voltage standard 中文意思是什麼

voltage standard 解釋
標準電壓
  • voltage : n. 【電學】電壓，電壓量，伏特數。 the working voltage （電氣的）耐壓限度。
  • standard : n 1 標準，水準，規格，模範。2 旗；軍旗，隊旗；【徽章】標幟，標記；旗標，象徵。3 【植物；植物學】...
  1. When measuring the magneto performance parameter ， we find that the instrument which use to measure voltage and current is still the simple voltmeter and amperemeter in the national standard ， and the form of wave that we observed is anomaly. based on the measure principles, it obviously ca n ' t be used to do quantitative analysis ； because the discharge process of ignition system is quite complex, accompanies with very strong electromagnetism interference, and the ignition current and voltage are variable ， it make the measure of ignition energy become a difficult thing of ignition system performance detection

    在磁電機常規測量時，發現在國家標準中用於測量電壓、電流的儀器仍然是普通的電壓、電流表，而觀測到的波形多為不規則的形狀，根據測量原理，顯然不能用其來做定量的分析；由於點火系統的放電過程比較復雜，伴隨著很強的電磁干擾，點火電流、點火電壓都是變量，使得點火能量的測量成為點火系統性能測試的一個難點。
  2. The lightning impulse breakdown and steep - front impulse breakdown test of silicone rubber are also performed, which give a reference for other so lid materials. the result of this research also will give a reference to revises the standard of steep - front wave impulse voltage test

    為了配合本課題的研究還做了硅橡膠材料的雷電沖擊耐受強度和陡波沖擊耐受強度試驗，這兩個試驗對了解其它固體材料的雷電沖擊系數和伏秒特性也具有參考價值。
  3. Low - voltage switchgear and controlgear for industrial use. mounting rails. top hat rail 15 mm wide for the fixing of terminal blocks. european standard en 50 045

    工業低壓設備.支架型材.連接件固定用寬15mm端頭型材
  4. Low - voltage switchgear and controlgear for industrial use. mounting rails. top hat rails 75 mm wide for snap - on mounting of equipment. european standard en 50 023

    工業低壓開關和控制設備.支架型材.止動機構固定用寬度為mm的端頭型材
  5. Low - voltage switchgear and controlgear for industrial use. mounting rails. top hat rails 35 mm wide for snap - on mounting of equipment. european standard en 50 022

    工業低壓開關和控制設備.支架型材.止動機構固定用寬度為mm的端頭型材
  6. Luminaires that conform to the safety standard should bear proper markings of rated voltage, rated frequency, rated power, number and type of lamp bulbs, model number, mark of origin ( manufacturer nametrade mark ) and symbol for suitability or non - suitability for direct mounting on combustible surfaces where applicable

    符合安全標準的燈飾須有適當的標記，包括額定電壓、額定頻率、額定功率、燈泡的數目和類別、型號、原產地標志（製造商名稱或商標） 、是否適宜於直接安裝在可燃物質表面的標志等資料。
  7. Standard for safety for low - voltage fuses - part 11 : plug fuses

    低壓熔斷器安全標準.第11部分:插入式熔斷器
  8. This testing system is designed according to the germany standard, to test many dynamic parameters in the moment of ignition time. such as the primary coil current, secondary coil current, high voltage and time signal

    本文研製的測試系統依照德國標準進行設計，實現對點火瞬間產生的初級與次級線圈電流、電壓及時間等動態參數的測試。
  9. Research of standard time transmission in low voltage power net

    低壓電力網標準時間傳遞研究
  10. Standard test method for separating an ionizing radiation - induced mosfet threshold voltage shift into components due to oxide trapped holes and interface states using the subthreshold current - voltage characteristics

    利用亞閾值安伏特性測定由於氧化空穴和界面態產生的電離輻射感應金屬氧化物半導體場效應晶體管閾電壓偏移分量的標準試驗方法
  11. The design of voltage amplifier for dc ac standard supply

    交直流標準源電壓放大器的研製
  12. Volt ratio boxes rated up to 1000 v are usually calibrated at rated voltage against the laboratory s standard

    1000v或以下的直流分壓箱一般將按其額定電壓下與本所的標準電壓進行校正。
  13. Bolometric voltage standard

    熱輻射計電壓標準
  14. Further experiments of a 4k two - stage pulse tube cooler for operation of a josephson voltage standard

    液氦溫區脈管製冷機的優化實驗
  15. Voltage standard circuit

    電壓標準電路
  16. The superior voltage stability of such a josephson voltage standard has many applications in dc voltage metrology

    此約瑟夫森電壓標準傑出的電壓穩定性在直流電壓計量中可以有許多應用。
  17. This talk describes the working principle of the programmable josephson voltage standard ( pjvs ) and a few examples of its applications

    本文介紹此可程式控制的約瑟夫森電壓標準（ pjvs ）的工作原理和幾個應用範例。
  18. Development of 10 kv high accuracy dc high voltage standard p ower supply

    高精度直流高壓標準源的研製
  19. Due to there maybe being a series connect printer or other peripheral and protection locks behind the hardware lock, and the output voltage standard of printer port is 5v, if the components of a protection lock all use the power around 5v, it will cause difficulties usually when being used

    由於在硬體鎖後面有可能串接印表機，或是其它的保護鎖或外圍設備，而印表機埠的輸出電壓標準為5v ，如果保護鎖組成零件都是工作於5v的范圍，這樣將會經常造成使用上的困擾。
  20. Measurement of voltage and frequency of an ac voltage standard with single output

    測量一個單一輸出電壓的交流電壓標準的電壓及頻率。
分享友人
分享到 Line

分享到臉書