偏轉鏡 的英文怎麼說

中文拼音 [piānzhuǎnjìng]
偏轉鏡 英文
deflecting mirror
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • : 轉構詞成分。
  • : Ⅰ名詞1 (鏡子) looking glass; mirror 2 (幫助視力或做光學實驗的器具) lens; glass 3 (姓氏) a s...
  1. Based pc, d / a convertor and 2 - dimension galvanometer scanning system, laser marking control system is built. coordinate data scanned and kept in the computer are transformed into the analog signals by d / a converter, then control the galvanometer to deflexion

    基於pc 、 d / a換器和二維振掃描系統搭建激光打標機控制系統,將存儲在主控計算機的掃描坐標點的坐標數據通過d / a換,將數字信號換成模擬信號來控制振
  2. It compute the parameter of deflexion caused by thermal distortion in orbit, deduce the general expression for spreading beam after thermal distortion of reflector and the center deflexion of facula received in ccd. with the method of fixing etc, it put forward the restrain measures adopted accordingly

    計算了在軌運行條件下反射面熱變形引起的表面法向參數,推導了面變形后出射光線的通用表達式以及面變形前後在ccd探測器上的接收光斑中心量的計算表達式。
  3. Medical endoscopes - interface and deflection of distal end

    醫用內窺.遠終端的和介面
  4. The front element does not rotate so using a polarizer is no problem

    前組片不會動,所以使用沒有任何問題。
  5. The isoclinics rotate in the same sense as the polaroids.

    等傾線的向與向相同。
  6. Aberration of electronic lens made by electron gun and aberration of magnetic deflection system made by dy are comprehensively investigated, so is the shadow mask ' s effect on electron beam landing screen error. the conclusion can be get that, because the distribution of electron beam landing screen ( distribution of luminance ) is affected by many kinds of factors, it cannot get the correct function by calculation, and should be get by measurement instead

    全面分析了cpt電子槍發射系統形成的電子透像差與磁系統形成的像差;分析了蔭罩的自身厚度與位移對電子束著屏的影響,並由此得出結論,著屏電子束分佈(即亮度分佈)受著許多因素的影響,理論分析是半定量的,著屏電子束分佈需要用精確的測量儀器來測量。
  7. Special features for copying inputting originals auto paper select, auto scaling select, vertical horizontal independent anemographic magnification, final scale adjustment, copy density adjustment 7 degrees, scan start position adjustment, and copy position adjustment, top bottom bottom margin setting, mirror image, trimming, negative positive inversion, header, reference input, rotate image, sharpness, contrast, additional copy, scanning speed change

    自動用紙選擇,自動倍率選擇,縱向或橫向獨立縮放,倍率微調,復印濃度調整,掃描起始位置選擇,復印位置選擇,前後端空白選擇,消除框線,像,正負片反,頁眉,參照列印,畫面,明兩度,對比度,追加復印,掃描速度選擇,電子分頁可選配置
  8. Eccentrically rotating mirror

    心旋
  9. Prisms providing deviations ranging from about 15°to roughly 45°are available commercially.

    市場上能買到的棱角大約從15到45。
  10. This paper designs an optical system based on above to measure the small angle of the laser beam. a non - polarized beam splitter ( npbs ) is used to split the incident beam into two branches, and a rhombic prism agglutinated by two right - angle prisms is placed to realize total internal reflection twice in each branch. it not only improves the measurement sensitivity and linearity, but also increases antinoise ability by the differential optics

    本文正是基於這一原理設計了測量光束微小角的光路系統,用消振分光棱將入射光分為兩路,並在兩路分別用兩個直角棱組成的斜方棱來實現兩次全內反射,不但提高了測量靈敏度和線性,還利用差分光路的特點提高了抗干擾能力。
  11. The paper mainly focused on the beam transport part of asipp key laboratory of ion beam bioengineering and it ' s component elements, for example, van de graff accelerator, bending magnet, magnetic quadruple lenses, beam shutter, collimator and so on. the laboratory has performed the milestone achievement that is beam passed the hole of lo ^ m diameter in experiments. many experimental results are discussed by theories according to experiments

    本文重點討論了中科院離子束生物工程學重點實驗室單粒子束裝置的束流傳輸部分,對主要部件進行了詳細的討論,如:靜電加速器、磁鐵、磁四極透、束線開關、瞄準器等,實驗中已取得束流穿過10 m小孔的標志性成果,並運用相關理論結合具體實驗分析了實驗結果。
  12. These colors will change into the complementary values when the analyzer is rotated through 90°.

    當檢過90時,這些顏色就會變為它們各自的互補色。
  13. < uk > these colors will change into the complementary values when the analyzer is rotated through 90. < / uk >

    < uk >當檢過90時,這些顏色就會變為它們各自的互補色。 < / uk >
  14. In this thesis we analyze in detail the influence, created by random change of the optical wave polarization, on the output of the interferometer. then several principles of eliminating polarization - induced fading are introduced, and the principle that inserting two faraday rotator mirrors into the end of michelson fiber interferometer to eliminate the fading is analyzed in detail. this method can eliminate polarization - induced fading without additional signal processing, and make the output of the sensor stable

    其中,本文詳細分析了光波振態的隨機漂移對干涉儀輸出的影響,介紹了目前幾種消振衰落技術的原理,著重討論了在光纖michelson干涉儀末端加兩個法拉第旋的消振衰落的原理,該方法不需要任何附加的信號處理就可以消除振衰落,使干涉儀輸出穩定。
  15. At present, photothermal deflection technology and surface thermal lensing technology are widely applied in weak absorption measurement

    目前,廣泛使用的測量弱吸收的方法有光熱技術和表面熱透技術。
  16. The experimental setups have been built in the use of the photothermal deflection technology and surface thermal lensing technology, respectively. the weak absorption of different optical thin films has been measured. the experimental results obtained from the above two methods were compared

    4 .分別建立了表面熱透技術和光熱技術測量光學薄膜微弱吸收的實驗裝置,對多種光學薄膜樣品的微弱吸收進行了測量,並將兩種方法測得的實驗結果進行了比較。
  17. In the design, gear and spline were adopted, so symmetrical movement of ( collimator ’ s ) lead gates can be achieved easily, mechanical structure became more compact. worm was adopted to adjust mirrors accurately, and deflection of mirrors can be prevented in case of the external impacts or vibrations

    採用齒輪齒條結構,實現鉛門的對稱開合運動,使子系統的機械結構更為緊湊,同時提高了定位精度;採用蝸輪蝸桿調解反光的角度,可以使反光的調節更精確,同時可以防止在外界振動或撞擊下反光發生
  18. In this thesis, the overall optimization designs on surface - emitting lasers with 45 deflector structure are carried out. we have mainly considered two types of surface - emitting lasers with 45 deflector : surface - emitting lasers with 45 intracativity micro - mirrors and combined surface - emitting lasers, and then designed detailed fabrication processes

    本論文對45偏轉鏡面發射半導體激光器結構進行了優化設計,具體考慮了兩種45偏轉鏡面發射半導體激光器:折疊腔面發射和組合式面發射,設計了具體的工藝過程。
  19. Reflecting prisms - characteristics of image rotation

    反射棱特性
  20. Based on the above, we have made a research on the fabrication technology of two - dimensionally ( 2d ) arrayed surface - emiting lasers, and have obtained two - dimensionally arrayed laser primarily with lower threshold current density and higher power output, which will promote the achievement of higher reliability, lower threshold current arrayed surface - emiting lasers laser for high power output

    在此基礎上進行了面發射半導體激光器二維( 2d )列陣的制備研究,初步獲得了具有較低閾值電流密度和較高功率的45偏轉鏡面發射陣列半導體激光器,為研製高可靠性、高功率、低閾值電流的面發射陣列半導體激光器奠定了一定的基礎。
分享友人