均勻應力 的英文怎麼說

中文拼音 [jūnyúnyīnglì]
均勻應力 英文
homogeneous stress
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 勻 : Ⅰ形容詞（均勻） even Ⅱ動詞1. （使均勻） even up; divide evenly 2. （分出一部分） spare
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  1. The relation of ?to the average value of may be assumed to lie between the aforementioned relations for uniform plane stress and uniform plane strain.

    而和平均值的關系式可以認為處于上述的均勻平面應力和均勻平面應變的兩個關系式之間。
  2. The scale effects due to unsimilar bed risistance is discussed in detail, and the correct way of scour depth is supposed. at last, a new transport rate formulas of uniform or nonuniform bed load is given

    本文還對由於阻力不相似而引起的比尺效應進行了較詳細的討論，從理論上給出了沖刷深度比尺效應的修正方法及新的均勻、非均勻推移質輸沙率的計算公式。
  3. The powder was pressed through molding and cold isostatic pressure, which increased the density and decreased the uneven distribution of stress inside the briquet to make the ceramic briquet equally compact

    粉料採取模壓和冷等靜壓相結合的方法壓制，增大了坯體內部的密度並減少了應力的分佈不均，得到均勻緻密的陶瓷坯體。
  4. The direction which embroiders wants consistently, while rising needle should make sure central point, while embroidering to loosen to make an effort tightly and appropriately to be even, while rising needle or ending don ' t tie knot, should stay an 1cm or so line head in the noodles anticipate back press a prison mutually, noticing don ' t make the line head entwine conglobation

    一、繡出的方向要一致，起針時應確定中心點，繡時要松緊適度用力均勻，起針或結束時不要打結，應留出一厘米左右的線頭在面料背面相互壓牢，注意不要使線頭糾纏成團。
  5. The cyclo - hoop effect which steel tubular has exert to the concrete shows the character of heterogeneous in the arch rib section, the same to the axial direction. the paper verifies the change of the material poisson ration and the concrete grade will make the cyclo - hoop effect obvious alteration, the change of the cyclo - hoop effect and the stress redistribution of the section produced by the shrinking and creeping of the concrete and the expensive concrete on the section

    在鋼管混凝土拱肋斷面上，鋼管對內填混凝土的環箍效應具有非均勻性，在拱軸方向上環箍效應也呈現非均勻性。驗證了材料的橫向變形系數、混凝土標號等參數的變化將引起環箍效應的明顯改變；混凝土的收縮、徐變和膨脹混凝土的應用導致鋼管混凝土的環箍效應發生變化並使截面的應力發生重分佈；並總結了其變化的基本規律。
  6. The drive band and retainer feature a hex - drive system to distribute drive loading evenly and eliminate overstressing of the flexible elastomer bellows

    傳動環和護圈配置一個六角傳動系統，均勻的分配傳動負載，消除柔軟的彈性波紋管上的過度應力。
  7. The brief name ring, measures a device right high, inside, low and each segment scope for ability for even emersion of signal, pointing lowestly validity returning putting the frequency with tallestly validity returning put of the frequencying. request towards device rang contain both side, on is a scoping as far as possible breadth, can be namely frequency bottom that replay the is as far as possible low, and the upper limit is as far as possible high ; two is a frequency scope the inside is at all point to respond to as far as possible flat, avoided to appeared the big motion

    簡稱頻響，衡量一件器材對高中低各頻段信號均勻再現的能力，指最低有效回放頻率與最高有效回放頻率之間的范圍。對器材頻響的要求有兩方面，一是范圍盡量寬，即能夠重播的頻率下限盡量低，上限盡量高二是頻率范圍內各點的響應盡量平坦，避免出現過大的波動。
  8. Analysis on stress uniformity of viscoelastic materials in split hopkinson bar tests

    試驗中粘彈性材料的應力均勻性分析
  9. Some other defects in castings are well - defined cracks and hot tears that develop during solidification, under combination of stress concentration from uneven contraction and the metal ' s low strength at near - melting temperatures

    鑄件內部的其它一些缺點是，凝固過程中，在不均勻收縮造成的應力集中和接近熔點溫度下金屬的低強度的綜合作用下，出現的清晰裂縫和熱撕裂。
  10. Application of magnetic moment formula in the non - uniform magnetic field

    磁力矩公式在非均勻磁場中的應用
  11. In recent years, plentiful and substantial fruits achieved by the lb method in simulations of hydraulics, multiphase flows, flows in porous media and heat transfer as well as magnetohydrodynamics, have revealed a broad perspective of application of this method, it will become a powerful competitor to the conventional approaches. in order to absorb the recent achievement in theory and application of the lb method, explore new ways in hydraulic computation to promote the development of practice, some work is car ried out in this thesis, as following : advances in the theory research and application, deductive process of the d2q9 model and some other commonly used models of the lb method are summarized. based on the hydrodynamic and general boundary conditions, a new joint boundary condition is presented, it integrates advantage of the two conditions above and obtains very good results in dealing with all kinds of boundaries of flow fields

    為了消化和吸收近年來lb方法在理論和應用方面的新成果，探索在水力計算方面的新途徑以促進lb方法實用化的發展，本文進行了下列研究工作：綜述了lb方法在理論研究和實際應用方面的新進展，以及d2q9模型的推導過程和其他一些常用的模型；在水動力邊界條件和通用邊界條件的基礎上提出了一種新的聯合邊界條件方法，它綜合了上述兩種邊界條件的優點，在流場的各種邊界處理中取得了非常好的效果，經過模塊化的處理以後這種邊界條件具有更好的實用性；針對均勻網格的lb方法計算效率較低的不足，提出了雙重網格的latticeboltzmann方法，通過二維poiseulle流動、后臺階流動和渠道方槽流動三個算例的模擬，證明這種方法能夠明顯地提高流場模擬的計算效率；此外，根據復雜區域流場的特徵提出了latticeboltzmann方法的分塊-耦合演算法，利用lb方法的計算特性實現塊與塊之間的數據交換，充分利用計算資源提高計算效率，通過對「 t 」型、 「十」型和「 x 」型分岔管道流場的模擬，展示了這種演算法的特徵和優點，以及它所具有的應用前景。
  12. The embroidery way should be consistent and making sure the center before stitching. moreover, elasticity and potency should be moderate during embroidering. meantime don ' t tie a knot in the begining of stitching and the ending and the head of thread lefting one cm should be pressed firmly on the back of material and pay attention to avoid the sleave of the head of the thread

    繡出的方向要一致，起針時應確定中心點，繡時要松緊適度用力均勻，起針或結束時不要打結，應留出一厘米左右的線頭在面料背面相互壓牢，注意不要使線頭糾纏成團。
  13. 2 ) the structure elements should be laid out symmetrically and uniformly when designing steeve - arch structure, what ' s more, the reasonable selection of section geometric size near the arch foots of first beams is paid attention to and the arrangement difficulties of steel bar due to the big eccentric pressures 2, the analyses of anti - seismic features on transverse direction of the aqueduct l ) the method of adjusting the elements " mass can be harnessed in order to even the layout of seismic loads

    2 ）設計吊桿式拱架支承結構時，各部分構件應當均勻對稱布置。另外，還應注意頭道梁拱腳附近截面的尺寸擬定，克服地震內力造成的大偏心受壓狀態給結構配筋設計增加的困難。 2 、橫槽向抗震性能分析1 ）可利用調整構件質量的方法，使得結構的某些構件的地震荷載分佈均勻一些。
  14. The hualu brand anatase titanium dioxide we offer has high chemical stability, even particle size distribution, and excellent tinting strength. it is well accepted by customers in more than 20 provinces across china and widely used as pigment and filling in coating, rubber, paper, plastic, printing ink and other related products

    該裝置生產的「華綠」牌銳鈦型ba01 01鈦白粉是一種優質白色原料，化學性質穩定，粒子細小均勻，光學性能佳，著色力高，廣泛應用於塗料橡膠造紙塑料油墨等行業，產品暢銷全國20多個省市。
  15. Smooth tempered glass is manufactured by heating up float glass to swiftly and uniformly, with this special heat treatment and quenching process which increases glass strength up to four to five times vs, annealed glass, in case stresses beyond its capacity, smooth tempered glass simply disintegrates into innumerable small pieces, significantly reducing the risk of serious injury

    鋼化玻璃是將浮法玻璃經過物理性淬火處理，使其表面形成均勻的壓應力，而內部則形成張應力，從而有效的提高了玻璃的抗彎和抗沖擊性能，強度達到了普通玻璃的3 - 4倍，當其破碎時則分裂成均勻純角不易傷人的小顆粒，使其成為一種現代生活中理想的安全玻璃。
  16. The stress distribution is far from uniform in this stratified rock, the horizontal stress magnitude in hard rock layers is significantly higher the that in soft layers

    在軟硬相間的層狀巖體中地應力分佈很不均勻，應力大小與巖層硬度具有正相關性，硬巖中的水平應力大於軟巖的水平應力。
  17. Based on unified strength theory, the boundary line equation of surrounding rock mass plastic zone under non - uniform stress field was deduced, and it can be used to pre - estimate the dimensions and shapes of underground tunnel ' s plastic zone with different coefficients of horizontal pressure

    摘要基於統一強度理論，推導出非均勻應力場的巷道圍巖塑性區邊界線方程式，可用於預測不同側壓系數時地下深埋隧洞的塑性區大小及形狀。
  18. Abstract : the anti - plane problem in transversely isotropic magnetoelectroelastic materials containing an elliptic inclusion is considered by using the complex variable approaches. the analytical expressions for the field variables in both the matrix and the inclusion are obtained when the stresses and the electromagnetic fields at infinity are uniform. the results show that the stress, the electric displacement and the magnetic induction inside the inclusion are constants

    文摘:用復變量方法研究了橫觀各向同性電磁彈性固體的反平面夾雜問題，得到了遠場均勻應力和電磁場作用下夾雜內外彈性場和電磁場的解析表達式，結果表明夾雜內的應力、電位移和磁感應強度為常量。
  19. Homogeneous state of stress

    均勻應力狀態
  20. In this paper we present improved draft of joint bar in the base of the analysis of rail joint. the draft is reasonable for it can make the stress evenly when a wheel rolls over the rail joint

    同時，本文根據對夾板的應力分析提出了改進的接頭夾板方案，認為該方案能使夾板均勻受力，在設計上是合理的。
分享友人
分享到 Line

分享到臉書