勻化器 的英文怎麼說

中文拼音 [yúnhuà]
勻化器 英文
emulsifier
  • : Ⅰ形容詞(均勻) even Ⅱ動詞1. (使均勻) even up; divide evenly 2. (分出一部分) spare
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. The structure of air - blast pipe was improved on. an orienting object was installed based on theoretical analysis, that increase the spraying span. it has been found that both spraying span and droplets uniformity improved, by installing the orienting object. according to the results of a great number of experiments, orderliness of droplets diameter along the spraying span was researched, and rational spraying span of air - assisted sprayer was suggested

    通過試驗檢驗噴霧機樣機的噴霧性能,並提出對各項參數的優設計方案。通過正交試驗和對比試驗對霧滴取樣,證明導流的安裝不僅增加了噴幅,而且還提高了霧滴均性系數。根據大量試驗的結果分析,找出了霧滴直徑在噴幅方向上所呈現的變規律,並提出了合理的噴幅范圍。
  2. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下,不同流速對熱管空氣預熱壁面溫度的影響;然後對影響整個流場分佈的各種因素:包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬;最後提出在分流煙道轉彎處加裝導流板,並模擬加裝導流板后的流場分佈,得到下級空氣預熱出口、熱管空氣預熱進口處的斷面速度場分佈、濃度場分佈,以論證加裝導流板能達到流場均的作用。
  3. In this thesis, a multiple - stigmatic - point method ( mspm ) is applied to improve the conventional rowland - type design, which is especially important for designing an awg when the total number of the channels is large. it greatly improves the performance of an awg, such as the channel uniformity, the crosstalk and the insertion loss

    文中採用多點消像差方法,對多通道數awg件的結構設計進行了改進,改善了傳統的rowland圓結構設計中存在的緣通道的性能嚴重劣的問題,大大改善了多通道數awg各通道性能的均性,改善了件性能。
  4. Many factors have effect on irrigation uniformity. with the growing of pressure, how is irrigation uniformity of trickle irrigation varying on different condition of the diameter of drip line, the distance of emitters, the length of drip line, the style of emitters, the flux ratio of emitters and the face gradient of little irrigation district. the consequence shows that pressure has puny effect on irrigation uniformity

    滴灌系統的灌水均度受眾多因素的影響,本文通過毛管的管徑、滴頭間距、毛管的管長、灌水的類型和灌水的流量系數不同的情況下,灌水均度隨壓力水頭變模擬結果顯示,壓力水頭對灌水均度影響非常小。
  5. In the experiment of varistor bleeder circuit, the successful load of equal voltage requires that the relation between load and varistor be correctly defined, so as to choose appropriafe experimental instrument

    摘要在變阻分壓電路實驗中,要求負載得到均的電壓時,怎樣確定負載與變阻之間的關系,以便在實驗中正確選擇實驗儀
  6. The concept called parallel macro - micro robot is presented. two kinds of optimal disposing methods of the cables ? tensions are used to build the inverse kinematics model of cable and cabin system. the error compensation model of the fine tuning stewart platform is deduced

    本章提出了並聯宏-微機人的概念及基於懸索張力均原則和懸索系統勢能最小原則的兩種索張力優配置方案,並在此基礎上建立了並聯懸索系統的逆運動學模型,推導了動基座stewart平臺的誤差補償模型。
  7. The research results show that compared with the uniform inlet velocity profile, the exponential inlet velocity profile has more advantages to get lower contaminant concentration, to prevent patient and operating apparatus in the operating area from infection by airborne disease germs and to reduce the airflow rate needed for pollutant concentration control

    研究表明,與通常採用的均風速的送風口相比,變風速的送風口對于降低手術室工作細菌濃度,防止病人手術切口及手術械等回風氣流攜帶的浮遊細菌再次感染,以及減少手術室的送風量等方面具有明顯的優點。
  8. Influence of gas flow uniformity on catalyst light - off characteristics in automotive catalytic converter

    汽車尾氣催內流動均性對起燃特性的影響
  9. Effect of injecting inert particles on coking prohibition and particle velocity uniformization in downer reactors

    下行床反應中惰性顆粒射入對結焦抑止和顆粒速度均的影響
  10. It was found that there are lower pressure drop and better distribution in the radically variable cell diameter converter and the inlet loss of catalytic converter may be neglected when the velocity in cell passage is low

    結果發現,三效催微元通道孔徑沿徑向的不同組合可以達到既不增加壓降、流速分佈又均的效果,而且在所計算的軸對稱三效催結構中,在通常的流量范圍內其進口損失可以忽略。
  11. According to the characteristics of pipeline leak signals that the influence degrees of burst interference noises are various in each local area, this paper optimizes the uniform quantization to be adaptable, and proposes an adaptive quantization

    根據管道泄漏信號局部區域受到突發干擾噪聲影響程度的不同,本文進一步優,將其改進為自適應量,提出了基於突發干擾噪聲的自適應量近無損壓縮演算法。
  12. The adaptation processing includes linear prediction coefficient adaptation and adaptation of quantization step size for residual signals. based on g. 726, we adopt a huffman coder to make use of probability statistic of bit cascade covering n ( n 1 ) samples generated from adpcm, in order to further reduce the bit rate. ng is lossless entropy coding, the speech quality of our improved algorithm should be same as that of g. 726 standard

    我們的研究和改進工作包括:研究最優非均自適應量,及其自適應演算法;研究波形預測函數,以及函數零點、極點的自適應演算法;基於每n ( n 1 )個樣本所對應符號的概率統計,對預測殘差量值再進行huffman編碼,進一步降低比特率。
  13. Our factory increase a set of intensifier with non - grade - adjustable rating speed to form the intensive air drying, the wet material mixed with hot air fully by screw feeder in the intensifier and material surface is crashed into fine granules and moving to the outlet as well as drying, under rapid rotating hitting and pushing. in the long run, the materials get a further even drying in the dryer pulled by the wind force and those wet and weighty granules the wind force can not pull continue to be crashed, dried until they are pulled by the wind force into the dryer

    我廠強型氣流乾燥是在基本型上增加一套轉速可以無級調節的強組成,濕物料通過螺旋加料進入強后和熱氣流充分混合,在飛速旋轉的擊刀擊碎和推進下,物料被破碎成細顆粒,在乾燥同時向出口移動,最後在風力吸引下進入乾燥管,進一步均乾燥,風力無法吸引的濕重顆粒繼續被擊碎、乾燥、直至能被風吸起進入乾燥管。
  14. The results of the study show that a uniform velocity distribution can be obtained with the deflector

    研究結果表明:彌散可使催獲得較均的流速分佈。
  15. The numerical simulation results show that the flow uniformity of catalytic converter with deflector is higher than that of the conventional catalytic converter

    數值模擬的結果表明,有彌散的催的流動均性優于常規結構的催
  16. The experimental and simulation results show that using the improved structure of inlet header can greatly improve flow uniformity, decrease pressure loss, enhance the efficiency of twc, attribute to prolonging the service life of the machine, and lessen the power decrease caused by twc, but the light - off time of twc is retarded

    通過模擬與試驗表明,與常規結構催相比,組合型入口管可明顯改善流動均性,降低壓力損失約1 / 4 ,提高催效率,延長使用壽命,減小對發動機動力性的影響,但起燃變慢。
  17. A mathematical model of flows in the substrate was established using the equivalent continuum approach, and multi - dimensional numerical simulation of the steady flows in the catalytic converters was performed. simulation results show that the separation and vortex, which cause the pressure loss and the velocity non - uniformity at the front of the first substrate, are generated near the wall of the conical pipe. in addition, the larger the inlet cones angle the more the pressure loss and maldistribution in converters, however, when the angle enlarges enough the pressure loss would be decrease

    結果顯示氣流在擴張圓錐管壁附近出現分離產生較強的擾動,造成局部流動損失和載體前氣流速度沿徑向分佈不均;入口擴張管結構對催的流動特性有很大影響,但並非擴張角越大,催流速武漢理工大學碩士學位論文分佈的不均性和壓力損失也增大,而是存在著一個最佳角度,但當擴張角增大到一定程度以後,擴張角對流速分佈和壓力損失的影響變小。
  18. ( 3 ) another method using liquid crystal spatial light modulator can control the small region of incident laser, which can change the intensity distribution and uniform temperature distribution. the related driver circuit of liquid crystal spatial light

    ( 3 )採用液晶空間光調制方案實現溫度分佈均通過液晶空間光調制對入射光束不同位置的微小局部進行幅度調制,從而改變輸出光場分佈,達到均的目的。
  19. A new structure of three - way catalysts ( twc ) with combined flow guide device was presented and the simulated results of its influence on the flow distribution uniformity were given

    摘要設計了一種組合式導流裝置,並數值模擬了其對三效催內流場均性的影響。
  20. The investigation showed that due to the improvement of the combined flow guide device, the catalyst composition and the processing technology, the uniformity of flow distribution in twc could be improved by more than 5 % and the life - span of twc could be prolonged

    在設計的均流裝置、催劑配比及催劑加工工藝下,催內流場均性提高了5 %以上,使用壽命也較大提高。
分享友人