vulcanization rate 中文意思是什麼

vulcanization rate 解釋
硫化速率
  • vulcanization : n. 硫化(作用);(橡膠)硬化(作用)。
  • rate : n 1 比率,率;速度,進度;程度;(鐘的快慢)差率。2 價格;行市,行情;估價,評價;費,費用,運費...
  1. The experimental results further demonstrate that the combination of incompatibility polydimethylsiloxane and polyacrylate by co - vulcanization improves the both compatibility and broadens the low temperature and high temperature functional region. while in sin, to improve microphase structures and damping properties, the design to increase compatibility between two compositions and modulate crosslinking density as well as relative reaction rate of two compositions, is also effective

    以上實驗結果表明,在復合橡膠阻尼材料中將聚硅氧烷與聚丙烯酸酯通過共混硫化相結合,改進了二者的相容性,拓寬了其阻尼功能區的低溫和高溫溫域;而在sin中通過改善組四川大學博士學位論文分間相容性,調節交聯密度控制其微相結構和兩種組分相對反應速度的快慢,進而控制材料阻尼性能的設計是行之有效的。
  2. The development history of preparation technology of reactive extrusion dynamic vulcanization for thermoplastic dynamic vulcanizates was introduced, and reactive extrusion dynamic vulcanization technology, including its characteristics, preparation technology conditions, vulcanization rate and vulcanization process, was systematically discussed

    摘要介紹了制備熱塑性動態硫化膠的反應擠出動態硫化技術的發展歷史,系統論述了該技術的特點、工藝條件、硫化速率及硫化過程。
  3. The problem of the cure - rate incompatibility in dissimilar rubbers, including the selection of optimum vulcanization system, the modification of rubber, the use of dynamic vulcanization technology and the selection of optimum blending technique were reviewed with 25 references

    摘要硫化不相容性是橡膠共混中的重要問題,解決硫化不相容性的方法主要是:選擇合適的硫化體系,對橡膠進行化學改性,採用動態硫化技術和選擇合適的共混工藝。
  4. Through orthogonal experiment design, the preparation technology of reactive extrusion dynamic vulcanization for low hardness epdm / pp blend thermoplastic dynamic vulcanizates was studied, and the effects on micromorphology of extruded vulcanizates of such main technological factors as barrel temperature, feed screw driven voltage and host machine screw rotation rate were discussed

    摘要通過正交試驗設計,研究了低硬度epdm / pp共混型熱塑性動態硫化膠的反應擠出動態硫化制備工藝,初步探討了機筒溫度、喂料螺桿驅動電壓及主機螺桿轉速等主要工藝因素對擠出物微觀相態結構的影響。
分享友人