tip size 中文意思是什麼

tip size 解釋
電極接觸表面直徑
  • tip : n 1 （塔、手指、尾巴等的）尖，尖端，頂端，末端，梢。2 裝在末端的東西，加固末端的金屬環[箍]；鞋尖...
  • size : n 1 大小，尺寸規模身材。2 （鞋帽等的）尺碼，號；（紙張的）開。3 巨大，大量；相當大的分量。4 〈口...
  1. These brushes are designed to be easily inserted into the spaces between the teeth and can be used with or without toothpaste, etc., for greater effectiveness, they also feature bristles that vary in thickness between the tip and root except for size 1

    刷毛部分的毛尖和毛根粗細不同，即使沾有牙膏或牙粉也能平滑進入間尺寸為1的除外，把手部門採用側凹加工及八角形狀把持更加穩固。
  2. No endplate of reasonable size will prevent tip flow.

    沒有一個合適的端板尺寸將會阻止翼根繞流。
  3. At arm s length, the angular size of our fists is about 10, fingers is about 1 and the tip of the thumb to the tip of the little finger of an extended hand is about 20

    將手伸直后，拳頭的角大小約為10度，手指約為1度，若把手掌張開，由拇指尖至小指尖的角距則約為20度。
  4. According to elasto - plasticity theory, with the help of finite - method program ansys, the paper undertakes the computer analogue tests about the bearing capacity of pile tip arranged by orthogonal principle, and attains the relations of pile - tip bearing capacity to embedment depth, pile diameter, cohesion, internal friction angle and modulus of deformation. by the means of mathematical statistic, regression equation of the ultimate bearing capacity calculated by finite element method is gained through the regression analysis of 81 group data from the computer analogue tests. by comparison and analysis of the values calculated by finite - element regression equation and the values of in situ loading test, the regression equation is gained which calculates the size effect for base resistance of large diameter pile

    根據彈塑性理論，運用大型有限元軟體ansys按正交設計理論對樁端承載力進行模擬計算，獲得樁端承載力與樁長（埋置深度） 、樁徑、粘聚力、內摩擦角及變形模量等主要影響因素的關系，並採用數理統計方法，對81組ansys模擬試驗結果數據進行回歸分析，得到有限元法確定樁端極限承載力的回歸公式，並將有限元法回歸公式計算值與現場小壓板載荷試驗值進行比較分析，得到大直徑樁端阻的尺寸效應系數計算公式。
  5. Twelve casing configurations were investigated, consisting of three step profiles at each of three clearance levels ( including seven casing geometric size ) to find the effects of radial / axial variation of tip gap on rotor performance, and five casing configurations including two types of asymmetric profiles were applied in the research of circumferential variation of tip clearance

    文中設計了十二種機匣結構用於與實壁機匣相比較，包括軸向布局的七種階梯狀結構及五種周向變化的不對稱結構形式（偏心周向變化和橢形周向變化） 。
  6. Based upon the near crack-tip elastic analysis, estimates of the size and shape of the plastic zone will be developed.

    根據裂紋尖端附近的彈性分析，來估計塑性區的形狀和大小。
  7. A 33 - year - old male had suffered from one mildly tender dome - shaped protruding mass measuring 0. 8 0. 8 0. 5cm in size over the tip of the right index finger for about 3 months

    摘要一位33歲男性于近三個月在右手食指頂端出現一輕微壓痛之圓頂型腫塊，其大小約0 . 8 0 . 8 0 . 5公分。
  8. According to the flow characteristics and the tip shape of the injection pipette measurements of ejection volume and tip size of the pipette were explored theoretically and described methodically

    就微針端內徑、出流量的測量進行了理論探討和方法闡述。對出流量與諸影響因素間的關系進行了理論推導和試驗測試。
  9. Basing on past achievement, we analyzed and gained the damage expression, the craze stress expression in craze zone and the integral equation that the size of craze zone met, all of which changed with time, distance from crack - tip and crack growth ratio

    分析得出本文實驗中銀紋區內損傷、銀紋應力隨時間、距裂尖位置的表達式及銀紋區尺寸所滿足的積分方程。
  10. A finite element analysis ( fea ) was eventually conducted, using mori - tanaka model and j - integral, to further explain the toughening mechanisms and fracture behaviour of the particle interleaved composites. the aim of the analysis was to examine the influence of the particle concentration and size, and the interaction between the particle and the crack tip. fea results indicate that interlayer zones can effectively lower j - integral and stress around the crack tip, and the high stress distribution in the region close to the interface can be the driving force for interfacial failure

    本文的最後還藉助于有限元方法對層間增韌復合材料進行了宏觀和細觀斷裂韌性分析，基於mori - tanaka等效夾雜理論，計算了顆粒含量和尺寸對j積分的影響，有限元分析的結果同樣表明層間增韌可以有效的降低裂紋尖端應力水平，並暗示界面是可能存在的失效原因，所進行的數值分析起到了進一步支持和解釋增韌機理的作用。
  11. As one of the most beautiful places on earth, the 137 islands, islets and shoals that make up the hawaiian island chain sit at the northern tip of the polynesian triangle, an expanse of ocean roughly the size of europe and north america combined

    作為世界上最美麗的勝地，由137個島嶼、小島和沙洲組成的夏威夷島鏈位於波利尼西亞三角洲的北部，此地所涵蓋的海洋麵積幾乎等於整個歐洲和北美的面積。
  12. By comparing the fracture toughness ( kic ), the fracture energy ( gf ) and the crack tip opening displacement ( ctod ) of the same strength grade concrete, it is found that the values of the fracture toughness ( kic ), the fracture energy ( gf ) and the crack tip opening displacement ( ctod ), tested by three - point - bending method and wedge - split tensile method approach, so it is proved that the fracture toughness ( kic ), the fracture energy ( gf ) and the crack tip opening displacement ( ctod ) are related to its own properties such as material, specimen size, and crack size, but unrelated to the test - method

    通過比較三點彎曲法和楔入劈拉法測定的相同強度等級混凝土的斷裂韌度k _ （ ic ） 、斷裂能g _ f以及裂縫的尖端開口位移ctod ，發現兩種試驗方法測定的斷裂韌度k _ （ ic ）斷裂能g _ f以及裂縫的尖端開口位移ctod的數值接近，從而證明混凝土斷裂韌度、斷裂能、 ctod的值僅與材料、試件尺寸、裂縫尺寸等試件自身的性質有關，而與試驗方法無關。
分享友人
分享到 Line

分享到臉書