ultrasonic bonding 中文意思是什麼

ultrasonic bonding 解釋
超聲波焊接法
  • ultrasonic : adj. 超音的，超音速的。 ultrasonic wave 超聲波。n. 超聲波。
  • bonding : 冰凍膠結
  1. Ultrasonic wire bonding was applied to connect the contacts and sub - miniature - a ( sma ) connectors. also a suitable shield box has been designed for the test of hts filters

    對于超導濾波器的焊接，採用超聲點焊焊接sma的接頭和高溫超導濾波器的接觸電極，實現了較小的接觸電阻和較好的機械強度。
  2. The presence of microwave or ultrasonic wave, the inter - and intra - molecular complexation of cellulose molecules through hydrogen bonding is weakened, and the complexed polymer of cellulose and nylon formed in situ. the yield strength and young ' s modulus of the ramie / nylon / lldpe composites are increased from 9. 68 mpa, 260 mpa to 15. 7 mpa and 722 mpa respectively

    經微波輻照或超聲波處理后，苎麻纖維素氫鍵被削弱，與尼龍形成氫鍵復合物，增強了苎麻尼龍電子束輻照lldpe復合材料體系的相容性，屈服強度、楊氏模量從9 . 68mpa 、 260mpa提高到15 . 7mpa 、 722mpa 。
  3. Ultrasonic wire bonding

    超聲波線焊
  4. Ultrasonic wedge bonding

    超聲楔焊
  5. The assembly department is having more than 20 assembly lines, 3 sets of bonding machines and 20 sets of ultrasonic welding machines

    裝配部有20多條裝配線， 3套壓焊機械和20套超聲波焊接機械。
  6. Experiments on bonding behavior evaluation for new - to - old concrete by means of ultrasonic pulse velocity

    超聲波速評價新老混凝土粘結質量的試驗研究
  7. Set up an ultrasonic wire bonding laboratory

    成立超聲波電子焊接實驗室
  8. He bonding quality for wcu and cu ( or crcu ) can be indirectly showed by the reflected wave amplitude of ultrasonic ; 3

    觸頭cuw cu （ crcu ）燒結面燒結狀況可以通過比較界面反射波波幅來反映。
  9. According to the test results from 18mm - thick - steel plate adhering to concrete, gas and oil, the obvious differences in the attenuation coefficient and number of bottom waves are found. the test results shows that it is feasible to adopt ultrasonic longitudinal wave reflection method to test the bonding quality of the steel and

    採用超聲縱波反射法單面檢測鋼-混凝土的粘結質量是可行的，採用底波衰減系數和底面反射波的個數作為判定鋼-混凝土的粘結質量依據是有效的，所採用的理論分析模型是正確的。
  10. In this paper, the reflection method of ultrasonic longitudinal wave and that of ultrasonic shear wave to test the bonding quality of the adhesive interface between steel and concrete from single - surface is adopted respectively

    因此，找到一種合理的無損檢測方法來判斷鋼-混凝土粘結質量具有重要的工程意義和實用價值。本文分別採用超聲縱波和橫波反射的方法來單面檢測鋼-混凝土界面粘結質量。
  11. In the past, the ultrasonic transmission method was widely adopted to test the bonding quality of the steel and concrete

    以往對鋼-混凝土粘結質量進行檢測，一般採用超聲波透射法。
  12. Ultrasonic bonding machine

    超聲波焊接機
分享友人
分享到 Line

分享到臉書