throttle temperature 中文意思是什麼

throttle temperature 解釋
汽機入口溫度
  • throttle : n 1 〈方言〉喉嚨，氣管。2 【機械工程】風門，節氣閥，節流閥〈又叫 throttle valve〉；風門桿，節流桿...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. In this experiment, adjusting the throttle to the specific position, and letting engine rotary speed change from the lowest to the highest, at the same time, the data of the water temperature, the fuel temperature, the air press and the rotary speed can be noted. moreover, we can measure the fuel quantity and the ignition angle

    實驗中，調節節氣門在特定位置，並讓發動機的速度依次從最低變化到最高，同時記錄水溫、油溫、進氣壓力和轉速等數據，還可以測出相應的噴油量、點火提前角。
  2. Borrowing ideas from design theory and structure type of oil hydraulic proportional throttle valve and taking domestic and overseas correlative development as reference, this paper determines working conditions of the valve, designs its structure, selects suitable materials of its components, and performs corresponding intensity and temperature check

    在借鑒油壓比例節流閥的設計理論、結構型式以及參考國內外相關研究成果的基礎上，確定了水壓比例節流閥的工作條件，設計了水壓比例節流閥的結構型式，選取了合適的元件材料，並進行了相應的強度和溫升校核。
  3. According to a series of experimental data, the effect of following factors on the temperature in the ultra - low temperature box and cop are analyzed : the mixture composition, the pressure ratio and the return fluid extraction ratio of the rectifying column, the refrigeration capacity and the flow rate through throttle valve

    並根據一系列實驗結果，分析了工質配比、循環壓比及精餾柱迴流液的抽取率、加熱量和節流元件對低溫箱內溫度和系統cop的影響，為今後的進一步研究指明了方向。
  4. The company is specialized in the production of small diameter valve suitable for electrical station as well as sampling device and automatic feeding device for firepower electric plant, stop valve for high temperature and high pressure condition, throttle valve for high temperature and high pressure condition, counter - pressure high efficiency cooler, bi - screw reducer, fine adjustment valve together with pipe break, stop valve, diaphragm valve, plug - in speedy connector, ball valve and various special valves in addition to meter connector

    公司主要專業生產小口徑電站閥門及火力發電廠的爐內化學檢測集中取樣裝置、爐內自動加藥裝置，高溫高壓截止閥，高溫高壓限流閥，反壓式高效冷卻器，雙螺桿減壓閥、微調閥等取樣裝置件和石油化工行業使用的管道閘閥，截止閥，隔膜閥，承插式快速接頭，球閥及各種特殊閥門，儀表接頭等。
  5. It is concluded that it may be disadvantageous to capacity modulation at low temperature environment if the condenser area is smaller and throttle set is capillary. 3

    結果表明：系統在冷凝器面積偏小和採用毛細管作節流裝置的前提下，不利於低溫環境下的容量調節。
  6. In order to improve measurement precision and display fidelity of the instrument, three new methods of nonlinear calibration of thermal instruments, which are based on intelligent control theory, are presented in this paper, such as nonlinear compensation of zr02 oxygen measurement instrument using bp nn, nonlinear calibration of temperature measurement sensors using cmac nn and nonlinear identification of throttle flow meter using ga. these methods prove to be not only simple but also effective

    火電廠熱工儀表普遍存在非線性特性，為了提高參數測量的準確度和儀表顯示的精確度，基於智能控制理論，文中提出了熱工儀表非線性校正的新方法： bp神經網路補償氧化鋯氧量計非線性特性的方法、 cmac神經網路校正測溫傳感器非線性特性的方法、遺傳演算法辯識節流式流量儀表非線性特性的方法。
  7. The conclusion is drawn that in the quasi two - stage compression heat pump system coupled with ejector, discharge temperature of the compressor is decreased effectively, electric power is reduced, and heating performance is increased compared with those of the flash - tank throttle system in the same conditions. it shows that the quasi two - stage compression heat pump system coupled with ejector improves performances of air - source heat pump in theory

    由結果可以看出:在相同工況下，準二級壓縮?噴射復合熱泵系統可以有效降低壓縮機排氣溫度，所消耗的電功率較閃發器節流系統有所降低，制熱性能有所增加，從理論上說明該系統在解決空氣源熱泵低溫適應性問題上有進一步突破。
  8. This paper offers a method that can avoid the incorrect or rough methods mostly accepted now, and this method considers the temperature change along pipeline, the difference of friction loss in turbulence zone and the throttle effect in cross - section of reduced pipe

    針對現有的靜態模擬演算法存在的錯誤和不足，提出了一種更為精確的模擬演算法，該演算法除考慮了管道沿線的溫度變化、處于不同的紊流區摩阻損失的大小不同之外，還考慮了變徑管道在變截面處存在節流效應等問題。
  9. A new auto - cascade throttle refrigeration cycle with special cryogenic mixture for achieving the temperature range around 30k 60k

    溫區混合工質內復疊節流製冷循環及其實驗驗證
  10. With the operation conditions, the adsorber, the evaporator, the condenser, the receiver and the throttle are disigned. the adsorber is of the most importance in the adsorption system, so we provide the non - dynamic equilibrium model of active carbon fibre ( acf ) - methanol adsorption refrigeration pair. the numerical simulation is carried out based on the recorded solar radiation data measured in nanjing and daily ambient temperature for the typical clear days. the temperature field, the pressure field, the methanol concentration and the temperature of evacuted tube, and water tube are caculated

    吸附床是吸附製冷系統的核心，本文以活性炭纖維?甲醇為工質對，建立了吸附床非動態平衡吸附傳熱傳質數學模型，以南京夏季典型一天中的輻射強度和環境溫度為條件，模擬計算了吸附床在通水冷卻和自然冷卻兩種狀態下，吸附床內各點壓力、溫度、吸附率、吸附總量及真空管和冷卻水管壁溫隨時間變化關系。
  11. The engine is tested on the dynometer using the software that can monitor the ecu ( electronic control unit ) internal dataflow. and the electronic control fuel injection system parameters ( e. g. position of throttle valve, engine speed, air temperature, engine temperature, duration of injection ) are acquired at many different working conditions of engine

    本文以hirth3203二沖程汽油發動機為研究對象，利用開發的ecu內部動態數據流監測軟體進行發動機臺架試驗，獲取了在不同的油門開度和轉速下電控燃油噴射系統的一系列工作參數，如節氣門開度、發動機轉速、進氣溫度、氣缸溫度、蓄電池電壓以及噴油脈寬。
分享友人
分享到 Line

分享到臉書