卸閥器 的英文怎麼說
中文拼音 [xièfáqì]
卸閥器
英文
valve removal-
Carefully remove the handwheel and turn indicator sleeve assembly, leaving the valve at its balance set point
小心拆卸手輪,並旋轉指示器套筒總成,將閥門保留在它的平衡設置點上。Remove handwheel and turn indicator sleeve by grasping the handwheel and pulling away from the valve body along the stem
拆卸手輪,並通過抓住手輪旋轉指示器套筒,將其沿著閥桿從閥體內拉出。Remove the retainer from the body bore
從閥體鏜孔內拆卸固定器。The shaft also shall have a directional indicator on top to indicate disc position when the handle is removed
閥桿也應該在頂部配置方向指示器,用於當手柄拆卸下來時指示閥瓣的位置。Valve spring remover
閥彈簧拆卸器Valve - spring remover
閥門彈簧拆卸器Slowly open all ball valves to relieve air and water pressure. loosen bolts on groove coupler and remove groove couple and cover plate from valve body
慢慢開啟所有球閥,釋放空氣和水的壓力。松開溝槽連接器上的螺栓,從閥體上拆卸溝槽連接器和蓋板。Remove first check module from module adaptor, and repeat above procedure with second check module
從模塊適配器上拆卸第一止回閥模塊,對于第二止回閥模塊重復上列步驟。To clean or replace disc or strainer, remove the large hex head bottom plug
為了清洗或更換閥瓣或過濾器,拆卸底部的大六角頭塞。Function of three valve units is take signal from lead pressure point introduce the positive - negative pressure measuring container of transmitter, to realize on or off between lead pressure point and measuring container, and on off between positive and negative pressure container, also can use as differential pressure balance check zero and when remove transmitter as cut - off valve
三閥組的作用是從引壓點將信號引入變送器的正負壓測量容室,實現引壓點與測量容室之間接通或斷開,以及正負壓測量容室之間接通或斷開,亦可作為差壓平衡檢測零點用和卸變送器時作截止閥用。Shock absorber relief valve
減振器卸荷閥To clean ; remove bottom plug, seat spring, strainer and seat disc
因此要清洗,拆卸底部塞、閥座彈簧、過濾器和閥座閥瓣。分享友人