transmitted intensity 中文意思是什麼

transmitted intensity 解釋
透射, 射線強度, 穿透強度
  • transmitted : 透射的
  • intensity : n. 1. （思想、感情的）強烈，激烈。2. 強度。3. 【攝影】（底片的）明暗度。
  1. The rotary vibration influence on the transmitted light intensity ' s perturbance of the glan taylor prism

    泰勒棱鏡透射光強擾動影響的研究
  2. The fastened end of bar was machined to multi cone - shaped heads. through the cone heads compress the inorganic anchoring material, the load was transmitted from bars to base material. it changes the transfer path of loads and takes advantage of high compress strength of inorganic material, thus enhanced the anchor intensity of inorganically post - installed bars

    本文提出一種新型的植筋技術? ?帶錐頭無機植筋，它把鋼筋錨固端加工成多個錐頭，通過錐頭對無機錨固材料的擠壓，將荷載傳遞給基材，使基材與無機錨固材料的界面上產生剪壓復合應力狀態，改變傳統植筋的受力機理，利用了無機錨固材料抗壓強度高的特點，從而提高了無機植筋的錨固強度。
  3. On the basis of theory analysis, the average transmitted light intensity ( correspond to dc value ) was determined as characteristic parameter of raw water using photoelectric method for monitoring the fluctuation of transmitted light and photometric dispersion analyzer ( pda ). the dc value was closely related to both particle concentration and surface area of sand clay simultaneously. the experimental results shows that there is an exponential function relation between dc and surface area of sand clay in unit volume water ( sp ) : dc = asbp in which a and b are empirical coefficients. then the formula of macromolecule flocculant dosage is found to be d = f ( dc ) = e ( dc ) f in which e and / are empirical coefficients and the average correlation coefficient equal to 0. 981. so the model of automatical control system of water treatment plant was established using the formula

    應用透光率脈動檢測技術和光散射顆粒粒度分析儀（ pda ） ，通過理論分析，將pda的輸出信號之一? ?平均透光強度（對應于dc值）作為原水的特性表徵參數， dc值可以同時反映顆粒濃度和比表面積因素的影響，試驗結果證明， dc值與單位體積水中泥沙顆粒總表面積s _ p之間具有很好的冪函數關系： dc = cs _ p ~ d ，式中c 、 d為經驗系數，進而得到了以dc值為參數的高分子絮凝劑投藥量公式： d = f （ dc ） = e （ dc ） ~ f ，式中： e 、 f為經驗系數，平均相關系數達0 . 981 ，利用所建立的公式，建立了前饋? ?后饋聯合控制的在線自動投藥模型。
  4. On the basis of theories of physics, geometrical optics and photometry, the optical properties of collimated light beam incident upon single fiber perpendicular to the fiber axis are studied. by exploring the behaviors of reflected light and transmitted light from single fiber, the distribution of the light is described and the proportionalities between the intensity of the reflected, transmitted and scatered light are obtained respectively, and the different laws governing the intensity of diffused light and transmitted light from single fiber between near and far field are discussed. experiments demonstrate that the decrease of projecting light in far field is in direct proportion for the increase of fiber diameter, which serves as the theoretical basis for a series optics equations, as well as for the designment for photoelectric deviccs for detecting fibers

    結合物理學的基本原理和幾何光學的基本規律以及光度學的基礎理論等三方面，研究了單纖維在平行均勻光束垂軸入射時的光學性質.分析了單纖維反光和透光的特徵，光強分佈及反射光、透射光和散射光的相對大小;討論了在近場和遠場條件下，漫反射光和透射光光強的不同規律;通過實驗驗證了遠場時，纖維的漫射光強度與纖維直徑成正比的關系
  5. With analyzed the relation between the particles number in the oil and the contamination of t he oil, the relation between oil contamination and the weakening of transmitted light intensity, the oil contamination is monitored based on the particles scattered the light. the minimum peak value of the oil at low - loss transmission area of quartz optical fiber can be selected to monitor the oil contamination

    在對油液中磨損顆粒的含量與油液污染度的關系以及油液污染度與通過油液的光通量的減弱進行分析的基礎上，利用油液中懸浮顆粒對光線的散射的特性，對油液的污染度進行監測，選擇光線在石英光纖低損耗傳輸區域和油液對光線最小吸收峰進行測量。
  6. Only the main transmitted light from the glued layer or the first - order transmitted light also, is considered at most in the existing study outcome about light intensity transmission. on occasion, some experimental results about light transmission are given as a performance index. and nearly no one considers the contribution of the higher - order transmitted lights and the effects of the inaccuracy in glue technology on light distribution

    人們對它的研究，往往只考慮棱鏡膠合層的兩切割斜面上的主透射光束，至多同時考慮次級透射光束對出射光強的影響，或直接將光束光強透射比的實驗值的平均結果作為棱鏡的一個性能指標給出，很少考慮棱鏡膠合層間光束的多次反射對輸出光強的影響以及結構誤差和使用調整誤差對棱鏡光強分佈的影響。
  7. The results show that the peak intensity of the transmitted beam decreases with the increase of the input angle, the position of the peak intensity of the transmitted beam is shifted, and the spot size of the transmitted beam is changed. under the nonresonant case ( i

    結果表明，當以較大角度入射時，輸出為一系列空間分離的光斑:當以較小角度入射時，輸出盡管為單一光斑，但是與輸入相比，其峰值強度位置發生了偏移， _且光斑變大。
  8. If the message is encoded into the total intensity, the transmission method that works quite well in single - mode laser system cannot be extended directly to the multi - mode laser system due to the delay effect of the transmitted message

    當把信號疊加在總強度上時，由於信號有延遲效應，所以用原來在單模激光之間傳輸信號的成功辦法就出現了問題。
  9. Meanwhile, transmitted light intensity of measure route and reference route are detected simultaneously. thus the negative effect of illuminant vibration can be eliminated by their ratios

    通過檢測參考油液池的透射光強和測量油液池的透射光強，並把兩者進行比值運算，以消除光源波動等對測量結果的影響。
分享友人
分享到 Line

分享到臉書