均勻度檢驗 的英文怎麼說

中文拼音 [jūnyúnjiǎnyàn]
均勻度檢驗 英文
uniformity inspection
  • : Ⅰ形容詞(均勻) equal; even Ⅱ副詞(都; 全) without exception; all
  • : Ⅰ形容詞(均勻) even Ⅱ動詞1. (使均勻) even up; divide evenly 2. (分出一部分) spare
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : Ⅰ動詞1 (查) check up; inspect; examine 2 (約束; 檢點) restrain oneself; be careful in one s c...
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 檢驗 : checkout; test; examine; inspect; verify; survey; check;checking;testing;[英國]jerque(指檢查船舶...
  1. The activatory coal gangue powder ( acgp ), ground cement clinker and natural gypsum are mixed by different ratios to prepare blended cement specimens, and its mortar compressive strength performance, water usage for standard consistency, and flowability of mortar are investigated

    摘要將經燃燒等過程進行活化處理的煤矸石細粉與磨至一定比表面積的水泥熟料及天然生石膏混合,製成了活化謀矸石粉摻量比例不同的多組混合水泥,並對其膠砂強性能、標準稠用水量、膠砂流動進行了實測。
  2. Test method for dyeing uniformity of importexport polyester textured yarn

    進出口滌綸加工絲染色均勻度檢驗方法
  3. Test methods for natural facing stones part 8 : test method for structural performance of dimension stone cladding systems by uniform static pressure difference

    天然飾面石材試方法第8部分:用靜態壓差測石材掛裝系統結構強方法
  4. Through the theory of light radiation and intensity, we can use the fewest leds to satisfy the luminous intensity demand. through image segmentation theory, we can accurately pick module up from the test stripe when it is put in wrong directions. through image processing theory, we can acquire correct information and avoid the bad effects from the asymmetric chemistry reaction and instability of the devices

    用光的輻射和強理論,我們計算出了獲得足夠圖像強所需的最少光源;用圖像分割理論,我們在試紙條傾斜放置或有垂直方向上的偏移時,準確地提取出了各模塊的數據;用平滑濾波和值濾波理論,我們濾除了由於反應不及硬體設備不穩定帶來的噪聲;用交遇區設計線性分類器的方法,我們降低了有限樣本設計線性分類器帶來的誤差,提高了準確
  5. Used for testing the segment evenness of cotton lap at specified length, at the same time testing the weight and percentage of elongation of cotton lap

    用於棉卷在規定長片段間的,同時測定棉卷的重量及伸長率。
  6. Used for testing the evenness of sliver and roving

    用於條子及粗紗的條干
  7. Based on comparison of several technical schemes, the method of sand bedding pre - elevating and step water - filling pre - compressing is adopted. so the dissertation is consist of two parts : ( 1 ) the applicability study for the method of sand bedding pre - elevating and step water - filling pre - compressing, including numerical analyses for the thickness of sand bedding, the consolidation, settlement and stability of foundation, drainage, possibility of foundation liquefaction under seismic loading, et al. ( 2 ) monitoring at construction stage and checking the effect of foundation treatment, including the measurements of the settlement velocity and non - uniform settlement of ring beam under the tank, pore pressures and horizontal displacements in foundation, the pressure distribution at the bottom of oil tank and the strength increase of soils

    通過多種技術方案比較,最終選擇了技術先進的砂墊層預抬高分級充水預壓法,論文工作主要由以下兩部分組成: ( 1 )砂墊層預抬高分級充水預壓法的適用性研究,其中包括砂墊層厚、地基沉降與固結、地基穩定性、降水、地震作用下砂土液化的可能性等方面的計算分析; ( 2 )施工監測與地基處理效果,其中包括油罐環梁基礎沉降速率與不沉降程、各分級充水加載階段地基超靜孔壓與深層水平位移、油罐底板壓力分佈及地基土強增長等方面的實測與數據分析。
  8. In the process of devising rainfall apparatus, the calculative formula of traditional rainfall degree of consistency ca n ' t weight the uniformity of rainfall space. the paper suggests the checkup parameter and calculative method used in testing the degree of consistency of the rainfall intensity in rainfall space

    在降雨器設計中,傳統的降雨計算公式並不能衡量降雨強空間分佈的性,本文提出了雨強空間分佈的校參數及空間優劣的計算方法,給出了校該參數應達到的最小值。
  9. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制,以控制沉積過程,減少金剛石膜生長過程中的缺陷,並採用光纖光譜儀測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程;利用微波對材料的選擇加熱特性,通過構造等效方程,並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中,建立了非等離子體溫場綜合模型、復合介質基片材料的復合溫場模型及復合介質材料溫場攝動模型,為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備,並對基片加熱材料進行了設計和優選,以獲取大面積的溫場區,甚至獲得大於基片臺尺寸的區;作為研究重點之一,開展了微波等離體化學氣相沉積金剛石的成核與生長研究,系統地研究了在( 100 )單晶硅基片上mpcvd沉積金剛石膜的實過程中,基片預處理、甲烷濃、沉積氣壓、基體溫等不同實工藝參數對金剛石薄膜質量的影響,分別用raman光譜、 x射線衍射( xrd ) 、掃描電鏡( sem ) 、紅外透射光譜( ir ) 、原子力顯微鏡( afm )對薄膜進行了表徵,確立了該系統上mpcvd金剛石膜的最佳的實工藝參數。
  10. ( 5 ) sic content in coating was 20. 11 ( vol % ). coating was fine and close. the hardness was 2. 68 times pure ni coating, and wear - resistance was 4. 1 times pure ni coating

    ( 5 )對所得鍍層的性能進行了測,鍍層中sic粒子含量為20 . 11 ( vol % )且緻密;鍍層的硬和耐磨性分別提高到純鎳鍍層的2 . 68倍和4 . 1倍;結合力實也表明鍍層與基體具有良好的結合力。
  11. Entropy of an image is to express the smoothness or homogeneity of the image. while computing in a local window, if there exist edges, the local image will not be homogenous, variation of the grayness will be sharp and the entropy obtained will be low. otherwise, the entropy will be high. given the threshold of entropy, it can be determined whether or not exist edges. because entropy operator is sensitive to noise, the effect is bad if it is directly used to detect edges. in view of the deficiency, the paper comes up with an edge detection method in which entropy operator is combined with noise removal. if the entropy computed is higher than the threshold, it will be necessary to determine whether it is caused by noise or by edges. thus edge detection and noise removal can be made at the same time. with this method satisfactory effect has been achieved by experimenting upon image with low ratio of signal to noise

    圖像的熵用來刻劃圖像的平滑性或性.在圖像的局部窗口中計算時,如果窗口中存在邊界,則窗口中的圖像不,其灰變化急劇,計算出的熵小;反之熵大.設定熵的閾值,即可判斷是否存在邊界.由於熵運算元對噪聲很敏感,直接用它進行邊界測,效果很差.文中針對這一缺陷,提出將熵運算元與去噪相結合的邊界測法,如果計算出的熵大於閾值,要判斷是噪聲的出現所引起,還是邊界的出現所引起,這樣,邊測邊界邊去噪聲.用該方法對信噪比較低的圖像進行實,得到了滿意的效果
  12. Oil bearing materials for import and export. method for the inspection of grade and uniformity

    進出口油料.規格及均勻度檢驗方法
  13. Testing of textiles ; determination of unevenness of slivers and yarns ; general basis

    紡織品的.紗條和紗線的不的測定.基本原理
  14. Scaling - up of patch model is necessary in the calculation of surface energy fluxes and evapotranspiration from remote sensing data. the simulation error of two - layer model caused by sub - pixel heterogeneity and discontinuity of surface geometry and physics were investigated using a number of data experiments

    論文還分析了蒸散模型的空間尺效應,通過一系列的模擬實了雙層模型中國科學院遙感應用研究所博士學位論文在不同地表非狀態下的尺誤差,並且根據通量尺擴展的基本法則推導了雙層模型參數的尺擴展公式。
  15. Based on the analysis of experimental data from actual engineering, corrosion distribution law of general corrosion was found to follow the lognormal distribution through k - s test, while the localized corrosion follows the extreme distribution of type

    根據工程實際測數據的統計分析,通過k - s得出了腐蝕深服從對數正態分佈,局部腐蝕深服從極值型分佈的規律。
  16. Test method for structural performance of dimension stone cladding systems by uniform static pressure difference

    靜態壓差測石材掛裝系統結構強方法
  17. Genral rules for sampling inspection of bulk materials with uniform size

    散料抽樣通則
  18. General rules for sampling inspection of bulk materials with uniform size

    散料抽樣通則
  19. The scheme has a novel feature that the extraction location of the tracer is not fixed at the center location of the grid, but first optimized at the location where the gradient is maximum in the grid domain, and then by cumulonimbus and uniformity test, the final tracers can be decided

    該演算法的特色是反演風的位置並不固定在反演網格的中心位置,而是通過梯分析的方法使反演風的位置得到優化,再經過積雨雲測和灰分佈,剔除不適合用來反演的目標物。
  20. The performance of usscd is compared with the well known algorithm, icollide, through a series of experiments. the results show that, when the objects are evenly distributed, and the number of objects is large, the performance of usscd is better than that of icollide. in this paper, a class of non - uniform spacial subdivision method is proposed, which is composed of two steps : first, the space is coarsely subdivided non - uniformly, based on the distribution density of the objects, then, every subspace is uniformly subdivided

    提出了一種基於空間分割的快速碰撞測演算法usscd ,與經典的icollide演算法進行了對比試,試結果表明,在物體分佈的情況下,隨物體數量的增多, usscd表現出明顯的優勢;提出了一類非空間分割方法,在該方法中,空間分割由基於密的非空間分割和對每個子空間進行分割兩個步驟實現;提出了一種基於投影的非空間分割方法。
分享友人