倍增器輸出 的英文怎麼說

中文拼音 [bèizēngshūchū]
倍增器輸出 英文
multiplier output
  • : Ⅰ名詞(跟原數相同的量) times Ⅱ形容詞(加倍) double; twice as much
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : Ⅰ動詞1 (運輸; 運送) transport; convey 2 [書面語] (捐獻) contribute money; donate 3 (失敗) l...
  • 輸出 : 1 (從內部送到外部) export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd : yag激光的發展狀況、主要特性及其應用,從四能級速率方程發,推導了ld泵浦nd : yag激光的閾值、功率和斜效率的表達式,並簡述了激光的工作原理、結構型式和頻方法;其次,以空間相關的速率方程為基礎,提了ld端面泵浦nd : yag激光的設計方法,給了一定泵浦耦合方式下,振蕩光模尺寸、最佳耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據,以此為依據,設計了自聚焦透鏡耦合小功率ld泵浦nd : yag激光和透鏡組耦合高功率ld泵浦nd : yag激光,對激光功率和功率穩定性等特性進行了實驗研究;再次,在帶尾纖的高功率ld泵浦nd : yag激光腔內插入一隻空液晶盒,觀察到了激光以單縱模運轉;最後,根據泵浦光焦斑端面位置對激光功率的影響規律,提了ld端面泵浦nd : yag激光位移傳感新方法,並進行了理論和實驗研究,研究結果表明:當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時,激光功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律,測量范圍和靈敏度依賴于泵浦功率,隨著泵浦功率的加,測量范圍擴大,靈敏度提高,當端面泵浦功率為7 . 24w (最大功率為1 . 926w )時,激光位移傳感的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  2. One forward optical receiver module takes one slot, after power double - amplification inside, send out 1 way rf signal 104dbuv and 1 way level checking signal, or two - distribution output

    一個正向光接收模塊佔一個槽位,內置功率放大,1路射頻信號104dbuv和1路電平檢測口,或二分配
  3. In electronic detectors such as photomultipliers and television tubes, noise manifests itself as random fluctuations in the output current.

    對于光電管,電視攝像管之類的電子探測,噪聲則表現為電流的隨機起伏。
  4. A novel parallel - serial type cttfc ( combined two - transistor forward converter ) with coupled inductor is present in this paper, and the performance of three parallel - serial type cttfcs is studied and compared. the performance of cttfc with coupled inductor is similar to the other two cttfcs while coupling coefficient is less than one and the converter working ccm ( continuous current mode ), and input - to - output voltage gain increase one times while coupling coefficient is one

    本文提了一種耦合電感並?串型雙管正激組合變換,並對三種並?串型組合變換的特性作了比較:耦合系數小於1且耦合線圈電流連續時,三種並?串型組合變換特性相類似:耦合系數為1時,組合變換電壓大一
  5. With the theoretical and experimental methods, the characters of cr4 + : yag are studied from cr4 + : yag as passive q - switching in nd : yag laser, intracavity frequency - doubling of q - switching laser and dual - wavelength laser, which is based on cr4 + : yag ' s operations of saturable absorption and laser gaining medium. chapter 1 : introducing the cr4 + : yag ' s optical function, the general research situation and the main idea of this thesis

    本論文基於cr ~ ( 4 + ) yag晶體既可以作為nd yag激光的被動調q開關、又可以作為激光益介質的特點,採用理論和實驗相結合的研究方法,詳細而具體的研究了cr ~ ( 4 + ) yag晶體被動調q 、調q頻和雙波長激光的特性。
  6. The common detector output pulse signal scope is several dozens millivolts, but the multichannel pulse analyzer input pulse amplitude request is 1 - 15v, therefore the pulse linear amplifier must have the certain voltage gain, about ten times to several times

    一般探測脈沖信號幅度為幾十毫伏,而多道脈沖幅度分析入脈沖幅度要求為1 - 10v ,所以脈沖線性放大必須具有一定的電壓放大益,為數到上百
分享友人