying performance testing datas. through putting the fabric on the home air condition, the author analysed the effect to the air condition ' s runing and purifying performance

    為了將高效濾料進一步推廣使用，本文通過試驗，得到過濾速度和定量對過濾材料過濾性能的影響；利用120的高溫烘乾過的滑石粉作為塵源，試驗得到該濾料的容塵量；考慮到濾料的重復使用問題，對濾料進行清洗處理，比較處理前後濾料的過濾性能測試結果，看能否對濾料進行清洗。
  5. Along with the deeper study on the reliability testing and testing equipments, varieties of testing methods and fail data emerge as the times require, naturally the former analytic method would probably not satisfy us when the condition changes. the inapposite statistical arithmetic would clag the development of reliability technology undoubtedly

    在電器可靠性技術領域，隨著對電器產品可靠性試驗及其裝置深入的研究，各種不同的試驗方法及不同類型的失效數據應運而生，繼續沿用以往的失效數據分析方法將可能不會得出令人滿意的結果，因此能否尋找出適合的數理統計方法將是制約可靠性研究的一個瓶頸。
  6. The result is that this gas pool has simple structure, only forms a little nose - like structure at the district of fenghuangshan ; this pool belongs to delta front sub - facies sedimentary model, the underwater distributary channel and mouth bar is the better sedimentary microfacies ; the physical property of the reservoir is poor, the type of pore of the reservoir rock mostly are intergranular pore, intergranular solution hole and little are intercrystalline micropore ; the influential factors of pore structure and physical property are lithofacies, lithologic character and diagenesis ; the off - take potentia of all the testing well are deadly shortness, the wells have the worth of industrial recovery only under the condition of going through sand fracturing, and in the early of binging into production, the oil and sheath pressure drop rapidly, the production of the well drop rapidly

    研究認為該氣藏構造簡單，只在鳳凰山形成了一個小型的鼻狀構造；屬於三角洲前緣亞相沉積模式，水下分流河道和河口壩是有利的沉積微相；儲層物性差，儲層巖石的孔隙類型主要有粒間孔、粒間（內）溶孔及少量晶間微孔；影響蓬萊鎮組氣藏儲層孔隙結構及儲集性的因素有巖相、巖性條件及成巖作用；所有測試井自然產能都極低，必須經加砂壓裂后才有工業開采價值，且投產初期，油套壓下降較快，氣井產量下降迅速。
  7. 224 drillholes, 250 trial pits, refurbishment of 48 existing standpipes piezometers, laboratory testing of soil and rock samples obtained from the investigation works and the structural condition survey on existing highway structures along tuen mun road

    224個鉆孔， 250個探井，重整48個豎管測壓計，將所取得的土壤和巖石樣本進行實驗室試驗，以及對屯門公路上現有的公路建築物進行結構狀況勘測。
  8. By means of the analysis on motion equation of simple pendulum, a method for testing the moment of inertia of a complex shaped rigid - body moving around a fixed axle under the condition of not knowing the barycentric position of the object was obtained

    摘要通過對單擺運動方程的分析，得到了未知物體質心位置條件下測試復雜形狀剛體繞定軸轉動慣量的方法。
  9. Taking the measure of uncorking on the steel tube and filling water before sand filling, the installation process of sand compaction piles is optimized, the installation parameters and testing rate under the near shore condition are confirmed, and the control and testing methods for the piles ' quality are summarized

    採取樁管壁開孔、先灌水后灌砂的方法，優化了水上擠密砂樁的施工工藝；給出了在近岸無掩護、水流急的施工條件下的施工參數和檢驗比率，總結了沉樁定位、高程式控制制、灌砂率等參數的控制措施和檢驗方法。
  10. The research showed that combined modelling technology on dynamic behaviour can take full advantage of theoretical analysis and site testing. thus the synthesis response of dynamic behaviour of the whole structure can be acquired, and the specific condition such as component joint, restriction, and damage in the model can be reflected. so this method is reliable and effective

    揚州大學碩士學位論文研究表明，動力特性聯合建模技術充分利用理論和實測的優勢，既可以獲得整體結構動力特性的綜合響應，又可以反映結構的各部件連接、約束、損傷等具體情況，是一種可靠而有效的方法。
  11. Acoustics - measurement of airborne noise emitted by earthmoving machinery operator ' s position - stationary testing condition

    聲學.測量土方機械操作者位置發出的氣載噪聲.靜態試驗條件
  12. There are advantages to using rapid viral testing for influenza as part of the standard guidelines for managing fever of unknown origin in infants in good general condition during flu season, the authors conclude

    最後，作者總結說，在流感季節，將快速流感病毒測試作為標準治療方案的一部分，有助於使原因不明的發熱患兒的治療處于有利地位。
  13. But using a floating bulkhead as a door of checkgate is a new concept. because of the complex boundary condition and the fluid - structure interaction, model testing is a very important method of researching in this field

    浮箱門在動水中運行時，由於門體和水流的耦合作用和邊界條件的影響，其受力情況極其復雜，研究手段以物理模型試驗為主。
  14. The paper firstly analyzed the condition for the transit of information efficiency to the capital allocation efficiency, then tested the efficiency of the stock market mainly from the viewpoint of the formation of industrial capital employing co - integrated testing

    通過分析信息效率向資本配置效率傳導的條件，然後從產業資本形成的角度出發，利用協整分析方法對中國股票市場上的資本配置效率進行了檢驗。
  15. Based on the analysis about the test requirements and the saturated magnetization of the armor plate, the excitation magnetic circuit satisfying the testing condition and a validation system are designed. because the geometric, of the magnetic leakage at the direction of the normal of the roundness fault has the feature of two peaks : a positive and a negative, using the linear regression and the software matlab, two regression equation are proposed : one is about the peak value of the magnetic leakage and the diameter and depth of the roundness fault ; the other is the distance between the two peaks and the diameter of the roundness fault. the result of the validation system proves that the two equations are valid, and an applied method using for quantificationally inspecting the roundness faults is proposed according to the two equations

    根據實驗要求，通過對鋼板達到飽和磁化的必要性進行的分析，設計了符合試驗條件的勵磁磁路，並設計了一套實驗驗證系統；根據圓形缺陷法線分量漏磁場幾何圖形正負雙峰值的特點，採用線性回歸擬合的原理和matlab軟體及其統計工具箱中的相關函數，給出了圓形缺陷漏磁場幾何圖形的峰峰值與圓形缺陷的直徑和深度以及峰峰值間距與圓形缺陷直徑的兩個回歸擬合方程，並通過實驗驗證系統驗證了擬合方程的正確性，利用這兩個簡單實用的擬合方程，提出了一種工程定量檢測圓形缺陷的應用方案。
  16. The technology of research include following. the computer order control to attain testing condition of relay ' s turn - on and off. to control of testing ac voltage by adoption of advance control strategy

    測控技術包括：實現模擬繼電器接通與分斷負載條件的順序控制技術；採用先進控制策略的試驗電壓控制技術；試驗參數檢測技術；試驗參數波形的實時顯示技術；以dsp （數字信號處理器）為核心的試驗數據高速採集技術。
  17. Railway applications. fatigue resistance of structural bonding zones. test methods and testing condition

    鐵路設備.結構結合處的耐疲勞性能.試驗方法和試驗條件
  18. 1 to confirm the testing condition under the component ' s criteria

    確認測試方式是否超過元件的最大規格（根據供應商提供的資? ） 。
  19. Second, the paper studies the testing project by orthogonal test and the method of principle components analysis to pick up the optimum testing condition. third, the paper analyzes the signal from vibration energy and abrasion degree

    通過建立大型回轉軸承裝置的振動模型，以大量的試驗數據為依據，提出了一套從試驗條件與參數的選取到最後分析結論判定的系統方法。
  20. This paper also studied effects of categories of semi - coke, total pressure, oxygen concentration, particle size and heating rate on maximum mass loss - rate, burning time, burn - out temperature, and described the dynamic transformation of combustion reactivity of semi - coke under different testing condition

    分析了半焦種類、實驗總壓、氧濃度、試樣粒徑和加熱速率對最大失重速率、最大失重峰溫、燃燒時間、燃燼溫度等的影響。
分享友人
分享到 Line

分享到臉書