低阻抗輸入 的英文怎麼說

中文拼音 [kàngshū]
低阻抗輸入 英文
low impedance load
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : Ⅰ動詞1 (抵抗; 抵擋) resist; combat; fight 2 (拒絕; 抗拒) refuse; defy 3 (對等) contend with...
  • : Ⅰ動詞1 (運輸; 運送) transport; convey 2 [書面語] (捐獻) contribute money; donate 3 (失敗) l...
  • : Ⅰ動詞1 (進來或進去) enter 2 (參加) join; be admitted into; become a member of 3 (合乎) conf...
  • 阻抗 : [電學] impedance
  • 輸入 : 1 (從外部送到內部) import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  1. We have designed different measurement instruments according to the methods. the instrument used to measure electrode is a high precision multi - channel system constructed with a iaadc as the core and high input impedance amplifier and low input current multiplexer

    對于硫屬玻璃電極,我們設計了以高精度的adc為核心,配以高噪聲的前置放大器和漏電流多路模擬開關的多路精密電極測量系統。
  2. Jedec ? an input voltage in a region of relatively low differential resistance that serves to limit the voltage swing

    用於限制電壓擺幅的相對的不同范圍的電壓。
  3. This is a low impedance discrete level control which sits between the preamp active circuitry and the input to your power amplifier

    這是一個位於前級有源電路和后級放大器端之間的的音量控制。
  4. If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency

    負載端電及電源電均高於傳線特性情況下,當線長為某頻率波長之半波,則端與負載端電壓在該頻率均為最高,在該頻率之半時則電壓均為最
  5. If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency

    負載端電於傳線特性及電源電高於傳線特性情況下,當線長為某頻率波長之半波,則端與負載端電壓在該頻率均為最,在該頻率之半時則電壓均為最高。
  6. Main research result : 1. to succeed in researching miniature pressure modulator, realizes integretion of electropneumatic conversion, high importation resistance, low power consumption, bear vibration and miniaturization by making use of physics / electricity characteristic design of piezo ceramics ; 2

    主要研究結果: 1 、利用壓電陶瓷的物理/電氣特性設計研究成功了微型壓力調節器,實現了電氣轉換、高功耗、耐振動和微型化的統一。
  7. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點:電路結構簡單;製造工藝與普通cmos工藝兼容:短溝道,高寬長比的nmos晶體管具有的通導電,將其作為加權、出器件可降由電路引起的插損耗;改變加權信號,可實現權值在較大范圍內的連續變化;頻(如50mhz )下接近50 ,而在高頻下略有偏離50 ,但反射系數均於0 . 1 ;實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
  8. While low voltage and low power is realized when designing the operational amplifier in this text, great efforts have been devoted to increasing the input common mode range and the swing of output signal, and lowing the output resistance at the same time

    只是實現功耗而不實現良好的性能顯然是錯誤的。本文在設計實現功耗的運算放大器的同時,也想法提高共模範圍和出信號的幅度,同時降
  9. A new similarity method in fem is presented for researching of the problems about the nonuniform and irregular region, such as micromachined microwave coplanar waveguide. by using this method, we calculate the characteristic impedances of mems waveguide and analyse the change with its different dimensions. with the use of a recurrence relation, this new method not only use much less computer ' s memory than the conventional fem, but also simplify the post - process

    硅襯底上實現v型槽mems共平面波導進行了詳細深的研究,提出並採用混合相似剖分有限元方法對不規則結構傳線的特性進行數值分析,在驗證了方法的正確性基礎上,進行了大量計算,並總結了常用50 、 120等線的結構參數。
  10. The condition that exists when two coupled circuits are adijusted so that the outp - ut impedance of one circuit equals the input impedance of the other circit connec - ted to the first, there is a minimum power loss between two circuits

    指一個存在的條件,當調整兩個偶合電路使得其中一電路的與另一電路的相等進稱之,當他們連接的相等時,兩電路間的能量損失最
分享友人