切形變 的英文怎麼說

中文拼音 [qiēxíngbiàn]
切形變 英文
shear deformation
  • 切 : 切Ⅰ動詞1 （合; 符合） correspond to; be close to 2 （用在反切后頭 表示前兩個字是注音用的反切）見 ...
  1. On the backgrounds of researches inside and outside country, and cooperating experiments with theories analyses, the influence of different processing technology parameters and different sbs modifier sorts on the sbs modified asphalts " properties has been studied. at the same time, their microstructure are observed through fluorescence optical microscopy and scanning electronic microscopy, thus to direct modified asphalt production. on the above conclusion ' s basement, analysing some disadvantages of the storage stability test of sbs modified asphalt in the current specification, a new storage stability test apparatus is developed

    本文在參考國內外研究的基礎上，採用理論、試驗相結合的方法，研究加工工藝參數以及改性劑種類等對sbs改性瀝青性能的影響，並通過熒光顯微鏡、掃描電鏡分析其微觀形態，從而指導sbs改性瀝青的生產；在此基礎上，分析我國現行規范用來評價sbs改性瀝青儲存穩定性方面的不足，開發了新的試驗儀，根據動態剪切流變試驗結果和微觀狀態分析，提出一個新的指標? ?離析率r _ s來評價sbs改性瀝青的儲存穩定性；最後，針對不穩定的改性瀝青提出改善措施，研究證明摻加增容劑和穩定劑是行之有效的方法。
  2. Good bonds are always accompanied by surface extension, that is, plastic shear strain.

    良好的鍵合總伴有表面延伸即塑性切向形變。
  3. The deformations at the surface of the crust after rainfalls have close relations to the occurrence of shallow shocks in the upper crust.

    雨後地殼表面的形變與地殼上部發生的淺源地震密切相關。
  4. The first stage is primary slip then followed by secondary slip ; the last stage is due to dislocation passing the slips. the cyclic stress strain ( css ) curve exhibits a stronger hardening occurred in cyclic plastic deformation than that in tensile test

    建立了拉伸和應變疲勞的有限元模型，使用基於晶體滑移模型的數值方法，對晶體內部滑移系的啟動以及滑移繫上的分解切應變、切應力這些無法試驗觀測的變量進行計算，分析它們對晶體塑性變形的不同影響。
  5. The regional deformation anomaly of medium - term phase ( 1 ~ 3 years or more ) before strong earthquake occurrence usually shows three aspects of common characteristics : for regional vertical deformation, it shows distribution features of anomalous uplift area and concentration belt - high gradient belt of vertical differential deformation ( some of them reflect distribution of four quadrants ) related to tectonics ; for horizontal movement, it shows features of centralized high strain area ( or zone ) of domination shear deformation related to active blocks and faults ; it shows common features of regional vertical deformation anomaly area and high strain distribution area of horizontal deformation

    摘要強震前中期階段（ 1 ~ 3年或稍長）區域性形變異常往往表現出3個方面的共性特徵：區域垂直運動變形呈現與構造有關的異常隆起區、垂直差異變形高梯度帶（有的還呈「四象限」 ）分佈特徵；水準運動變形呈現與活動地塊及斷裂構造有關的、以剪切變形?主的高應變集中區（帶）特徵；區域性垂直形變異常區與水準形變的高應變分佈區共性的特徵。
  6. In this paper, the characteristics of large plane - pure - shear deformation is analyzed. based on the principle of strain accumulation, the equivalent strain formulae of large plane - pure - shear deformation is derived

    摘要本文分析了平面純剪切大變形的變形特徽，基於應變累積的觀點，推導出等效應變值的計算公式。
  7. Compared with any vibrating systems involving normal impacts, an oblique - impact vibrating system features not only the non - smooth characteristic of impacts, but also complicated dynamics owing to the relative tangential velocity and corresponding friction between two colliding objects

    斜碰撞振動系統不但具有正碰撞振動系統力學狀態的非光滑特性，還由於相對切向速度和摩擦引起碰撞物體的切向變形，因而具有更大的研究難度。
  8. The deformation characteristics and the formula for equivalent strain of large plane - pure - shear deformation mentioned in reference [ 1 ] are questioned in this paper

    摘要對文獻[ 1 ]中的平面純剪切大變形的變形特徵及等效應變表達式提出質疑。
  9. Based on the transfer - matrix method, the general expressions of equivalent four - terminal network parameters of varying section torsional horn are derived, the relations between frequency equation and both the rotational velocity amplification and that of the surface tangential velocity of stepped type torsional ultrasonic horn with transitional section of cosine - like type are obtained

    摘要基於傳遞矩陣演算法，推導出了變截面桿扭轉振動時等效四端網路參量的一般表達式，研究了帶類餘弦過渡段階梯形變幅桿扭轉振動頻率方程與角速度放大倍數及外表面切向速度放大倍數等的關系。
  10. Using abundant tools of maya, we could simulate varieties of operations in sugeries, such as incision, stitching, ligation, different types of anastomoses, deformation of organs and also the case of tumors

    採用maya中的各種工具，在三維模型中實現了各種模擬操作:如切開、縫合、結扎、各種吻合、器官形變和腫瘤的顯示，以及利用骨骼化模型模擬手術體位的調整等等。
  11. In the last part of the thesis a study of engineering effect about the complicated rock mass was done base on a numerical simulation and the engineering geological condition in the dam site. numerical simulation result reflect several disciplinarian of stress - distortion action in the right bank slope. firstly, today ' s right bank stress field mainly is grave stress field

    在上述研究工作的基礎上，通過對右岸巖體應力?形變作用的有限元數值模擬分析，表明：右岸壩基巖體的現今應力場主要是在自重應力場的基礎上，河谷下切應力、分異的應力場。
  12. The process and mechanisms of slipping, exfoliation to layered graphite and compounding with polypropylene ( pp ) on nano - scale were systemically studied. the effects of shearing force field offered by pan - milling and confined environment of the exfoliated graphite on the microstructure of polypropylene, the electrical and thermal conductivities of the nanocomposites were also investigated. based on the experimental results, a modified electrical conductive model as well as thermal conductive model for polymer - based composites was proposed

    利用層狀無機物（如石墨）的弱層間結構和聚合物的粘彈性特點，在磨盤碾磨剪切力場作用下，通過摩擦和拉伸形變錯位、擠壓嵌合、拉伸滑移、剪切剝離與粉碎和混合分散等過程，實現層狀無機物層間剝離和與聚合物的納米復合。
  13. And the linear viscoelastic behavior, steady rheological behavior and the formation / evolvement of particles net structure for molten nanocomposites were studied using an advanced rheometric expansion system ( ares ) and capillary rheometry. it is believed that the melt intercalation is a more efficient processing for formation of nanophase in polymer - layered silicates hybrids

    用高級流變擴展系統（ ares ）及毛細管流變儀對復合體系熔體的線性粘彈行為、穩態剪切流變行為進行了表徵，並對熔體粒子網路結構的形成與演化作了較系統的研究。
  14. Yet for thickness shear actuators, due to the shear deformation dominates the plate deflection for shear actuation mechanism, the higher order shear theory can provide more accurate evaluation of the shear strain energy of the plate than the first - order one, higher order shear deformation theory can provide more accurate evaluation of the deformation of the plate

    但對于厚度剪切型激勵器而言，由於激勵器主要是引起板的剪切變形，而高階剪切變形理論比一階剪切變形理論能更好地反映結構的剪切應變能，因此高階剪切變形理論可以提供板變形的更為精確的解。
  15. To solve the above problems existing in detection approach, a new way to detect the structure deformation based on strap down fiber optic gyro is presented in the paper

    本文針對上述工程結構形變測量方法中存在的問題，提出了一種基於捷聯式光纖陀螺慣性測量系統的切實可行的連續測量方法。
  16. Abstract : this paper intnoduces the means of wedm based on gnand command for altenating of the sysnmetrg figares, and explanins the steps and skills of he cutting. routes programming combining the particular part

    文摘:介紹了基於對稱圖形變換宏指令的低速走絲線切割加工方法，並結合具體零件切割路徑的編程步驟及技巧予以說明。
  17. The notch in the izod specimen seres to concentrate the stress, minimize plastic deformation, and direct the fracture to the part of the specimen behind the notch

    埃佐德待試驗樣品的切口用來聚集（沖擊）應力，將塑膠形變減至最小，並且將裂縫引向待試驗樣品切口後面的部分；這樣一來就會減少（沖擊）能量的散失。
  18. The mechanical properties of the modified nano ~ cac03 / pp is better than that of unmodified nano - cac03 / pp, especially the impact strength has been improved greatly. but when the dosage of nano - particles is too much, those nano particles will accumulate and this will lead to decreasing of strength of the material. through investigated of xrd and dsc, we found that ? - pp was formed by addition of nano - particles

    通過xrd和dsc分析發現，納米粉體對- pp有誘導生成作用：通過sem分析發現表面改性后的納米粒子填充即后，與pp基體結合較好，基體在沖擊方向存在層狀滑移，並有纖維狀形變，顯示基體發生了剪切屈服形變。
  19. The distribution of modified and unmodified nano - particles in pp were studied by means of tem, it showed that modified nano - particles dispersed much better than the unmodified nano - particles. the improved contribution of nano - particles lead to more ( 3 - pp formed and microscopic damage, all those structural changes caused the improvement of the mechanical properties

    通過tem分析發現經過表面改性后的納米粒子比未改性的納米粒子在pp中具有更好的分散性，分散性的改善更有利於誘導- pp的生成以及誘導基體發生剪切屈服形變，正是這種結構上的變化導致了力學性能的改善。
  20. ( 6 ) the predicting of large deformation in the tunnel has been given by using of two effective measures of forecasting - geological and complex forecast method and tangential strain predicting method. the result is that the probability of large deformation in this tunnel is non - existent

    （ 6 ）運用「地質綜合分析預測」 、 「切應變預測」兩種方法對雪峰山隧道的大變形問題進行了預測，預測結果表明，雪峰山隧道不會出現大變形問題。
分享友人
分享到 Line

分享到臉書