working electrode 中文意思是什麼

working electrode 解釋
工詛極
  • working : adj 1 工作的，從事勞動的。2 操作的，作業的。3 工人的。4 （用於）實際工作的，任事的；使用（中）的...
  • electrode : n. 1. 電極。2. 電焊條。adj. -less 無電極的。
  1. Therefore, any changes in the cell are ascribable to the working electrode.

    因此，電池中的任何變化，都歸因於工作電極。
  2. If we can find a way to artificially enhance the adsorption of activated carbon, its benefits on economy and environment will be considerable. it is the aim of this work to investigate electrosorption of chloroform in water on granular activated carbon. the potentials on working electrode are controlled by potentiostat and the concentration of chloroform is measured by headspace gas chromatography

    實驗用恆電位儀作控制電源，調節工作電極電位（相對于參比電極電位）來控制加在活性炭上的電場，用頂空進樣法測定水中氯仿的剩餘濃度，參照方法與依據都是國家標準方法或國外先進方法。
  3. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  4. In addition, the biosensor could be used for the detection of benzoic acid. the choline oxidase electrode based on polyaniline / polyacrylonitrile composite film showed sensitive and stable bioelectrochemical response to choline, which was influenced by ph, working potential and temperature

    研究發現，基於聚苯胺/聚丙烯腈復合膜的膽堿氧化酶電極對膽堿具有靈敏和穩定的生物電化學響應，被測溶液的ph值、工作電位、使用溫度等對酶電極的響應有一定的影響。
  5. According to the working principle of thermo - electrode, we demonstrate the structure of enlarged reflection area and the structure of step broaden waveguide to improve the switch ' s performance and bring down the driving power. according to the fabricating condition of our lab, we proposed simple wet - etching method to fabricate the oversized waveguides and peeling - off method to fabricate the electrode

    針對全內反射和熱電極的作用特點，在全內反射型熱光開關的設計中提出了擴大反射區結構和漸變展寬結構，理論模擬和實驗結果表明該方法能有效地提高了開關性能，降低了驅動功率。
  6. Jingyijia was established in 1998, who is professional in manufaturing plastic mould, die - casting products. the workshop is more than 2000 cm2. the moulds was started to be exported to south asia and europe in 2001 using cnc milling machine, electrospark, wire - electrode cutting, etc. technique is unending while no the best in moulds. only by untiring working, reserching and improving, can we design good moulds. we welcome every old and new friend both at home and abroad to visit us and building business relationship

    廈門精藝佳公司成立於98年，百分百開發生產塑膠產品，壓鑄產品，製造各類塑膠壓鑄模具.模具廠使用面積兩千多平方米，多臺大型cnc銑床及電火花，線切割能加工製造， 3 . 5米以下各類模具. 2001年開始模具出口東南亞及歐洲.技術永無止境，模具永遠沒有第一，只有不懈努力，研發，改進才能設計好模具.我們真誠期望國內外朋友，同行蒞廈交流指導，為繁榮經濟推動民族工業科學進步和偉大復興作應有貢獻
  7. The latter electrode is made by a 3 - electrode system with cv voltage. in the system, ta foil is acted as the working electrode, a pt foil as the assistant electrode and ag / agcl electrode as the reference electrode. stuff rucl _ 3 ? nh _ 2o is confected into electrolyte. after electrolyzing with cv voltage, ru ion can deposit on ta foil in the fashion of hydrated ru compound

    在循環伏安法中，用原料水合三氯化釕配製成的電解液，將鉭片作工作電極、鉑片作輔助電極、銀/氯化銀電極作參比電極組成三電極系統，向電解池通入循環伏安的電壓進行電解，使釕離子以水合釕化物的形式沉積在鉭基體上。
  8. For the cathodic process it is likely that there exists a coupling between ni2 + discharge and hydrogen evolution. hydrogen evolution on working electrode should have masked the nickel ion reduction peak in lsv curve

    對于陰極過程，鎳離子放電和氫氣析出過程存在耦合，氫氣的析出可能掩蓋了線性電位掃描曲線上鎳還原的電流峰。
  9. The technology not only reduces working procedure but avoids conversion errors caused by making transition model, and can ensure edm performance of the obtained electrode using the combination of puls

    該工藝不僅減少了工序，還避免了因翻制過渡模型帶來的轉換誤差，將脈沖電鑄和電弧摘要噴塗紫銅背村相結合製造電極，能保證電極的電加工性能，可以實現高效率、高精度和低成本的快速模具製造。
  10. In addition, based on the analysis of the change of inter - electrode capacitances as changing working condition, a sub - circuit model for a power mosfet is developed and all model parameters can be easily extracted by data sheet. conducted emi includes two modes : differential - mode ( dm ) and common - mode ( cm )

    功率mosfet的開關動態特性主要受其極間非線性電容和外部工作條件的影響，在分析了功率mosfet在開關過程中各極間電容變化的基礎上，本文以小信號ldmos為內核，提出了子電路形式的功率mosfet高頻模型，所有的模型參數也都可以利用產品數據曲線獲得。
  11. The molten workpiece material can be ejected out from base body of workpiece with the aid of ultrasonic vibration and be removed / flushed out of the working gap without being reattached to the electrode

    電火花加工產生的熔融工件切屑，藉助超聲波振動從工件上彈出，從工作間隙輸送/沖刷出去，而不會附著在電極上
  12. Research on production of porous electrode sheet material by cold working

    直接冷壓法制備多孔電極極板材料研究
  13. Hybrid tongue is used in detection of heavy metal ions. a new electrode - - - - - - chalcogenide glass is used as working electrode. the data is analyzed by pca, bp and pls, and the results are compared

    混合電子舌應用在海水重金屬元素檢測，採用一種新的電極? ?硫屬玻璃電極作為工作電極來檢測海水重金屬元素，最後採用pca 、 bp演算法對結果進行分析比較。
  14. This paper was mainly designed to determine the nitric oxide in the medium of natural seawater. the following several aspects were carried through : ( i ) confirmed the determination method of nitric oxide in the medium of natural seawater - the electrochemical method ; ( 2 ) modified the working electrode by two methods, confirmed the best conditions of each method and compared the two modified methods through several aspects, also compared by the iso - nopmc microsensor. the main results were summarized as follows : 1

    本研究以天然海水介質中的一氧化氮為研究對象，主要進行了以下幾方面的工作： （ 1 ）確定了天然海水介質中一氧化氮的測定方法? ?電化學法，並對修飾電極進行了確定； （ 2 ）用兩種方法對工作電極進行修飾，對每一種修飾方法都確定了最佳實驗條件，從幾方面對這兩種修飾方法進行了比較，並且與iso - nopmcno微晶元傳感器進行了比較。
  15. 21a / w, and a1so get some other significative resul t. mair1 works and resu1t inc1ude : ( l ) by ana1yzing the the working pril1ci p1es of gan - - based msm ph ( ) to - detectors, we designed the two ki11ds of di fferent structure parameter of device. the electrode fingers are 2 p m wide, and l00 ll nl long, the gap.

    本文的主要工作和結果有： （ 1 ）通過對gan的msm結構探測器的工作原理的分析，我們設計了兩種尺寸的器件結構參數，確定了器件的金屬電極條寬為2 m ，長為100 m ，電極間距分別為6 m 、 10 m兩種，器件有效面積分別為104 m 155 m 、 150 m 155 m 。
  16. After studying the precision of fdm process, a rapid edm electrode fabrication technology based on fdm is developed, the technology, which combined pulse - reverse electroforming with strengthening of copper wire - arc spraying, can obtained compact crystal electrode ' s working part, and strengthened filling part which has big adhesion strength, better electricity and heat conductivity, the edm performance of the obtained electrode reaches that of electrolysis copper electrode

    繼fdm工藝精度研究后，開展了快速模具製造技術的研究，建立了基於fdm原型快速製造電加工電極的工藝。該工藝將脈沖電鑄和電弧噴塗紫銅背襯相結合，獲得了結晶緻密的電極工作層和結合強度高、導電與導熱性良好的電極背襯層，得到的電極達到了常規機加工紫銅電極的電加工性能。
  17. Time setting function for electrode and working material to prevent carbon accumulated and electrode consumed

    電極與工作物放電時之時間設定功能，可防積碳及防電極損耗。
  18. Standard test method for determining plutonium by controlled - potential coulometry in h 2so4 at a platinum working electrode

    用控制電位庫侖計法在鉑工作電極上測定硫酸中鈈的標準試驗方法
  19. In spite of its great advance, this method is a one - dimensional method working on single electrode site. it did n ' t take the correlativity between electrodes into account. in this case, spatial topography could only be pictured through manual combination of electrodes, but not topography of statistical spatial component

    然而該法在空間維度上只取了單個電極位置，沒有考慮不同電極數據間的相關關系，得到的空間拓撲只是單個電極的手工組合，並非統計分析得到的空間成分之拓撲。
分享友人
分享到 Line

分享到臉書