voltage coil 中文意思是什麼

voltage coil 解釋
電壓線圈
  • voltage : n. 【電學】電壓,電壓量,伏特數。 the working voltage (電氣的)耐壓限度。
  • coil : vt vi 卷,盤繞,(把…)盤[卷]成一圈 (up)。n 1 (一)卷,(一)盤,(一)圈。2 螺旋管,蛇管。3 ...
  1. This testing system is designed according to the germany standard, to test many dynamic parameters in the moment of ignition time. such as the primary coil current, secondary coil current, high voltage and time signal

    本文研製的測試系統依照德國標準進行設計,實現對點火瞬間產生的初級與次級線圈電流、電壓及時間等動態參數的測試。
  2. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊,當開關管接收控制信號脈沖列(經調制的spwm波列)導通時,在低頻調制信號的正半周或負半周內,施加在變壓器繞組上的是同一方向的電壓,變壓器磁芯中的磁通可能將級進地逐漸增加,導致磁芯飽和,造成磁偏或單向磁化,導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  3. The operation principleresult of saving power , mate rial and reliability of ac and dc usual auto - converting saving power instrument are expounded, which the operation - coil of ac contactor given ac and dc voltage is usual, output is even dc, on and off and keeping voltage non - contactor auto - convert

    論述了與交流接觸器操作線圈適配的交直流輸入(操作)電壓通用、恆直流輸出、吸合與保持電壓無觸點自動轉換節電器的工作原理;接觸器配用節電器后的節能節材效果及節電器的可靠性。
  4. The fluctuating mangnetic field cutting across the turns or loops of wire of the secondary coil sets up an electrical pressure or voltage in these loops.

    起伏變化的磁場橫向切割著次極線圈的線匝和線環時,會在這些線環中引起電壓。
  5. The fluctuating magnetic field cutting across the turns of loops of wire of the secondary coil sets up an electrical pressure or voltage in these loops.

    起伏變化的磁場橫向切割著的次級線圈的線匝或線環時,會在這些線環中引起電壓。
  6. A new type of compound flyback converter is two flyback converters with only one transformer core and secondary coil. it completes changing voltage, isolation, and power transfer

    雙組合式單端反激變換器其實質為共用一個變壓器鐵芯和副邊的兩個單端反激變換器,由它完成對低頻電功率的變壓、隔離、傳遞功率的任務。
  7. According to the quickly adjustable characteristic of the peterson coil grounding system, this dissertation proposes a new control strategy. when the system is in operation, the strategy can limit the series resonance over - voltage by using the off - resonance method. when fault occurs, the strategy can conveniently suppressing arc by rapidly adjusting the inductance value of the peterson coil to the point, which the resonance with grounding capacitance of the power network is occurred

    依據可控硅控制消弧線圈接地系統的快速可控性,一改傳統的電網正常運行時調節消弧線圈接近於全補償的預調諧方法,提出正常運行時採用脫諧方法抑制串聯諧振過電壓;故障時立即調節消弧線圈電感量達到與對地電容諧振,以利熄弧的新型調節原理和方法。
  8. The key parts of barretter are made of irf840 field - effect transistor, the magnetic ring and high frequency choking coil which adopting negative temperature index. such components can provide barretters a wide applicable voltage 160v - 250v. low power consumption, minor temperature rise, stable functions, long life - span

    鎮流器核心元件採用irf840場效應三極體,磁環及高頻扼流圈採用負溫系數,這樣的元件選擇使整流器適用電壓范圍寬160v - 250v ,功耗低,溫升小,性能十分穩定,確保其擁有很長的壽命。
  9. The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability , insulation coordination , electromagnetic interference , but assault safety 。 in china , the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network , low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai , beijing , and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas , such as zhuhai , substations grounding with low resistance revealed some problems , including power supply reliability rapidly dropping , transmitting line often tripping ; and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance

    爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析,比較各方式的特點,然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型,在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下,對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算,其計算結果與電科院所作現場試驗進行了比較。
  10. The voltage ir on core adopts semienclosed insert model. the current element adopts two - stage compensation to have wide load property. the whole plasticenclosed voltage coil. can withstand instantaneous large voltage impulse. the double jewels bearing or the magnetic - propelled bearing can ensure long lifetime. the bipolar aluminium nickel cobalt damping magnet steels have high coercivity, stable magmetic property. the electric function is in accordance with iec521 international standard

    :電壓鐵芯採用半封閉插入式,電流元件採用二級補償使表計具有寬的負載特性。全塑封的電壓線圈能稱說瞬時大電壓沖擊。雙寶石軸承或磁推動軸承確保表計長壽命。
  11. The characteristics : the unit is composed of high voltage parallel capacitor, serial reactor, switch ( disconnector, grounding switch, breaker etc. ), lightning arrestor, fuse, discharging coil, current transformer, insulator, busbar and steel bracket, includes two kinds of structure : frame type and cabinet type

    產品特點:裝置由高壓並聯電容器、串聯電抗器、開關(隔離開關、接地開關、斷路器等) 、避雷器、熔斷器、放電線圈、電流互感器、絕緣子、母排和鋼架組成,裝置有框架和櫃式兩種結構。
  12. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流,兩者產生的偏置磁場在控制線圈產生感應信號,檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號,該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號,再由pid控制器轉換為轉子位移的控制信號,最後控制信號輸入功放電路產生控制電流,實現閉環控制。
  13. Among them insulated the insulation resistance testing instrument to adopt the high direct voltage testing method ; the ac insulate testing instrument adopt to the instrument of ac high voltage, and we also designed the protected circuit with excessive current ; the coil insulate testing instrument is adopt surge voltage impact testing method

    其中絕緣電阻測試儀採用了直流高電壓測試法;工頻耐壓測試儀採用高壓工頻測試,並設計了過流保護電路;匝間耐壓測試儀採用浪涌電壓測試法,並設計了多路可控硅控制脈沖輸出電路。
  14. All parts such as condenser, voltage stabilizing tank and cooling coil pipe which contact with alcohol equipments all adopts stainless steel material. distillation still adopts demountable u type heating pipe

    本裝置中凡接觸酒精設備部分如冷凝器穩壓罐冷卻蛇管等均採用不銹鋼,確保成品酒精不被污染。
  15. Dexterous control due to the low consumption & wide voltage range dc coil inside, while electronic thermal overload relay provides precise protection against all kinds of fault

    低功耗、寬電壓范圍接觸器線圈,寬范圍整定電流( 4倍)電子式熱繼電器,控制保護精準無誤;
  16. For the best tuning you need to add a 100 ohms resistor in series with the coil, so you will be able to measure the voltage and the current accross the coil

    為最佳調諧你需要添加一個100歐姆電阻串聯線圈的,那麼你將能夠測量電壓和電流線圈。
  17. Four methods have been taken to decrease the total heat quantity generated by the solenoid coil. the four methods are to reduce the duration of the high voltage, to reduce the amplitude of the high voltage, to reduce the duration of the control signal, and to reduce the amplitude of the low voltage. it was found that the four methods did have some effect on temperature

    研究發現,以減小電磁閥的總發熱量為目的而採用的縮短高電壓作用時間、降低電磁閥高低壓驅動的高電壓幅值、縮短控制信號持續時間和降低維持電壓的四種方法,對減小電磁閥的發熱都是有效的,但效果都不特別顯著。
  18. 2. after the electromagnetic coil has been vacuum and sealed in, then coverd the insulation shield, in order to increase heat conduction capacity and machinery strenth, conteol temperature rise and buzzer noise, and resist dampness and 8kv crest voltage thunder strucked

    2電磁線圈真空浸漆封閉后再套絕緣護套,即了熱傳導能和和機械強度,抑制了溫升和蜂鳴噪音,抗潮防濕,可抗擊8kv峰值的雷擊電壓。
  19. Most flashlamp applications use a trigger coil to produce high - voltage pulses of short duration, usually a few microseconds or less

    大多數閃光燈使用一個觸發線圈產生瞬間高壓脈沖!其持續時間只有幾微秒或更短
  20. A measure of the induced voltage in a circuit caused by a magnetic flux and equal to the flux times the number of turns in the coil that surrounds it

    碰撞,匝鏈電路中由於磁通量而造成電伏減少的單位,等於穿過一載流線圈的磁通量與線圈匝數之積
分享友人