voltage loop 中文意思是什麼

voltage loop 解釋
電壓波腹
  • voltage : n. 【電學】電壓，電壓量，伏特數。 the working voltage （電氣的）耐壓限度。
  • loop : n 1 （用線、帶等打成的）圈，環，匝，框，環孔，線圈；【醫學】（常 the loop）宮內避孕環。2 環狀物，...
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  2. Block diagram of voltage - type closed - loop control

    電?形閉
  3. The starting voltage of electroscopes, correct operation of electroscopes, roles of the starting voltage of electroscopes in production, and the difference between the all - loop self - inspection and the non - all - loop self - inspection are illuminated, as well as the relationship between the electroscope and the high voltage generator

    摘要闡述了驗電器起動電壓的原理、驗電器的正確操作、驗電器起動電壓在生產中的作用、全迴路自檢與非全迴路自檢的區別、驗電器與高壓發生器之間的關系。
  4. The pll consists of a crystal oscillator, a ring voltage - control - oscillator, a frequency divider, a phase / frequency detector, a charge pump and a loop filter

    設計的電路包括20mhz晶體振蕩器，鑒頻鑒相器，壓控振蕩器，固定分頻器，電荷泵和低通濾波器。
  5. Intelligent electricity quantity concentration display instrument is a kind of intelligent instrument used to measure combined parameter of ac electricity quantity, which can simultaneously measure each phase electricity parameter in the tri - phase ac loop such as voltage, current, active power, reactive power, apparent power, power factor, frequency, active kilowatt hour, reactive kilovolt ampere - hour and so on

    智能電量集中顯示儀是一種用於交流電量綜合參數測量的智能儀表，它可以同時測量三相交流迴路的每一相電壓電流有功功率無功功率視在功率功率因數頻率有功電度無功電度等參數。
  6. The same remarks for the ideal voltage source in nodal analysis apply to ideal current sources in loop analysis.

    關于節點分析法中理想電壓源的附註同樣可以應用到迴路分析法中出現理想電流源的情況。
  7. To comply with the low - power - consumption application, low - voltage design is taken into account by using some special circuit structures. besides there are many nonideal effects in pll which degrade the loop performance badly, some efficient solutions have been put forward to suppress the undesired ones

    此外論文還討論了若干制約環路性能的非理想效應，並在借鑒國外相關理論成果的基礎上，成功設計了克服這類效應的一些改進電路。
  8. In the positioning servo - system, which generally is configured by the d. c. pulse width modulator ( pwm ) velocity governing system and position servo - loop, the parameter perturbance of pwm velocity loop really exist by reason of such as the load behavior ; power voltage supply ; operating setting value, etc. 1, 2 ， and it cannot be ignored. by using the identification technique to form the mathematical model of the system, authors have confirmed the facts. therefore, to design the discrete sliding mode controller ( dsmc ) of the positioning servo - system, the perturbed parameters value bounds of the pwm velocity loop, which is as the controlled plant of position servo - loop, should be accounted. consequently, the design principle of dsmc for accounting system with parameter perturbance is proposed by the authors. the proposed method can ensure the stability of system with parameter perturbance and the behavior of non - overshoot, fast precise positioning. in order to reveal the effects of the design method, the comparative research work is done by the authors. also, it has been tested in an industrial experiment, the results proved it is satisfactory

    由直流脈寬調速系統（ pwm ）和位置環構成的定位系統中，速度環的參數隨負載特性；電網電壓；給定工況而攝動是不容忽視的.作者通過系統辨識建模也證實了這一事實1 ， 2 .因此在設計位置環的離散滑模控制時，必須針對速度環（即位置環的控制對象）的參數攝動范圍採用「對象參數攝動離散滑模控制器的設計方法」 ，以確保系統在參數攝動時的穩定性和快速、無超調、準確定位的優良動態品質.為剖析該設計方法的控制效果，本文作了對比性研究，並將該設計方法用於工業試驗中，取得了滿意的結果
  9. The design of rcd snubber and voltage feedback loop is introduced. finally, a 1kw prototype is researched and developed successfully to verify the operation principle of the combined converter

    該變換器中的開關管實現了在零電壓下關斷，而且其中兩個開關管在零電流零電壓下開通。
  10. For the purpose of boosting voltage, because of the effect of the load r on q, the proposed close - loop control method is the best choice to ensure the stable output voltage

    當利用諧振網路提升整機輸出電壓時，由於負載r對q值的影響，因此必須採用所提出的閉環控制方法才能保證良好的穩壓功能。
  11. Thirdly, the paper detailedly explained the whole system ’ s hardware structure based on dsp, and made the flow chart of the software which realized the pwm occur, the current control loop and the voltage loop

    然後給出了基於dsp的全數字式6kw三相應急電源的硬體實現方法，結合設計出來的硬體，編制了基本的dsp底層程序流程。在程序中實現模擬量采樣， pwm產生，電壓控制環和電流控制環等功能。
  12. The instantaneous voltage inner loop is used to control output voltage waveform to track a sinusoidal waveform. and the outer average voltage loop guarantees accuracy of output voltage

    電壓瞬時值內環保證輸出電壓波形的正弦度，平均值外環實現對輸出電壓幅值的控制。
  13. This dual - loop strategy is analysed completly and simulated. the implementation strategy is using digital and analogous hybrid control. the voltage loop is realized by dsp, and the inner - loop is realized by analogous circuit the design of cpld which simplified signal - phase cascade inverter circuit is also introduced in this paper

    根據控制方案設計了採用數模混合方案的控制電路，電壓外環採用dsp控制，實現輸出電壓有效值計算、 pi調解、輸出限幅等操作，電流內環採用模擬電路實現，並基於復雜可編程邏輯器件cpld設計了載波移相電路和死區產生電路，簡化控制電路。
  14. The asi parallel system in this thesis is presented based on common voltage loop control. the system is made up of five paralleled modules based on high - frequency zero - voltage - switch 1kva asi

    本文採用公用電壓外環方案，實現了五臺1kva基於高頻零電壓軟開關航空靜止變流器模塊的並聯輸出。
  15. In order to get good dynamic as well as static performance, multiple - loop control strategy with the instantaneous outer voltage loop and inner current loop is used in pfc converter based on dsp tms320lf2407a

    內環通過瞬時值控制獲得快速的動態性能，保證輸出畸變率較低，外環使用輸出電壓的瞬時值控制，具有較高的輸出精度。
  16. Each module is controlled by voltage - current two closed - loops. the common voltage loop controls system output voltage & frequency, and generates a common reference current signal

    每臺航空靜止變流器模塊均為電壓、電流雙環控制，通過公用電壓調節器穩定並聯系統的輸出電壓及頻率，同時產生統一的模塊電流給定信號。
  17. Because of high stability, the voltage loop gain is set high, so the static error is very small and dynamic performance is enhanced

    由於內環的高度穩定性，所以電壓環的增益可做得很高，使系統的靜態誤差非常小且動態性能得到了提高。
  18. For the direct current decouple controller, the p1 adjustor ? parameter of current and voltage loop ? is designed. the correction of the designed parameter is testified by simulating on two phase synchronization coordinate and three phase stationary coordinate, the simulation wave is given

    對直接電流解耦控制器的電流環和電壓環的pi調節器參數進行了設計，並通過在兩相同步坐標系與三相靜態坐標系的模擬驗證了設計參數的正確性，同時也驗證了直接電流解耦控制方案的可行性，給出了模擬波形。
  19. Arming at the shortages of traditional control mode, voltage loop control strategy is analyzed the simulation conclusion indicates that voltage compensation strategy, detecting method and control mode are correct and effective

    針對傳統開環控制方式的不足，分析了電壓環控制策略。模擬結果表明，本文採用的電壓補償策略、檢測方法和控制策略是正確、有效的。
  20. The working principle of buck - boost is first introduced, and averaging model of non - ideal buck - boost converter is established. the design details for voltage loop were given and zero - pole compensation method from classic control theory was applied to the filed of power electronics. thus, small - signal model of closed - loop was established, with detailed design guidelines for correction network

    本文介紹了buck - boost電路的工作原理，建立了非理想buck - boost平均法的模型，對整個電路進行了單電壓閉環參數設計的研究，實現了控制理論中零極點補償法在電力電子中的應用，建立了閉環小信號模型，總結了設計校正網路的步驟和具體方法。
分享友人
分享到 Line

分享到臉書