viscosity density ratio 中文意思是什麼

viscosity density ratio 解釋
比密粘度
  • viscosity : n. 黏性；黏（滯）度；【物理學】黏滯性。
  • density : n. 1. 稠密；濃厚。2. 【物理學】濃度；密度；比重。3. 愚鈍，昏庸。
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. Viscosity density ratio, kinematic viscosity

    比例粘度
  2. The development of mass transfer in the system of vapor - liquid - liquid three - phase distillation from trays was introduced, the effects of the hydrodynamic conditions e. g. vapor velocity and ratio of liquid to vapor loading and physical properties of liquid phase, including surface tension, interfacial tension, viscosity or dispersion viscosity, density, relative volatility etc. and the volume ratio of oil to water on mass transfer were discussed systematically, the influence of the second liquid on mass transfer efficiency was also investigated, a gnat deal of viewpoints and suggestions having been put forward in this paper are significant important for optimizing design of distillation tower

    摘要介紹了氣液液三相精餾塔板傳質性能研究的進展情況，討論了氣速、液氣比等操作條件，表面張力、界面張力、液體的粘度或分散粘度、密度和相對揮發度等物系性質以及油水體積比等多種參數對傳質效率的影響，探討了第二液相的存在對傳質的影響，文中的許多觀點獲和建議對于優化精餾塔的設計具有重要的指導意義。
  3. Oil type 1, non - biodegraded oil, is characterized by low viscosity, low density, high content of saturated fraction, low content of resin and asphaltene and high ratio of isomerization of steranes

    第一類原油粘度和密度低，族組成以飽和烴組分為主，非烴和瀝青組分含量低，甾烷異構化指標高，未遭受生物降解。
  4. The oil of type 5 is the biodegraded one from the oil of type 3, and characterized by a density and viscosity similar to type 4. however, the isomerization ratio is lower in the type 5 than that in the type 4

    第五類原油是由第三類原油生物降解的產物，原油密度和粘度與第四類原油相近，但甾烷異構化指標相對較低。
  5. The position of the trajectory depends on the ratio of bead - to - fluid density, the ratio of bead - to - disc radius and the reynolds number which describes the operating conditions of the stirred media mill. by means of the beads motion in the calculation domain, the influence of different comminution operation parameters on comminution results is discussed. those parameters mainly include the beads size, beads density, stirrer angular speed and liquid density and viscosity etc. those parameters are optimized so that the comminution results are improved

    通過研究研磨介質在計算域內的運動來探索不同的粉磨技術參數對粉碎效果的影響，這些粉磨技術參數主要包括磨介尺寸、磨介密度、攪拌盤速度、液流密度及粘度等；通過優化這些參數來達到提高攪拌盤式攪拌磨粉磨效果的目的。
  6. Further more, its saturation oil - adsorbing capability ratio increases when it is used for adsorbing higher density and viscosity crude oil

    油品的密度和粘度越大，熔噴聚丙烯非織造布的飽和吸油率越大。
分享友人
分享到 Line

分享到臉書