working load limit 中文意思是什麼

working load limit 解釋
極限工咨載
  • working : adj 1 工作的，從事勞動的。2 操作的，作業的。3 工人的。4 （用於）實際工作的，任事的；使用（中）的...
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  • limit : n. 1. 界限，界線；邊界。2. 極限，限度；限制。3. 〈pl. 〉范圍，范域。4. 限價；限額；賭注限額；獵物限額。vt. 1. 限制，限定。2. 減少。adj. -able
  1. In order to deal with it, the concept of limit load under steady working conditions is put forward. it is a feasible alternative method

    本文提出了串並聯逆變器穩態運行重載極限的概念，它是研究啟動極限工況的一種替代方法。
  2. 3 > the power - load matching control of pump and diesel is also investigated in this paper, which includes economic working control and load limit control of diesel

    3 、對液壓泵與柴油機之間的功率匹配控制進行了研究，其中包括柴油機經濟工作點的控制和防止柴油機過載的全程極限負荷控制。
  3. The change of residual contact pressure of bimetal composite pipe under the action of heat load in this article, the possibility of separation between two metal layers in temperature cycle was researched ; it has been shown that under heat loading condition, it has a limit working temperature

    摘要分析了在熱載荷作用下雙金屬復合鋼管結合強度的變化，研究了經歷溫度循環后內外層管之間出現松脫的可能性。
  4. Secondly, through the examination and observation of the structural model of the cast - in - place pre - stressed compound floor slab system, under the normal usage load, the normal usage limit - state and the failing load, we have validated the space working - feature of the structural model under variable loads, including the rigidity, the crack, failing - state, failing load and the stress variation of the pre - stressed bar, and so on

    其次，通過對該體系的結構模型在正常使用荷載、正常使用極限狀態和破壞狀態下的試驗研究，驗證了現澆預應力復合樓蓋體系模型結構在各種荷載作用下的空間工作性能，包括剛度、裂縫、破壞形態、極限承載力及預應力筋的應力變化狀態等。
  5. Bearing capacity and displacement are two main problems in the application of geotechnical engineering. based on a series of pull - out tests using three kinds of paper and a sort of window screening as geogrid, twenty - seven in limit and several in working - stress geogrid - reinforced slope model tests designed through orthogonal principle have been conducted to have obtained the relationship between the bearing capacity and four factors ( i. e. reinforcement, angle of reinforced slope, the designed - length of reinforcement and the distance between layers of reinforcement ). the law of slope lateral ( horizontal ) displacement versus to the height of slope vary with external - load was derived from the model test data, and the main factor affecting the lateral and vertical displacement of geogrid - reinforced slope was obtained through analysis

    承載力（強度）和變形是巖土工程應用領域的兩大主要問題，本文以紙和窗紗布模擬加筋土邊坡的土工格柵，在一系列拉拔試驗的基礎上，以正交設計理論分別安排27個極限應力狀態和若干個工作應力狀態加筋土邊坡模型試驗，並以模型試驗獲得的數據為依據，採用誤差、極差及回歸分析方法，探討了加筋土邊坡承載力與筋類、筋長、層間距、坡角4因素的相關關系，獲得了在外荷載作用下加筋土邊坡的側向位移隨坡高的變化規律（並進行了定性解釋）和坡頂的豎向位移特性，並分析其主要控制因素。
  6. The product of working speed and radial load should not excess the limited value on the list, which determins the limit of application

    工作中實際轉速和徑向載荷的乘積不可超過表中極限值，它確定了應用的極限
分享友人
分享到 Line

分享到臉書