助顯影劑 的英文怎麼說

中文拼音 [zhùxiǎnyǐngjì]
助顯影劑 英文
second developing agent
  • 助 : 動詞（幫助; 協助） help; assist; aid; support
  • 顯 : Ⅰ形容詞1 （明顯） apparent; obvious; noticeable; evident 2 （有名聲有權勢的） illustrious and inf...
  • 影 : Ⅰ名詞1 （物體擋住光線后映出的形象） shadow 2 （鏡中、水面等反映出來的物體形象） reflection; image...
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 顯影 : [攝影學] develop
  1. The dispersion of the modified nano - sized caco3 in the pvc matrix was observed in tem ( transmission electron microscope ). the influences of surface treatment and the contents of nano - sized caco3, extrusion technology and other additives on the properties of the composites were investigated. the results show that the surface treatment of the nano - sized caco3 particles with wet method enlarged the specific surface area and reduced the surface energy of the particles, and made the particles dispersed at the nanometer level in the pvc matrix, which improved the mechanical properties of the composite

    本課題為了解決納米caco _ 3在pvc中的分散問題，對納米caco _ 3粒子進行了濕法處理，採用雙螺桿擠出法制備出具有良好性能的pvc -納米caco _ 3復合材料；對復合材料的力學性能和加工性能進行了測試；利用tem （ transmissionelectronmicroscope ，透射電子顯微鏡）觀察了納米caco _ 3粒子在pvc基體中的分散情況；討論了納米caco _ 3的表面處理方法、納米caco _ 3的含量、復合材料的制備工藝以及各種助劑對復合材料各項性能的影響。
  2. The results of experiment shows : l / d10, rate of filtration, filtration - supporting agents have bigger influence to filterability. the optimal combination of certain parameter of l / d10, rate of filtration, filtration - supporting agents can improve filterability obviously, get better quality of water outlet, extend the filter cycle, improve periodic quantity of water produce

    試驗結果表明： l d _ （ 10 ） 、助濾劑、濾速這3個因素對過濾性能有較大的影響；一定參數的l d _ （ 10 ） 、助濾劑、濾速的優化組合能明顯改善過濾性能，取得較好的出水水質，延長過濾周期，提高周期產水量。
  3. The properties of cn thin films such as their morphology, component, crystal structure and the bonding structure and the relation between those properties and the gas - phase reaction parameters were discussed, showing that the deposition of p - c3n4 thin film is the compete result of various reaction processes in the dynamics balance conditions ; the process of cn films depo sition is diagnosed in situ through the optical emission spectra technique, the effects of experimental parameters on the concentration of the precursors and the gas - phase reactions in the plasma have been obtained ; the main reaction precursors for film deposition identified ; the relation between the characteristics of cn thin films and the reaction process in the plasma is analyzed. the cn thin films deposition under different substrate temperatures in high pressure pe - pld shows that the si atom of the substrate has participated the cn films growth process, based on this the growth mode of cn thin films on the si substrate is proposed. the further experiment of cn thin films deposition on si substrate scratched by diamond as well as covered with fe catalyzer has been attempted, which indicates that changing the dynamics conditions of the surface reaction can alter the growth characteristic of the cn thin films and can enhance obviously the films growth rate

    採用pld技術進行了碳氮化合物薄膜沉積，得到了含氮量為21at的cn薄膜；研究了襯底溫度和反應氣體壓強對薄膜結構特性的影響，給出了cn薄膜中n含量較小、 sp ~ 3鍵合結構成分較少和薄膜中僅含有局域cn晶體的原因；引入脈沖輝光放電等離子體增強pld的氣相反應，給出了提高薄膜晶態sp ~ 3鍵合結構成分和薄膜的含n量可行性途徑；應用pe - cvd技術以ch _ 4 + n _ 2為反應氣體並引入輔助氣體h _ 2 ，得到了含n量為56at的晶態cn薄膜；探討了cn薄膜形貌、成分、晶體結構、價鍵狀態等特性及其與氣體壓強和放電電流的關系，證明了- c _ 3n _ 4薄膜沉積為滿足動力學平衡條件的各種反應過程的競爭結果；採用光學發射譜技術對cn薄膜生長過程進行了實時診斷，得到了實驗參量對等離子體中活性粒子相對濃度和氣相反應過程的影響規律，給出了cn薄膜沉積的主要反應前驅物，揭示了cn薄膜特性和等離子體內反應過程之間的聯系；採用高氣壓pe - pld技術研究了不同襯底溫度條件下cn化合物薄膜的結構特性，揭示了si原子對薄膜生長過程的影響，給出了si基表面碳氮薄膜的生長模式；在金剛石研磨和催化劑fe處理的si襯底上進行cn薄膜沉積，證明了通過控制材料表面動力學條件可以改變碳氮薄膜結構特性，並可顯著提高晶態碳氮材料的生長速率。
  4. Changing the grading of sic particles not only affects the strength and pile density, but also modifies the phase compositions and microstructure of the material. with the reducing of sic particles, the strength of the material increases obviously. the nitrification scheme has the greatest influence on phase compositions and microstructure " of si3n4 ( si2on2 ) - sic, after two continuous nitrification reacting peak and short - time high - temperature treating, the best properties can be obtained ; and the residual strength of the composite is much higher after the thermal shock resistance test, which shows that the material possesses excellent thermal shock resistance

    本論文較全面地探討促進強度和顯微結構良好的si _ 3n _ 4 （ si _ 2on _ 2 ）結合相的實驗條件，實驗數據顯示：引入適量的燒結助劑能夠促進si _ 3n _ 4 （ si _ 2on _ 2 ）的生成和晶粒的長大，而過量時，其促進作用反而下降；隨著si粉加入量增加，生成的結合相明顯增多，復合材料的性能顯著提高；改變sic顆粒級配不僅影響復合材料的強度與堆積密度，而且對復合材料的物相與顯微結構也有影響，隨著顆粒逐漸細化，材料的強度有較大的提高；對復合材料的強度、物相與顯微結構影響最大的是氮化制度，經過兩個氮化高峰連續的反應和短時間的高溫后處理得到的復合材料性能最好；通過抗熱震性能實驗后復合材料的殘余強度較高，顯示出較好的抗熱震性能。
分享友人
分享到 Line

分享到臉書