低阻濾波器 的英文怎麼說

中文拼音 [dīzǔlǜbōqì]
低阻濾波器 英文
low cut filter
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 濾 : 動詞（除去液體雜質） filter; strain
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 濾波器 : [電子學] electric filter; （electric） wave filter; filter
  1. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  2. Compare to the normal rectangular waveguide, ridge waveguide has the character of broader bandwidth, smaller dimension, lower equivalent characteristic impedance, etc. because of these merits, it is used more and more widely, such as broadband ridge waveguide filter, broadband direct coupler, diplexer, frequency converter, phase shifter, ridge waveguide slot antenna array, and so on

    與普通矩形波導相比，脊波導具有工作頻帶寬、尺寸小、等效特性阻抗低等特點。由於脊波導本身的特點，使其得到了越來越多的應用，例如寬帶脊波導濾波器、寬帶定向耦合器、雙工器、變頻器、移相器、脊波導縫隙天線陣等等。
  3. To analyze some key technologies of optical network relative with rwa in detail, such as transmission, switching and internetworking ; to emphasize on the research of function, fabric and performance of optical cross - connection ; to carry out numerical simulations for crosstalk introduced by optical cross connect and to present measurements for suppressing it such as doubly filtering, fixing optimum decision threshold and appropriately choosing the number of multiplexed wavelengths ; 3. to research the fundamental principle and some problems relative with rwa, including the type of optical network, the type of traffic, the type of service, the survivability of optical network ; to classify and compare rwa algorithms and particularly research some dynamic rwa algorithms ; 4. to present reserved light - path and classify network resource such as used, unused and reserved status, to emulate establishment of all - optical connection in optical network through modified rwa algorithm and show effectively reducing setup time of all - optical connection utilizing reserved light - path ; to research rwa algorithms of multi - fiber network, to present new link weight functions dependent on node degree, unused fiber ( s ) per wavelength - layer and routing policies, to perform emulation of rwa based wavelength layer graph applying new link weight functions and show them make algorithms better performance and network lower blocking rate ; 5

    詳細分析了與rwa相關的光網路關鍵技術，包括傳輸、交換、組網等，重點研究了光交叉連接的功能和結構、性能，對其引入的串擾進行了詳細分析，選擇恰當的器件參數進行了數值模擬，並提出了抑制措施（如雙重濾波、優化判決門限、選擇恰當的復用波長數） ; 3 .研究了光網路的r認叭的基本原理、與r認叭的幾個相關問題（光網路類型、業務類型、流量類型、光網路生存性） 、 r認人演算法的分類和比較，具體研究了幾種動態r場人演算法; 4 .研究了以全光連接建立時間為優化目標的r認認演算法，提出預置光路的概念，對網路資源進行狀態分類（佔用、未佔用、預置） ，利用改進的r認叭演算法模擬，預置光路可為部分新到的連接請求快速建立連接，從而提高網路性能;研究了以多光纖網路連接阻塞率為優化目標的r認城演算法，提出了以節點度數、每個波長分層的空閑光纖數以及路由策略決定的幾種鏈路權重函數，利用基於波長分層圖模型的并行r場人演算法模擬，利用新的鏈路權重函數使得演算法具有更優的性能，使網路具有更低的連接阻塞率。
  4. Using piezoresistive accelerometers and magnetoresistance sensors measure the dynamic acceleration and geomagnetic field and through avr mcu software to calculate the attitude angular and azimuth. the fact of affecting the module is discussed in detail in this report and put forward the resolving scheme of key technology of digital filter, linear compensation, temperature compensation and magnetic field adjustment. the digital module has advantages of small size, light weight, low conception, high accuracy, all solid state and high reliability

    本課題採用壓阻式加速度計和磁阻傳感器分別測量重力加速度和地磁場，通過avrmcu軟體解算出姿態角和方位角，課題詳細分析了影響模塊性能指標的因素，就數字濾波、線性補償、溫度補償、磁場修正等關鍵的技術問題提出了可行的解決方案，研製的數字化模塊具有體積小、重量輕、低功耗、精度高、全固態、高可靠等特點，所有性能指標均滿足設計要求，為姿態角測量提供了有效的手段。
  5. We analyzed the anti - jam and band inside anti - interfere performance of the system, and the low probability intercept ( lpi ) of the traditional direct sequence spread spectrum ( dsss ) modulations in the uav platform ' s applications. so a new modulation technique using a multi - level pseudo noise ( pn ) code has been presented. the new multi - level pn code is built from a high speed pn code through a low passed filter ( lpf )

    分析了系統抗阻塞式干擾和抗帶內頻帶干擾的性能，以及常規bpsk qpsk - dsss調制在無人機通信中存在的安全隱患，提出了一種用多電平pn碼進行擴頻調制的方法：採用高速pn碼，經過低通濾波器，產生多電平pn碼進行直序擴頻調制，能在低信噪比情況下有效抵抗平方率檢測器對系統載波的檢測。
  6. Moreover, a spindly shaped damping zone is designed to improve the absorption capability of conditional damping zone, which has the function of two directional wave absorption and low - pass filtering

    其中對阻尼消波技術作了改進，設計了一種紡錘形的阻尼消波器使其具有雙向消波功能和低通濾波功能。
  7. The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load

    本文在場效應管fet柵極上加上諧振網路（諧振網路是通過cst模擬得到的，它是串聯反饋迴路，介質工作在te01模，對于其後的fet ，它又相當於一個帶阻濾波器） ，然後設計輸入輸出匹配電路，使電路結構滿足起振條件，之後繼續用諧波平衡法模擬和優化，使振蕩器輸出功率合適，相位噪聲很低。
  8. By analyzing the refraction 、 reflection process of fault transient current traveling wave of high voltage and characteristics of refraction 、 reflection coefficient systematically, a new fault location method of single ended traveling wave is presented. it can not only identify the reflection wave for fault location efficiently, but also not be affected by the structure and length of line. fault earthed resistance 、 fault type 、 system impedance and can locate fault in adjacent areas accurately

    論文深入地分析了高壓線路故障暫態電流行波的波折、反射過程以及折、反射系數的特點，提出了新的單端行波故障測距方法，它不僅能夠有效地識別出測距所用的反射波，而且幾乎不受線路結構、長短、故障接地電阻、故障類型、系統阻抗的影響，在近區仍可以準確地進行測距；同時模擬阻波器的特徵，設計了低通數字濾波器，對通過了低通數字濾波器的暫態故障電流行波再次進行小波分析，並利用本文提出的單端行波故障測距方法進行故障定位，結論是所提出的測距方法在實際應用中仍是有效的。
  9. The complete design uses the given functions and releases the low - pass, high - pass, band - pass and the band - stop filters directly. butterworth, chebyshev and caoer filters are used for the implementations. in the fir filter designs, chebyshev and hamming windows are used for a band - pass filter

    完全設計方法中我們利用函數直接設計出低通、高通、帶通和帶阻濾波器，並分別用巴特沃斯（ butterworth ）濾波器、切比雪夫（ chebyshev ）濾波器、橢圓（ cauer ）濾波器來實現，並比較了各自的頻率響應曲線。
  10. In the fifth chapter, a new fully differential operational amplifier with voltage and current - mode negative feedback has been proposed, which can stabilize its quiescent operation point, using the characteristic of mos transistors which operate in the triode region acting as active variable resistor, a fully differential fourth - order chebyshev low - pass filter with tunable frequency and bessel low - pass filter with accurate group delay based on r - mosfet - c and operational amplifier has been designed

    第五章：提出了一種新的既具有電壓共模負反饋又同時具有電流共模負反饋的全差分運算放大器電路，能較好地穩定電路的靜態工作點，並應用mos管工作在線性區可作有源可變電阻用的特性設計得到了截止頻率可連續調節的高性能r - mosfet - c 、運放結構切比雪夫（ chebyshev ）和精確群時延值貝塞爾（ bessel ）低通濾波器。
  11. Signalling on low - voltage electrical installations in the frequency range 3 khz to 148. 5 khz - low voltage decoupling filters - impedance filter

    頻率范圍為3khz至148 . 5khz的低壓電氣設備的信號傳輸.低壓去耦濾波器.阻抗濾波器
  12. Signalling on low voltage electrical installations in the frequency range 3 khz to 148, 5 khz - part 4 - 4 : low voltage decoupling filter - impedance filter

    頻率范圍為3khz至148 . 5khz的低壓電氣設備的信號傳輸.第4 - 4部分:低壓去耦濾波器.阻抗濾波器
  13. The typical design gets the technical parameters from digital filters that should be designed, and then transformed into the analog parameters of a low - pass analog filter prototype. the prototype is converted into the analog low - pass, high - pass, band - pass and the band - stop filters respectively, which are transformed into the digital ones

    典型設計是先按一定規則將給出的數字濾波器的技術指標轉換成模擬低通濾波器的技術指標，據此產生模擬濾波器原型，然後把模擬低通濾波器原型轉換成模擬低通、高通、帶通、帶阻濾波器，最後再把模擬濾波器轉換成數字濾波器。
  14. A frequency selective surface ( fss ) is a metallic periodic structure with frequency selective properties. depending upon design, it may be low - pass, high - pass, band - pass, band - stop filter

    頻率選擇表面（ fss ）是具有選擇頻率功能的一塊金屬周期結構，它可以被設計成低通、高通、帶通、帶阻濾波器。
分享友人
分享到 Line

分享到臉書