water pressure test 中文意思是什麼

water pressure test 解釋
水壓試驗
  • water : n 1 水；雨水；露；〈常作 pl 〉 礦泉，溫泉；藥水。2 〈常 pl 〉水體；水域；水道；海；湖；河；海域；...
  • pressure : n 1 壓；按；擠；榨。2 【物理學】壓力，壓強；大氣壓力；電壓。3 精神壓力，政治[經濟、輿論等]壓力。4...
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. Code of water pressure test in borehole for water resources and hydropower engineering

    水利水電工程鉆孔壓水試驗規程
  2. Considering the similitude law for shaking table test, we study the test results and obtain some conclusions which are a ) generally, the silty soil in test box liquefies and the liquefied time has relation with the amplitude of acceleration, b ) when the intensity is on and above eight degree, the silty soil deposit will be liquefied dramatically, c ) the relationship of the pore water pressure is relevant to the cycle loading which represents when the cycle loading ranges from little to great, the relationship is represent as a concave curve, or else as a protruding curve and tends to stability. ( 3 ) based on the triaxial compression test and the resonant column test, some studies are made such as a ) the duncan - chang parameters of constitutive model, b ) the dynamic shear modulus ratio and c ) the damping ratio of the site soil deposits. in order to deal with the test data, a computer program is compiled

    （ 2 ）利用小型振動臺進行了k _ 0固結狀態下粉土的振動液化模擬研究，通過分析正弦荷載作用下的試驗資料，驗證了粉土的孔隙水壓力增長模式的合理性；從微分方程推導了基於土體振動臺模型試驗的相似律，並從模型實體、孔壓時程曲線和相似律等方面做出了分析，得出了如下結論：在小型振動臺試驗中，模型箱中的粉土都發生了液化，液化的時刻和輸入加速度幅值有關，而對頻率的變化不太敏感；粉土在相當於8 9度地震烈度的加速度幅值作用下可能產生嚴重的液化；孔壓的增長曲線形狀與施加的荷載有關：當施加荷載為由小到大的形式時，曲線形狀為上凹的曲線；當施加荷載為等幅的正弦荷載或荷載幅值由大到小時，曲線形狀為上凸的曲線，且逐漸趨于穩定。
  3. Based on the cause analysis for failure of water stop of tunnel ' s cast in site circular construction joint from theoretical and constructional point of view as well as the working mechanism of expansive water stop proposed in terms of width of construction joint, the relation between width of circular construction joint and water pressure resistance of water stop is established and its model test carried out

    首先從理論和施工角度分析了隧道現澆環向施工縫止水條的失效原因，然後從施工縫張開度的角度提出了膨脹止水條止水的原理，在此基礎上建立了施工縫張開度與止水條抗水壓力之間的關系，並進行了模型試驗。
  4. The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi

    得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 「角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器製造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86
  5. Hydraulic pressure test of long distance pressure water conveyance culvery junction

    長距離有壓輸水箱涵接頭水壓試驗
  6. Textiles. determination of resistance to water penetration. hydrostatic pressure test

    紡織品.耐滲水性的測定.液壓靜壓力試驗
  7. Based on the foundation " liquefaction test study on the rapid railroad bed " supported by the railway department, some works on the liquefaction of silty soils have been carried out. in this dissertation, after making a short review of the works on seismically induced soil liquefaction, some research results are presented, which include the following contents. ( 1 ) depending on the dynamic triaxial test, the liquefaction strength of the silty soils is studied and two new models are proposed to evaluate the pore water pressure and the strain of the saturated silty soils during earthquake

    結合鐵道部發展基金項目： 「高速鐵道液化土地基試驗測試研究」 ，本論文概括總結了地震液化的研究現狀，就滬蓉高速鐵路徐州段可液化場地粉土地基的液化特性問題開展了一些研究工作，內容如下： （ 1 ）提出了基於實用目的的粉土的孔隙水壓力增長模式和永久應變勢計算模型，並把此兩模型應用於場地的地震反應分析和地震液化性能的評價中；依靠循環振動三軸試驗技術，對粉土地基的地震液化強度進行了試驗研究；驗證了密實度是粉土液化的重要影響因素。
  8. Water pressure method is applicable for evaluating permeability of concrete. the test time needed is short, and operation and pretreatment is easy

    通過研究發現水壓法對于評價混凝土滲透性來有很好的適用性，而且試驗周期短，操作簡便，對試件的預處理簡單。
  9. Permeability of concrete and its correlation with chloride ion diffusion coefficient under different test conditions including water pressure method and tension method are studied

    本課題主要研究混凝土在水壓法及張力法試驗條件下水在混凝土中的滲透行為以及同氯離子擴散系數相關性。
  10. Pressure test of through out pigging : inspect pipe deformation and construction quality. exhaust before water pressure test, drainage before manufacture, dryness and medium isolation

    總通清管試壓：檢測管線變形、施工質量。水壓試驗前排氣、生產前排水、乾燥、介質隔離。
  11. Based on a thorough investigation of the engineering geological condition for the reservoir region of the huizhou pumped storage power station, the in - situ trial pit water injection test, boring water injection test, and water pressure test were performed to study the permeability of rock and soil mass

    摘要在對惠州抽水蓄能電站庫區工程地質條件進行詳細調查的基礎上，採用現場試坑注水和鉆孔注水、壓水試驗等方法了解巖土體的透水性。
  12. Determination of resistance of textile fabrics to water penetration ; hydrostatic pressure test iso 811 : 1981 ; german version en 20811 : 1992

    紡織品.耐水滲透性的測定.靜水壓試驗
  13. Standard test method for water penetration of metal roof panel systems by static water pressure head

    通過靜水壓頭測試金屬屋頂格間水滲透性的標準試驗方法
  14. Based on the results from both laboratory test and field application of vacuum preloading it can be concluded that soil is water - saturated in the processes of vacuum consolidation or vacuum preloading. thus, the consolidation properties in negative - pressure area cannot be calculated by using the theory based on non - saturation soil. negative pore - water pressure and suction were specified

    在室內試驗及現場試驗基礎上，證明真空預壓加固地基過程中，負壓區土體仍是飽和的，不能用非飽和土理論來計算負壓區的固結性狀，並辨析了負壓與吸力的概念。
  15. According to the selected project, a stability test with scale of 1 : 35 of cushion bottom had been done. with the research results of the experiments and the flow shape of xiao wan hydraulic power station were thought about, on the other hand, the ternary complex jet shape of baishan water cushion was analyzed, all this gave a base for the analysis of the force of the cushion bottom. through observation, the dynamic water pressure, the fluctuation pressure, the time - homogeneous pressure on the surface of the bottom and the characteristics of the fluctuation pressure could be got, also the calculation method and the test results were compared to get the argument

    針對選定的方案，進一步做了1 ： 35比尺的水墊塘底板穩定性試驗；通過試驗及借鑒小灣水墊塘內水流流態的研究成果，分析白山水墊塘內三元復雜淹沒射流流態，為水墊塘內底板受力分析打下基礎；通過觀測得到水墊塘底板動水沖擊壓力、脈動壓力、底板上下表面的時均壓力及脈動壓力特性，並通過計算方法與試驗成果進行相互比較論證。
  16. Considering that the load was added in steps, dynamic design based on in - sile test parameter is an effective and practical method. based on the author ' s experience of djm composite ground engineering, and two projects of highway djm composite ground, it systemically analyzed and summarized the in - site test result as well as the settlement deformation, pore water pressure dissipation, deep horizontal displacement, stress ratio, stress of pile. etc. it also compares the in - site test results of djm composite ground with or without rigid bearing stratum, and draws many practical conclusions

    根據筆者多年粉噴樁加固路基工程的經驗，結合兩個高等級道路粉噴樁加固路基工程實例，全面系統地分析和總結了現場試驗路段試驗結果，對攪拌樁復合地基沉降特性、孔壓消散特性、深層水平位移特性、樁土應力比、樁身應變等作了深入細致地分析，對有硬持力層和無硬持力層（浮樁）的粉噴樁復合地基現場試驗結果作了對比，得到了許多有應用價值的結論。
  17. Thermoplastics piping systems - end - load - bearing joints between small diameter pressure pipes and fittings - test method for leaktightness under internal water pressure, including end thrust

    熱塑管道系統.小直徑壓力管和配件間端部負荷軸承接頭.在包含端推力的內部水壓下密封性的試驗方法
  18. The experimental method of the model test with 1 : 6 scale based on the work mechanism of bearing of steel y - pipe strengthened inside with crescent rib in combination with surrounding rock mass simulated by composite materials is adopted and the regularity of their participant capacity to bear inner water pressure is analyzed in this paper

    摘要本文結合實際工程採用幾何比尺為1 : 6的物理模型試驗方法，用不同材料分層組合模擬圍巖，對水電站內加強月牙肋鋼岔管與圍巖聯合承載的工作機理、圍巖分擔內水壓力的規律進行分析。
  19. Packaging for the transport of liquids. light gauge metal packaging. metalic or plastic packaging. composite packaging water pressure test. procedure

    液體運輸包裝.輕型金屬包裝.金屬或塑料包裝.復合包裝水壓力試驗.程序
  20. What ' s to be done after water pressure test ? acid flushing or galvanizing

    壓力試驗通過了，把壓力放掉，拆開管子，檢查管子內部。
分享友人
分享到 Line

分享到臉書