time switch 中文意思是什麼

time switch 解釋
定時電門
  • time : n 1 時，時間，時日，歲月。2 時候，時刻；期間；時節，季節；〈常pl 〉時期，年代，時代； 〈the time ...
  • switch : n 1 （樹上折下的）細樹枝；軟鞭子；鞭打。2 假發；（尾巴上的）毛簇。3 〈美國〉【鐵道】道岔扳子，軌...
  1. The central heating is on a time-switch.

    集中供熱設備是定時開關的。
  2. If bath king has been used for a long time, there will be feculence on the switch panel. when clear it, cut off power at first to make sure power off. and then use dishcloth with a little neutral detergent to rub it till the feculence is removed

    用戶長期使用浴霸，開關面板沾有污漬，在清理這些污漬時，應先切斷電源（零線和相線） ，並在確認沒電的情況下，用沾有少量中性清潔劑的抹布擦試，待污漬擦去后，再用清潔干布擦乾。
  3. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現蓄電池恆流放電過程智能控制是蓄電池放電裝置發展的必然趨，本文提出了一種通過三極電阻調節模塊和由智能功率模塊ipm為開關器件進行斬波從而實現蓄電池恆流放電的方法。為達到對ipm的驅動保護和放電過程的智能控制，文中設計了igbt門極驅動脈沖pwm信號形成電路和ipm故障封鎖保護電路及由單片機80c196為核心的微機控制器。本裝置能夠對蓄電池進行0 150a放電電流及放電時間的精確控制及釋放容量的計算。
  4. This is a good time to switch to the classical notation.

    此刻是換用經典符號的好時候。
  5. Electric - controller is nubbin in developping. we are based on designing to structure of circuit, we are dead against in time and stabilization for controlling and communications, precision and rapidity for transformation etc. we have completed to select on microprocessor, clock - frequency and a / d transfer. it carry out transformation for valve position signal, and select on solid - switch ac

    在控制器的電路結構設計的基礎上，考慮到通訊、控制的及時、穩定、轉換的精度和速度等幾方面，主要完成對微處理器的選擇、時鐘頻率和a d轉換器的選用，閥位變送功能的實現，固態交流開關和顯示器的選擇等。
  6. In the hardware design, the paper completes modules ’ design like outside memory, patulous a / d, patulous d / a, rs232 communication, ecan communication, led control, keyboard control, distant control, emulation, reset, logic voltage switch, dsp supply power regulate and ac - dc power circuit, as well as room layout design like anterior panel, back panel etc. and dsp transfers data with peripheral equipments except outside memory using serial ports. besides, the whole circuit is configured in interrupt response. thus, it can meet system demand as well as take full advantage of tms320f2812 ’ s hardware resource. in the software design, the paper finishs programs like the interface programms intercommunicates with people, the distant control program, ad and da modules ’ control program, in addition, the paper select the velocity and acceleration state - feedback algorithm and is written in the program. the software design uses dsp integrate exploiting environment named ccs2. 2 of ti inc. as software instrument, and programs with the combination of c language and assembly language. moreover, in order to maintenance or modify the software expediently and shorten software ’ s exploitation time, the design adopt software modularization technique. finally, some air cylinder experiments are carried out to proved that the pneumatic controller is very practical

    在硬體設計中，本文完成了片外存儲器擴展、 a / d擴展、 d / a擴展、 rs232通信介面、 ecan通信總線介面、液晶顯示控制、鍵盤控制、遠程控制、模擬、復位、邏輯電平轉換、 dsp工作電源校正電路和ac - dc電源等模塊設計以及控制器前面板、後面板等的空間布局設計。其中dsp與除外部存儲器的外圍設備之間的數據傳送全部採用串口通信，同時系統電路配置成中斷響應方式，這樣既滿足了系統要求，又充分利用了tms320f2812的硬體資源。在軟體設計中，本文完成了人機界面功能模塊、遠程控制模塊、 ad擴展模塊、 da擴展模塊、速度和加速度狀態反饋的控制演算法的程序設計。
  7. For the first time, an integrated hall switch based on gaas mesfet process was fabricated

    論文首次採用gaas直接離子注入mesfet集成電路工藝，研製出了gaas霍爾開關集成電路。
  8. The automatic switch has light function ( delay time for three minutes ) : the light is opened automatically while opening the door, shut off the door taillight to go out automatically

    動開關照明燈功能（延時三分鐘） ：開門時燈自動打開，關閉門后燈自動熄滅
  9. The main loop of the welder uses a thyratron transistor non - contact switch circuit, quick and reliable close time, accurate timing of welding, high precision of welding, good repeatability, bring a high quality welding

    焊機主迴路採用晶閘管無觸點開關電路，關斷時間快、可靠，焊接定時精確，焊接精度高，重復性好，可實現高品質焊接。
  10. Optical power meter real - time monitor optical power of each optical cable, and control computer gather the value of optical power attenuation circularly, if some values excess the limit, the computer control optical switch to connect another spare optical fiber with otdr card, control the otdr card to test the optical fiber, and then find the malfunction point accurately. the system require software system to run with hardware devices tother. this paper analyze requirement and technical feasibility in software system, ooa and uml are used to analyze software and abstract the class diagram

    通過光功率計對每條光纜中的備用光纖進行實時的監控，測試光功率的衰減值，主控計算機不斷循環的對每個光功率模塊進行數據採集，並記錄每路光信號的光功率衰減值，然後進行分析處理，如發現達到設定的光功率衰減門限值就報警，並控制光開關的切換，將故障光纜中的另一備用光纖與otdr卡連接，通過otdr卡對該光纖進行測試，從而確定故障點。
  11. Particularly, cr4 + - doped crystals as passive q - switch ( saturable absorber ) have got extensive attention, such as cr4 + : yag ， cr4 + : gsgg ， cr4 + : mg2sio4 and cr4 + : yso, which have the advantages of wild absorption band, good saturable absorption, long restored time, good photo - chemical stability, no fading, good thermal conductivity and high damage threshold

    特別是近年來，摻cr4 +離子的各種晶體如cr4 + : yag ， cr4 + : gsgg ， cr4 + : mg2sio4和cr4 + : yso等作為被動調q開關受到了廣泛的關注。它們具有很寬的吸收帶和良好的飽和吸收性質，恢復時間較長，光化學性質穩定，無退化現象，熱導性好，損傷閾值高。
  12. Leon was supposed to signal us at the proper time by flashing a light in the window, but apparently he fell asleep at the switch

    利昂本來應該在適當的時候從窗口給我們發出閃光信號，但他顯然沒有履行職責。
  13. Time switch ts

    時間接線器
  14. Time switch for tariff and load control

    費率和負載控制時間開關
  15. Thermo - time switch

    熱時間開關
  16. Through researching these characteristics of real - time data received deeply, some good measures are put forward and accepted to improve the fault - tolerance performance of the fault diagnosis system in the thesis, such as advance disposing of real - time switch information and instauration of dummy switch etc. based on the data information received, three starting arithmetic is developed in the thesis

    本文在深入研究決策系統接收到的實時數據信息特點后，針對不同的情形進行不同的處理，它們是：對故障前後信息及故障時跳閘開關信息的確定、實時開關變位信息的預處理、虛擬開關的設立等。從投入現場運行以來，這些處理方法取得了良好的預期效果，提高了故障診斷系統的容錯性和抗噪聲能力。
  17. While shutter doors and windows can conduct such settings, temperature and wind control, and that is when the room reaches a certain temperature or outdoors when the wind is strong it will automatically switch, so you have to go to work when no worries, regular design can make shutter doors and windows at a predetermined time switch, and a cluster of design can be so the home fans several windows simultaneously switching

    同時卷簾門窗還可進行這樣的設置，溫控和風控，即當室內達到一定的溫度或室外刮大風的時候它會自動開關，這樣您在上班的時候也沒有后顧之憂，定時設計則可以使卷簾門窗在預定的時間開關，而組群設計還可以使家中的幾扇門窗同步開關。
  18. On one hand, the problem of " big horse pulls little wagon " is resolved and the working efficiency of motor is improved by optimizing way to control the stator ' s voltage ; on the other hand, an energy automatic processing system of " electric motor generates electricity " is developed, in which, the energy of the feedback of motor generating electricity is processed duly and correctly through real - time switch control of the generating electricity absorbing energy cell and is used at wellhead instead of returning power net

    本課題運用新型電力電子技術和計算機控制技術研究開發了一種電機功率因數自調整及節能控制系統，一方面通過對定子電壓的尋優控制，解決了「大馬拉小車」問題，改善了電機的工作效率；另一方面開發了一種電機「倒發電」能量自動處理系統，通過倒發電吸收單元的實時切換控制，將倒發電反饋的能量及時準確地進行處理，使其在井口利用不返回電網。
  19. On - load tap - changer of transformer can work under load, transfer quickly, change one class voltage about 3 - 6 ms each time ; switch can be operated by hand or electrically - driven and distant place operate while being electronic too, easy to realize automatic management ; transfer and keep relatively heavy range is generally more than 15 % ; switch and voltage transformer structure are more complicate than others, make man - hour and material increase, the cost is relatively high

    變壓器的有載調壓能帶負載調壓，調壓速度快，每調換一級電壓約3 6s ；開關可手動、電動操作，也能遠方電動操作，便於實現自動化管理；調壓范圍較大，一般為15以上；開關和變壓器結構比無勵磁調壓的復雜，製造工時和材料增多，成本較高。
  20. Time switch and control unit tcu

    時間交換和控制單元
分享友人
分享到 Line

分享到臉書