亮度基本量 的英文怎麼說
中文拼音 [liàngdùjīběnliáng]
亮度基本量
英文
luminance primary-
The ten - wavelength pyrometer is developed for the demand of china jiliang university. the mathematical model is based on brightness temperature. the data is processed with least square fitting and the software is programmed with vc + +
本課題是應中國計量學院要求設計的一臺十波長高溫計，採用的是基於亮度溫度的數學模型，數據處理採用最小二乘擬合方法，軟體採用vc + +編寫。Compared with different inducing methods by lots of experiments, a simple and effective inducing method is confirmed, the opimal technological conditions and formula about the soluton of electroless deposition ni - p alloy are also obtaned. the influence of different technological parameters on the deposition rate is studied. analyzed the pefformance of ni - p alloy on the differen substfates and its corresponding tricture, the result is shown tha the electroless plating nickel process can obtained the ni - p alloy film having brightuess - integrity sdse, strong binding energy and high rigidity at the temperatur about 350wt00oc, the electroless plating nickel film would trallsform from amorphous to crystal state
本文通過大量實驗，對幾種誘發材料與過程進行分析，研究確定了簡便有效的誘發方法，以及與之相匹配的化學鍍ni - p合金溶液優化配方和工藝條件，討論了各工藝參數對鍍速的影響，並對銅及黃銅基體上得到的ni - p沉積層進行了性能和結構分析，得到外觀光亮完整、結合力強、硬度高的鍍層。To improve the measuring precision of true temperature and spectral emissivity, the dissertation brings forth the new ideas and work as follows : ( 1 ) a brightness temperature approach is proposed and used for the measurement of the true temperature and spectral emissivity
為了提高目標真溫和光譜發射率的測量精度，本課題主要研究工作如下: （ 1 ）提出了基於亮度溫度模型的亮溫逼近法的多光譜數據處理方法，以求取目標真溫及光譜發射率。For being with many advantages, it has been an active subject in recent years and much progress has been made. on the basic of analysis of many kinds of led structures, a new kind of strained layer structure has been introduced into our designed hb - led which has been manufactured in our laboratory to demonstrate a even higher efficient light emission. through calculation of led external quantum efficiency, a method for design hb - led top layer was evaluated
本論文分析了當前國內外各種led的結構及其製作工藝，在技術上較為成熟的雙異質結構基礎上，我們在器件的有源區引入應變多量子阱結構，並根據實際需求增加補償應變技術以保證發光層結構的穩定性；通過對器件外量子效率的計算，使得在器件設計有了定量的理論分析依據；並採用先進的渦輪lp - mocvd成功制備出galnp gaalinp應變多量子阱高亮度發光二極體器件。分享友人