turbogenerator 中文意思是什麼

turbogenerator 解釋
n. 名詞 渦輪發電機，透平發電機。

  1. A nonlinear unified controller design for heavy - duty turbogenerator

    大型汽輪發電機非線性綜合控制器設計
  2. Methods and limits for checking the direct gas ventilation cooling system of turbogenerator rotor

    透平發電機轉子氣體內冷通風道檢驗方法及限值
  3. Application of fuzzy clustering theory for diagnosing the vibration faults of turbogenerator units

    聚類模糊原理在汽輪發電機組振動故障中的應用
  4. The osilating monitoring and diagnosis system by using turbogenerator unit is introduced

    摘要介紹了藉助汽輪發電機組進行振動監測和故障診斷的系統。
  5. Application of fuzzy clustering analysis for the diagnosis of vibration faults of turbogenerator units

    模糊聚類分析在汽輪發電機組振動故障診斷中的應用
  6. Investigation on knowledge data discovery and data mining based on the real time turbogenerator ' s monitoring data

    基於汽輪機運行監測數據的知識發現和數據挖掘初探
  7. Fault diagnosis of the vibration of turbogenerator units based on ga neural network and evidence theory fusion

    基於遺傳神經網路和證據理論融合的水電機組振動故障診斷研究
  8. Measurement of airborne noise emitted by machines ; enveloping surface method ; turbogenerator sets for use in thermal power stations

    機器空氣噪聲的測量.包絡面法.熱電站用的渦輪發電機
  9. This paper expounds the structural design and operating mode of the sealing oil system of a turbogenerator with a detailed description of its simulation - based mathematical model set up for the system

    描述了汽輪發電機密封油系統的結構及其操作方式，並重點建立了該系統的模擬數學模型。
  10. With the development of electric power, the problem of vibration on turbogenerator shafts stands out. a deep research on vibration mechanism is carried out. and valid method for preventing and diagnosing fault is explored

    隨著電力工業的發展，汽輪發電機組振動問題越來越突出，人們對相應的振動機理開展了深入的研究，並積極探尋有效的故障預防和診斷方法。
  11. For solving the existing problems of machine braking and electrical braking during the process of stoppage of a turbogenerator set, a magnetic reducing method is recommended, which can greatly reduce the current of generators at switch due to remainder magnetic and abate the demand for braking switch

    摘要針對水輪發電機組在停機過程中，目前廣泛採用的機械制動和常規的電氣制動中所存在的問題，提出了採用減磁法來進行水輪機發電機組的電氣制動。
  12. On the grounds of theory of asynchronized turbogenerator ( astg ), based on the practice of the analog asynchronized generator, this dissertation designs and debugs the computer - controlled system, and investigates detailedly the intelligent excitation control method

    本文以異步化汽輪發電機（ astg ）理論為依據，模擬試驗機組的實踐為基礎，設計並調試了計算機測控系統，並對異步化汽輪發電機的勵磁智能控制方法作了深入的研究。
  13. Aimed at the rotor bearing system of 300 mw steam turbogenerator set and on the basis of establishing its concentrated general model with 8 supportings and 9 nodes, a study was carried out on the bending vibration response of the most left end surface of shafting and of the right end face of generator

    摘要針對300mw汽輪機組轉子軸承系統，在建立其8支承9節點集總模型的基礎上，對軸系最左端面和發電機右端面的彎曲振動響應進行研究。
  14. By the data observed on - site, it indicate that the reinforcing plan which the plant to disembark and the dam to be connected has solved the problem that the plant to disembark occurs resonance vibration with the frequency of the turbogenerator units, but the problem of resonance vibration of the downriver structure of the plant has not been solved, hence the study of the reinforce structure of the downriver plant must be made

    廠房在此長期嚴重的振動下，立柱出現水平周邊裂縫，門窗墻壁也均產生裂縫，威脅到電站的安全運行。現場測試表明上游廠壩間在一定范圍內連接加固，雖然解決了廠房上游一階頻率與轉頻的共振問題，但對下游結構作用不明顯，因此需要對廠房下游結構的加固作進一步的研究。
  15. In large rotating machinery using filmatic bearing ( turbogenerator, air compressor, etc. ) there is a potential trouble from impefect installation or running conditions, a metals " contact between rotors and shells. the trouble is usully called rubbing. the advantage of ae technologe in the rubbing diagnosis and early detection is showed. instead of classical ae characteristic parameters ( counts, amplitude, energy, duration and the other ones ) a new feature extraction by frequency analysis of ae envelop signals is discussed. both research of ae process and field experements indicate that periodic components in the envelop spectrum related to rotational speed increase evidently at the beginning of rubbing production, hence are highly sensitive to the rubbing fault diagnosis. according to the new design an acoustic emission equipment for the rubbing diagnosis named buaa ae testing system is developed and described

    汽輪發電機、空氣壓縮機等採用油膜支撐的大型轉動機械，由於安裝或運行中的原因，在轉子旋轉過程中，可能和器壁發生輕微的摩擦和碰擊，簡稱碰摩.聲發射技術在碰摩發生特別是故障早期診斷上有優越性.本系統的特點是沒有沿用傳統的計數、幅度、能量和持續時間等聲發射特性參數，而是在聲發射包絡信號的頻率分析中進行特徵提取.聲發射發生的過程分析和現場試驗都表明這種方法對碰摩檢測很敏感，在碰摩發生的起始階段，包絡譜中與轉速同步的周期性分量顯著增加.根據這種新的設計思想自行研製了buaa碰摩聲發射檢測儀並對此作了介紹
分享友人
分享到 Line

分享到臉書