variation flow analysis 中文意思是什麼
variation flow analysis
解釋
變動工藝流程分析-
According to the experimental data of droplet size 、 particle spectrum range 、 droplet cone shape 、 flow rate 、 cover area and cover area rate which obtained through changing the pressure of power sprayer and the nozzle diameter in greenhouse ， this paper made comparative analysis on atomizing performance in same pressure and different nozzle type between same nozzle type and different pressure. the conclusion is that : the ejection rate and the droplet cone shape change with the variation of pressure and nozzle diameter ， average particle diameter decreases obviously and particle quantity increases obviously with the increase of pressure and decrease of nozzle diameter. these results will lay experimental foundation for precise spraying 、 low pollution and highly effective operation
本文根據溫室內動力噴霧機壓力與噴嘴孔徑的變化影響霧滴大小、粒譜范圍、霧錐形狀、流量、覆蓋面積及覆蓋面積率的試驗數據，對相同壓力下不同噴嘴型號和相同噴嘴型號時壓力不同時的微粒化性能進行對比分析和研究，得到如下結論噴出量與霧錐形狀隨著壓力和噴嘴孔徑大小變化而變化；平均粒徑隨著壓力的增加和噴嘴孔徑的減小而明顯減小；粒數隨著壓力的增加和噴嘴孔徑的減小而明顯增多，為精噴量、低污染、高防效的防除作業奠定了實驗基礎。 -
In order to study the influence of evolvement of permeation character induced by mesoscopic structural characteristics on macroscopic mechanical behavior and fracture mechanism, a nonlinear constitutive equations describing the relationship between damage of rock and seepage is proposed based on mesoscopic damage mechanics and biot seepage mechanics theory and coupling system of flow & solid in rock failure process analysis, f - rfpa2d, is developed to simulate the variation of permeability as well as coupling mechanism between seepage and stress during the initiation, propagation and coalescence of cracks in rock. this study also extends the research field of original rfpa2d
為了分析細觀結構特性變化引起滲透性演化對宏觀力學行為的影響，並進行滲流應力耦合作用下巖石破裂機制的研究，本文基於細觀損傷力學和biot經典滲流力學，建立了巖體損傷非線性本構方程和滲透率關系模型，開發出巖石破裂過程滲流-應力耦合分析系統（ couplingsystemofflow & solidinrockfailureprocessanalysis簡稱f - rfpa2d ） ，拓寬了原有程序rfpa2d的研究領域。 -
The calculated results are in agreement with the measured ones, indicating that according to the flow rate and composition of the exhaust gas and the mass and the carbon content of the liquid iron, the carbon content of steel bath can be dynamically determined ; with the aid of thermodynamic equilibrium analysis, the dynamic variation of temperature of the steel bath can be forecasted from the dynamic carbon content and the data from the exhaust gas analysis system
該模型計算結果與檢測結果吻合較好，這表明：通過煙氣流量、成分及鐵水質量和初始碳含量可動態地確定熔池中的碳含量；以動態確定的碳含量為基礎，結合爐氣分析數據，再經熱力學平衡分析，可預測熔池溫度的動態變化。 -
Based on the analysis of the variation law of smoke flow in subway platform fire, a concept about critical ventilation speed from platform to concourse was presented
在分析了地鐵站臺火災時煙氣流場變化規律的基礎上，提出了臨界通風速度的概念。 -
According to the variation of reactor flow regimes among reactor parts, a more efficient model is built. a new algorithm ( difference analysis ) is used to analyze this model. 3
針對反應器各區域流動狀況的差異，分區建立了適應各自流動特徵的反應器模型，並採用誤差分析和最小二乘法求解模型； 3 -
Complexity parameter c2, fluctuation complexity parameter cf and algorithm complexity parameter c ( n ) have been adopted to analysis pressure fluctuation signals from a gas - solid fluidized bed, the variation of the three complexity parameters with gas velocity from fixed bed, bubbling fluidization to turbulence fluidization are studied, then compared in order to characterize regime behaviors. it is demonstrated that there exists a phenomenon named " recorded " in the regime transition from fixed bed to bubbling fluidization, the three complex parameters are believed to be a new technique for flow regime identification
結果表明，起始流化至鼓泡態轉變的過程中，復雜性參數表明氣固體系會進行一種所謂的「重構」現象，這與用k熵表徵起始流化態至鼓泡態之間變化時所得到的結果相一致，並能明確地指示固定床、鼓泡流化及湍動流化等不同流態之間的轉變過程，為流型識別提供了新思路。 -
An improved finite volume technique and total variation diminish scheme has been presented for solving the numerical problem with complex flow gas and space time processing synchronously, based on analysis of some numerical method for increasing the convergence, precise and strong capture capacity of shock wave
針對高壓sf _ 6斷路器氣流場求解的復雜性和特殊性，在對常用氣流場數值求解方法應用特點分析的基礎上，本文採用改進的有限體積tvd格式進行斷路器氣流場數值求解，提高了解的收斂性、準確性和激波的捕捉能力。 -
The coupled turbulent flow field and temperature field are simulated by finite element method ; the influence of casting speed on the turbulent flow field and temperature field in the melting bath and the interaction between those two field are analyzed ; the variation tendency of the heat flux intensity between the melting bath and casting roll and law of variation with changes of casting speed in the process of solidification are given ; a comparison between the simulation results and experimental results demonstrates their good agreement ; and the mechanism of the heat flux variation is identified by analysis on the temporature gradient and development of solidification within the melting bath and its influence on the variation of the heat flux intensity
採用有限元法模擬了雙輥鑄軋不銹鋼過程的流熱耦合問題;分析了鑄軋速度對熔池內流場、溫度場的影響以及流場與溫度場之間的相互影響;給出了凝固過程中熔池與鑄軋輥之間的熱流密度變化趨勢及隨鑄軋速度的變化規律，並把此模擬的結果與試驗的結果相比較，吻合較好;通過熔池內溫度場及溫度梯度分析了熔池內凝固的發展及其對熱流密度變化的影響。 -
First, the direction of fringe variation in the interference images is different with different intake duct, but in the same intake duct, the direction is the same. second, different intake duct has different rules to flow variation. third, the infinite width of interference fringe is visual, high precision, and easy to qualitative analysis, but the finite width of interference fringe is easy to judge the direction of fringe variation and to further detailed analysis
實驗結果表明，氣道不同，條紋的變化方向不同，但同一氣道在不同的流量下，條紋的變化方向是一致的；不同形狀的氣道對流量的敏感程度不同，對氣體旋流的擴散作用影響也有很大的差異；用無限寬條紋法得到的圖像直觀，靈敏度大，易於做定性的分析對比，而有限寬條紋法可以進行流體在運動方向的判別，更有利於詳細的分析研究。
分享友人