waste-heat boiler 中文意思是什麼

waste-heat boiler 解釋
廢熱鍋爐
  • waste : adj 1 荒蕪的，不毛的，荒廢了的；未開墾的；荒涼的。2 廢棄的，無用的；多餘的；身體內排泄的。vt 1 糟...
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • boiler : n. 1. 煮器（壺、鍋等）；熬煮東西的人。2. 汽鍋，鍋爐；〈美俚〉酒類干餾器。3. 〈俚語〉導彈。
  1. Practice proves that the shell residuum gasifier with a waste heat boiler based on the partial oxidation process can not only use residuum as its feedstock but also use asphalt, a feedstock of poorer quality, thereby opening up a new feedstock route for the shell gasification process

    實踐證明，謝爾渣油部分氧化工藝氣化爐帶廢鍋流程不但可以以渣油為原料，而且能夠以質量更差的瀝青為原料，為謝爾工藝制氣技術開辟了新的原料路線。
  2. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  3. Improvement of mechanical seal of hot water circulation pump for waste heat boiler

    廢熱鍋爐熱水循環泵機械密封的改造
  4. In this article, the cause of oxygen corrosion occurred at the water inlet in the waste heat boiler without the mea - sure of removing oxygen and the problem of water shock were dis - cussed

    本文對沒有除氧措施的余熱鍋爐氣包進水管發生的氧腐蝕及由此產生的氣包水沖擊問題進行了探討。
  5. The ideal operational value of waste - gas temperature is provided through combining the boiler ' s practical operation and the research of heat loss due to exhaust gas, which offers important theory and paves a solid way in optimizing boiler operation

    通過對排煙熱損失的研究，並結合鍋爐的實際運行情況，提出了排煙溫度的運行目標值，此目標值的確定對于鍋爐運行優化有著重要的理論基礎。
  6. Thermal test method for gas pass waste heat boiler

    煙道式余熱鍋爐熱工試驗方法
  7. The mode for designation of product model of gas pass waste heat boiler

    煙道式余熱鍋爐.產品型號編制方法
  8. Discussing about the vibration of steel chimney of circle waste heat boiler

    淺談聯合循環余熱鍋爐的鋼制煙囪的振動
  9. The three - wastes fluid - bed multifuel burner utilizes the characteristics of fluid - bed burning and the blow gas waste heat boiler for recovery, and burns the waste gas, ash and residue from the gasifier to produce hot flue gas, which, after dust settling in the multiple dust collector, enters the waste heat boiler to recover waste heat for the generation of high - grade steam to be used in production

    摘要三廢流化床混燃爐系運用流化床燃燒特點，採用吹風氣餘熱鍋爐回收模式，對造氣產生的廢渣、廢灰、廢氣混燃，產生熱煙氣，經組合式除塵器除塵后，進入餘熱鍋爐回收餘熱，生產高品質蒸汽供生產用。
  10. When underground water is used, there is no need to equip boiler, so there is neither cold or hot wind nor waste gas exhausted into the air and the heat - island domino offect of being hotter in summer and colder in winter in the city will not happen

    當採用地下水時，不用鍋爐，沒有冷熱風排到空氣中，不會產生廢氣，不會造成城市夏天更熱，冬天更冷的熱島效應，如果採用新冷媒，不會對臭氧層造成破壞，保護人類生存環境。
  11. Parameters of waste heat boiler. waste heat boiler after glass melting furnace

    余熱鍋爐參數系列.玻璃熔窯余熱鍋爐
  12. Further, waste heat recovery boiler and steam turbine are combined to improve system efficiency, resulting combined cycle generation. main characteristics of this technology are as follows

    為進一步提高系統效率，可利用氣化系統和內燃機產生的余熱，通過余熱鍋爐和蒸汽輪機實現聯合循環發電。
  13. This essay has touched upon the following work : 1. has built up theoretic models including static mathematic models of air compressor, combustion chamber, gas turbine, waste heat recovery boiler and steam turbine which are deduced according to the feature and theory of the equipment of the object of study. upon establishment of each model based on the actual conditions, a method of multiple imitation and combination is applied to parts which have already got characteristic curves to have achieved quite accurate curves whilst the method of neural net is applied to the parts which have no characteristic curves for establishment of models

    本文進行了以下的主要工作：建立理論模型，根據對象的實際設備的特點和理論關系推導壓氣機、燃燒室、燃氣輪機、余熱鍋爐、汽輪機的靜態數學模型；根據本研究的實際情況，在建立各部件模型時，對已有特性曲線的部件，採用多項式擬合的方法，得到較為準確的特性，而對部分沒有曲線的特性，則採用神經網路的方法建立模型。
  14. Calculating method and utilization guides for waste heat resource ' s quantity of industrial boiler ' s and flame heating furnace ' s waste gas

    工業鍋爐及火焰加熱爐煙氣余熱資源量計算方法與利用導則
  15. Parameters of waste heat boiler. waste heat boiler for sulphuric acid production based on pyrites

    余熱鍋爐參數系列.硫鐵礦制酸余熱鍋爐
  16. By introduction to structure analysis and design calculation of middle pressure tubular waste heat boiler with expansion joint, the author thinks rational selection to the standard and code of the boiler and vessel is the key to assure the product design and manufacture quality and guarantee personal safety without the special national standard " tubular waste heat boiler " now

    摘要通過介紹一臺6t / h 、帶膨脹節的中壓管殼式余熱鍋爐的結構分析和設計計算過程，認為在目前國內尚沒有專門的《管殼式余熱鍋爐》標準情況下，合理選用各受壓元件所對應的鍋爐、壓力容器標準規范，是確保該類產品設計製造質量和保障人身安全的關鍵。
  17. Development and application of heat - resistant heavy - duty special paint for purifying facilities of waste gas from coal - burning boiler

    燃煤鍋爐尾氣凈化設備耐高溫重防腐專用塗料的研製及應用
分享友人
分享到 Line

分享到臉書