winding test 中文意思是什麼
winding test
解釋
卷繞試驗-
Test methods for bare wires - mandrel winding test
裸電線試驗方法卷繞試驗 -
The experimental tests were conducted to obtain the probabilistic statistic distribution of design variables of cfrp wound pressure vessels ( such as elastic constants, strength of lamina, winding technology parameters and the geometric sizes ). and a goodness of fit test using the kolmogorov - smirnov method was used to get the best probabilistic distribution of design random variables
對cfrp纏繞壓力容器各重要設計變量(單向板彈性常數及其強度、壓力容器纏繞工藝參數及幾何尺寸)的隨機統計特徵進行了試驗研究,並根據kolmogorov - smirnov檢驗法,獲得各設計隨機變量的最優概率統計分佈。 -
Test method for interlaminar shear strength of ring of filament - winding reinforced plastics
纖維纏繞增強塑料環形試樣剪切試驗方法 -
Winding wires - test methods - part 5 : electrical properties
繞組線.試驗方法.第5部分:電特性 -
Each unit of transformer is tested in accordance with the following items : winding d. c resistance test. measurement of turn ratio and calibiation of voltage vector relation. measurement of impedance voltage and load loss
直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。 -
Test methods for winding wires - part 1 : general
繞組線試驗方法第1部分:一般規定 -
Winding wires. test methods. part 5 : electrical properties
繞組線.第5部分:電性能 -
Methods of test for winding wires - mechanical properties
繞組線試驗方法.機械性能 -
Winding wires - test methods - determination of dimensions
繞組線試驗方法.尺寸測定 -
Methods of test for winding wires - thermal properties
繞組線試驗方法.熱性能 -
Winding wires - test methods - part 1 : general
繞組線.試驗方法.第1部分:總則 -
An a. c. voltage of 2000 volts is applied between the winding and ground to test the integrity of the insulation between the winding and core iron
在線圈繞組和地線上加上2000伏交流電以測試線圈繞組和芯鐵之間的絕緣的整體性能。 -
Fibre - reinforced plastics - methods of producing test plates - filament winding
纖維增強塑料.試驗板的制備方法.長纖維纏繞 -
The damage parameter versus fatigue life figures, which were plotted based on the stress - strain analysis and test results, could be used to predict the fatigue lives of the composite with different winding angles
根據雙軸載荷條件下管狀試樣的應力-應變分析及雙軸疲勞實驗結果,繪制出了基於臨界平面的多軸損傷參量與疲勞壽命關系圖,可對不同纏繞角的復合材料疲勞壽命進行預測。 -
Test procedure for the determination of the temperature index of enamelled winding wires
測定漆包繞組線溫度指數的試驗規程 -
Test procedure for the determination of the temperature index of enamelled winding wires ; amendment 1
測定漆包繞組線溫度指數的試驗規程.修訂件1 -
Test procedure for the determination of the temperature index of enamelled winding wires ; amendment a1 iec 60172 : 1987 a1 : 1997 ; german version en 60172 : 1994 a1 : 1998
測定漆包繞組線溫度指數的試驗程序.修訂件a1 -
Test specification of the interture insulation on armature winding for dc machines
直流電機電樞繞組匝間絕緣試驗規范 -
Abstract : based on the classical theory, the harmonic winding potential of the tooth harmonic brushless exciting generator have been calculated and analysed. the results tally with the data of no - load test very well. it was demonstrated the designing thread of harmonic winding is correct
文摘:從經典理論出發,對齒諧波無刷勵磁發電機的諧波繞組電勢進行了分析計算,其結果與空載實驗得出的數據完全吻合.說明諧波繞組的設計思路是正確的 -
The thesis realizes the control exciting winding method and the best exciting in towards polarity method provided in this thesis with singlechip ( at90s8535 ) and scr hardware. it proves these methods are accurate and available through the control exciting winding test. analyzing the stator current and exciting current test curves on a salient - pole synchronous motor with 2kw - 4 poles, it solves the starting - difficulty of salient - pole synchronous motors, and improves motors " starting capability
通過在一臺2kw 、 4極凸極同步電動機上進行異步起動試驗和分析試驗過程中的勵磁繞組電流和定子繞組電流的波形,證明了本文提出的勵磁控制線路的正確性和可行性,較好地解決了凸極同步電動機起動難的問題,同時改善了電機的起動性能。
分享友人