vector magnitude 中文意思是什麼
vector magnitude
解釋
向量大小-
To corner feature, both gradient magnitude change and direction change of gradient vector are discontinuity in a local image neighborhood, hence gradient - direction variation and gradient magnitude are used as another decision rule of the corner detection to improve antinoise
為了提高抗噪聲，根據角特徵不僅灰度變化是不連續的，且相對周圍其他點的梯度方向也是不連續的，提出利用梯度角變化和梯度幅值作為角特徵檢測的另一個準則。 -
A vector is defined by a direction as well as a magnitude.
一個矢量要用大小和方向來表示。 -
The scalar product of a vector with itself is the square of the magnitude of the vector.
一個矢量自身相乘的標積等於該矢量大小的平方。 -
A vector quantity is an entity with a magnitude and a direction in space.
矢量是空間中既具有大小又具有方向的量。 -
A vector quantity is one whose direction as well as its magnitude is significant.
矢量是一個其方向和其大小同樣有意義的量。 -
A vector quantity whose magnitude is a body ' s speed and whose direction is the body ' s direction of motion
速度一種向量，其量值為物體的速率，其方向為物體運動的方向 -
And more aperture extension is achieved in this novel esprit - based two - dimensional angle estimatio n scheme using a uniform rectangular array of vector hydrophones spaced much farther apart than a half - wavelength. this proposed scheme and the attendant vector - hydrophone array outperform a uniform half - wavelength spaced pressure hydrophone array with the same aperture and slightly greater number of component hydrophones by an order of magnitude in estimation standard deviation
結合實際的應用情況，對矢量水聽器構成的陣列進行了初步的探討，利用本文前面部分所分析的基於單矢量水聽器的方法，實現了陣元間距突破半波長上限的局限，並解決了角度估計的循環模糊問題，以較小的硬體代價和運算代價實現陣列孔徑的擴展，提高估計精度。 -
The affection brought up by magnitude and phase in vector signal analysis
幅相特性對矢量信號分析性能影響 -
In the researches about hexagon track, smith triggers are used, so is flux self - control. as to round track, the method of voltage vector selection is taken. we can select the proper voltage vector by the position and magnitude of stator flux as well as the magnitude of torque
在六邊形磁鏈的研究中，本文主要是使用了施密特觸發器，通過磁鏈自控制單元來實現的；而對于圓形磁鏈的直接轉矩而言，則是利用了電壓矢量查表的方法，通過實時判斷磁鏈的區間和幅值、以及轉矩的大小，繼而從表格中選擇合適的電壓矢量。 -
The input and output state vectors are defined, which are a 6 1 column vector including motion types, the magnitude and spatial orientation, respectively. the state matrices ( sms ) can be deduced by vectors operation, that is, the output state vectors multiplied by the input state vectors
其中，前者按照輸入輸出端的不同運動類型、速度矢量的大小及方向特徵，以6維矢量形式表示；而後者作為輸入、輸出特徵矢量之間的紐帶，描述了基本變換單元的功能與特徵。 -
Sts produces substantially better visual results. sts is faster than lic ( linear integral convolution ) texture - based method. 2 ) in order to overcome the lic ' s shortcoming that only presents direction of the vector field, multi - granularity lic and image blend technique which can present the magnitude and direction at one time are proposed
2 ）提出了多粒度lic紋理和圖象混合技術，它們能很好地同時表示矢量的大小和方向，從而克服了lic紋理方法只能表示矢量方向而不能表示矢量大小的缺點。 -
The operating principles of svpwm and associated control algorithms are also covered in the paper. by using svpwm to control the magnitude and phase angles of the spatial voltage vector, the speed control of the drive system in this paper can reduce the output of current harmonics, lower the torque ripple, and improve the energy efficiency
本文還對svpwm的工作原理和控制演算法進行了研究，控制系統採用svpwm演算法，通過對空間電壓矢量的幅值和相位的控制來調節電機轉速，減少了逆變器輸出電流的諧波，降低了脈動轉矩，提高了電壓的利用率。 -
The contributions done are as follows : according to the mathematical model of doubly fed motor and the theory of vector control, a unit power factor of rotor control scheme is proposed. in the doubly fed adjustment system, in order to control magnetic torque of motor this scheme is designed by controlling the reverse direction between rotor voltage and current to keep the vertical direction between rotor current and flux. it is known from theoretical analysis that for partly decoupling this scheme is only effective under sub - synchronization speed, but not control the system and obtain steady state since speed adjustment system ca n ' t adjust the magnitude of rotor flux under sup - synchronization
而傳統的無速度傳感器雙饋調速矢量控制系統，由於採用磁鏈定向方法，在同步速附近存在較大的工作死區，針對上述問題，本文做了如下的研究工作：本文從雙饋電機的數學模型出發，根據矢量控制的基本原理，提出了一種轉子側功率因數為1的雙饋電機矢量控制方案的設想，即在雙饋調速時採用轉子電流定向的方法，並控制外加轉子電壓與轉子電流始終反相，以保持了轉子電流與轉子磁鏈矢量垂直，通過控制轉子電流的大小來達到控制電機電磁轉矩的要求。 -
In engineering, vector control ( vc ) is called as filed orientation control ( foc ). the principle of foc is to divide stator current into two dc components. one of them is oriented to the rotor magnetic flux, another is oriented to the torque. the operating process can be carried out by transforming coordinate in magnitude flux and torque keeping consistent conditions
矢量控制一般稱為磁場定向控制，該控制理論的原理是在轉子磁通和轉矩保持不變的情況下通過坐標變換將異步電機的定子電流分解為按轉子磁場定向的兩個分量分別進行控制，從而實現轉子磁通和轉矩的解耦。 -
In the paper, the principle and actualizing means of spatial vector control have been systemically discussed and the control software has also been designed. the magnitude of both the rotor flux and the current in torque component have been estimated by using a flux observer, which is developed based on field orientation control principle. the results show that the observer has a good feature due to its speed being calculated without speed sensor or additional hardware
本文對矢量控制的原理、控制方法以及控制實施策略進行了較為系統的分析與研究，利用速度間接觀測理論，建立了異步電機的磁通觀測器，電機的定子磁通和電流的轉矩分量可以通過磁通觀測器估算出來，從而得到電機的轉速，並由此建立了異步電機無速度傳感器矢量控制的理論數學模型和相應的控制演算法，在此基礎之上，利用工程中常用的電機專用dsp晶元tms320lf2407作為處理器，對異步電機進行變頻調速控制。 -
To solve the overflow or underflow of the components of appearance attributes caused by watermarking, we clip the error ones to the correct ranges by adjusting the corresponding basis function elements. the normalization operation would destroy the watermark embedded in the normal vector. the author presents a novel approach by rotating the normal vector around a fixed axis, which will modify its orientation, not magnitude
其中，針對在外觀屬性分量上植入水印的值溢出問題，作者提出了動態修改基函數的方法；考慮到直接修改法向量分量的方法會受到法向量單位化操作影響導致水印提取困難，作者提出一種繞固定軸旋轉法向量的方法，有效地避免了單位化對已植入水印信息的影響。 -
In the vector control, both the no - load thrust and the thrust with the different current are calculated, and the end effect influenced by the current magnitude is analyzed
在矢量控制運行下，分別計算了電機在空載時和在通以不同電流時的由端部效應引起的波動推力，並且分析了電流大小對端部效應的影響。
分享友人