unit of tolerance 中文意思是什麼
unit of tolerance
解釋
公差單位-
The tolerance of hardness difference in each unit container is normally - 3 degrees
,每批號鋼珠的硬度差范圍一般都在- 3度之間。 -
At installation site. 3. the capacitance tolerance in each serial group and segment shold no more than 0. 5 %. the ratio between maximum value and minimum value of capacitance which is measured at any two termin - als of capacitor unit in three phases should no more than 1. 02
3 .電容器內部每個串聯組串聯段間的電容之差不大於0 . 5 % ,三相單元中在任何兩個線路端子之間測得的最大電容與最小電容之比不超過1 . 02 。 -
According to product quality requirements and tolerance regulations, a model of the theory of unit manufacturing quality control is obtained
根據產品質量要求和公差規定,建立了單元製造質量控制理論的模型。
分享友人