traction resistance 中文意思是什麼

traction resistance 解釋
牽引阻力
  • traction : n 拖曳,拖拉,牽引;牽引力;〈比喻〉吸力,魅力;【醫學】(對于肌肉等的)牽引(術);〈美國〉市內...
  • resistance : n. 1. 抵抗,反抗,抗拒,抵禦;敵對,抵抗力,反抗力,阻力,【生物學】抗病性。2. 【電學】電阻;阻抗;電阻器。
  1. Cu - zn - cr - zr conducting bar alloy and cu - cr - zr end ring alloys used for superpower asynchronous traction motor rotor were prepared by ingot metallurgy. using hardness measurement, tensile test at room and higher temperature, electrical resistance test at room and higher temperature, optical microscopy, xrd, sem, and tem, the mechanical and electric properties and the microstructure of above alloys at different treatment were studied. them were also analysed and explained in theory

    採用鑄錠冶金法制備了大功率異步牽引電動機轉子用導條合金和端環合金,通過硬度測試、室溫拉伸、高溫拉伸、電導率測定、金相分析、 xrd 、 sem 、 tem等方法研究了不同加工工藝和熱處理工藝對上述合金力學性能、導電性能及其組織結構的影響和變化規律,並從理論上進行了分析和解釋。
  2. The calculation method of technical parameters of maximum output power, the short time power and continued power ( equivalent heating ) in electric braking are derived from analyzing the relationship of maximum regenerative power with resistance value of ground absorption equipment, model of traction power supply, train circuit and network voltage drop while performing electric braking

    通過分析列車電制動時的最大再生功率與電阻吸收裝置的電阻值、電制動時刻牽引供電系統的模型、列車電流、網壓降之間的關系,導出了列車電制動時最大輸出功率、地面電阻吸收裝置的短時功率和持續(等效發熱)功率等技術參數的計算方法。
  3. Particular broad lateral pattern combined with special tread compounds and high casing ensures an excellent heat - resistance, wearability and traction, suits for use on mine and building area

    獨特的寬橫花紋,特殊的胎面設計和膠料配方及高強力胎體結構設築工地廣泛採用的經久耐用的輪胎。
  4. Based on slip frequency control strategy for the mutual - feed test bed, it is studied the regulation of traction motor speed as well as the analog load resistance torque with analog load

    摘要針對互饋試驗臺,基於轉差頻率控制策略,研究了牽引電機側速度的調節和負載模擬側阻力矩的調節。
  5. In the light of the specific characteristics of structure of traction drivespeed - raising system, its structure is modified and resistance method is introduced to measure the lubrication film ; besides, computerisused to colle ctandanalyze data. thus effectivemeasure mentmethod for similar structure is provided

    針對牽引驅動增速系統結構的特殊性,對該系統的輸出軸進行了改造,採用電阻法對其油膜的形成進行了測試,並利用計算機採集數據、進行分析,為類似結構的油膜測試研究提供了一種行之有效的研究方法。
  6. And the primary and secondary relation of the factors and the optimum level of every factor were obtained as well as the best scheme of structure design in the research condition. regression equal between traction resistance and partial sphere height, bottom circle radium was set up to explore the effect of two evident factors ( height and bottom circle radium of the partial sphere ) on traction resistance by optimum calculation

    採用二次回歸試驗設計的方法,建立了球冠高度和球冠底圓半徑大小與牽引阻力間的回歸方程,進行了優化計算,進一步考察了球冠高度和球冠底圓半徑大小兩個顯著性因素對牽引阻力的影響規律。
  7. The equilibrium current in 24 - pulse traction rectifier system is analyzed. the relation between critical load and resistance of traction rectifier transformer is discussed

    摘要分析了24脈波牽引整流系統中的均衡電流,討論了臨界負載與牽引整流變壓器阻抗參數的關系。
分享友人