塑性破斷 的英文怎麼說
中文拼音 [sùxìngpòduàn]
塑性破斷
英文
ductile fracture-
It is one of mechanisms of plastic distortion, at the same time it is also the beginning of microcosmic damage and rupture before the macroscopical destroying of materials, it representatives a mid - state between materials " macroscopical rupture and bend, it is considered a premonitor that the rupture of polymer material
它是材料塑性變形的機制之一，同時又是材料宏觀破壞以前微觀上損傷、破壞的開始，它代表材料微觀斷裂和屈服之間的一個中間狀態，可以看作是聚合物材料宏觀斷裂的先兆。After the stolon had suffered from severing disturbance, clonal ramets could keep photosynthetic organ from being damaged through the plastic responses of the chlorophyll fluorescence traits, such as increasing nonphotochemical quenching of chlorophyll fluorescence ( npq ), decreasing actual photochemical efficiency of ps ii in the light ( f / fm " ) and photochemical electron transport rate ( etr ). moreover, the clonal ramets could also increase water use efficiency by means of decreasing stomatal conductance
在匍匐莖受到切斷干擾后，臭柏能通過提高非光化學猝滅（ npq ） 、降低ps實際光化學量子產量（ f fm 』 ）和表觀光合電子傳遞速率（ etr ）等葉綠素熒光特性的可塑性反應來保護小枝光合機構不被破壞，並且可以降低氣孔導度以提高水分利用效率。The results show that the process of concrete sawing with diamond tools is that the impact of diamond sawblade induces the rupture and break of concrete surface layer during high speed sawing ; cement and carpolite become micro chips by the cutting of diamond grits ; steel fiber and steel wire are broken by plastic deformation or pulled out by forces
結果表明：金剛石鋸片鋸切混凝土的過程表現為高速據切過程中金剛石據片的沖擊引起混凝土表層斷裂破碎，水泥石子等在切削區內層受到金剛石磨粒的微切削作用形成粉屑，以及鋼纖維和鋼絲發生金屬塑性變形斷裂或被拔拉而斷裂的過程。The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi
得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 「角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器製造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86I. a mtil ( iaxial elastic - plastic hardening - sofling constitutive model of concrete is proposed iii order to offer a nonlinear material model of concrete for space restoring force analysis of reinforced concrete members taking into account the softening behavior of concrete. the concrete material model is incorporated the elastic - plastic hardening fracturing constitutive model of concrete with the plastic - fracturing theory of concrete, modified without defining two loading functiomis, and based on five parameter power function failure criterion proposed by guo zheng - hai etc from tsingliua ( jniversity, or three parameter unified strength theory proposed by yu mao - hong from x ian iiaotong university
1 、將砼彈塑性硬化斷裂本構模型與塑性斷裂理論結合起來，並加以改進，但無需定義兩個加載面，以清華大學過鎮海建議的五參數冪函數或以西安交通大學俞茂宏建議的，參數統一強度理論作為砼的強度破壞準則，建立了砼多軸彈塑性硬化松馳本構模型，能為鋼筋砼構件空間恢復力分析提供砼非線性材料模型，並能反映砼材料的軟化段。Topics include : elasticity, viscoelasticity, plasticity, creep, fracture, and fatigue
主題包含：彈性、黏彈性、塑性、潛變、破斷及疲勞。Researching on the technology if reverse order is to study strains if pits, structural systems if basement, environmental surwey and underpinnings. on account of emphasizing developing methods if checking strength if pick - ets, modemizing machenes of excavation and studying methods of underpinning is put forward and is a way if controlling the quality of pickets in sites, which leads an active effect ; synthetic application if rankintheory, spatial and time effect theory to excavation tl aanalyze the state of soil force and strain is brought forward and the time effect should be considered in the zone of clay, the formation and development of soil plasticity are analyzed and the most dangerous zone to decide how to excavate and where to begin is found ; analyzing the cause of picket settlement during reverse order and the differential settlement and discussing hlw to solute it. duringh the temporary survey and the environmental warship, bringing rorward the theory of environmental vibration and analyzing the state of soil force and probability of losing stabilization of soil under the effect of environmental vibration ; analyzing the state offeree in underground concrete wall by the method of mathematics and pointing out the place of the maximum force and deformation. based on systematic illustrating the reverse order, problems about application and development of reverse order and suggestions also are expressed
鑒于國內外的研究把重點放在大力發展工程樁的實驗室承載力監測方法與設備、如何使土方開挖機械現代化及對周圍建築的臨測方法上，本文提出了現場利用聲波層析成像技術監測鋼砼樁內部質量的方法與程序，並得出了聲波層析成像技術是砼樁的動態質量檢測的有效手段，這對指導施有積極、現實意義；提出了綜合運用朗肯土壓力理論、基坑空間和時間效應影響理論來分析逆作法施工過程中基坑邊坡土體應力及應變的變化情況，指出粘土地區也應考慮時間效應，並且進一步分析了基坑邊坡土體的塑性區形成和發展，找出邊坡最不利的區域，以確定地下室土體的挖掘的方式和順序，指出憑主觀臆斷與經驗來施工是不可取的；在分析、經較逆作法與大開挖順作法的地下室結構體系受力情況及施工順序的不同，提出了節點處理技術；分析了逆作法施工期間樁的沉降變化原因及由此而產生的差異，並探討了解決的方法；本文還提出了環境振動對土體邊坡穩定產生影響的觀點，並分析了在環境振動影響下，土體的應力狀態及土休失穩破壞概率，並且還運用彈性力學知識和數學分析的方法定量地分析了地下混凝土墻受力狀態，指出了被監測墻體的最大應力、應變位置。The critical crack and stress put forward provides theoretic foundation for monitoring portal machine. 3. applying steady theory of board, studying the problem of early curvature, flexibility model, welding remaining stress, elastic transmutation and brace condition and so on, conclude that structure of beam is primary place where metal structure of portal crane lose stabilization and the break of main beam is result of losing partial stabilization of main board
文章提出的界限應力和臨界裂紋對于港口機械的監測提供了理論依據； 3 、運用板的穩定理論，探索了作為薄壁構件的門機金屬結構在失穩破壞中所涉及到的初曲率問題、彈性模量問題、焊接殘余應力問題、彈塑性變形問題以及支承條件問題等，得出了門機金屬結構發生失穩破壞的主要部位為臂架結構，且主臂架的折斷是由於受壓翼板局部失穩引起整體破壞； 4 、探討了焊接對結構承載的影響。Under varied loads such as cyclic and / or transient loading, soil structures or foundation will induce permanent and / or fluctuating plastic deformations. such plastic deformations are cumulative and / or alternating in nature with increase of time of loading during a sequence of cyclic loading. if the resulting accumulated deformations is limited within a given bound or the alternating deformations will be adapted to a given plastic state after a certain cycle numbers or a certain period of loading, the soils will be in shakedown state
在復雜變值荷載作用下，結構有可能出現兩種狀態：一種是在若干次載荷循環之後，塑性變形趨于穩定，在此後繼的載荷循環中結構表現為純彈性響應，這種狀態稱為安定狀態（ shakedown ） ；另一種則是塑性流動一直持續地發展或不斷反復，直至結構破壞，結構的破壞有兩種型式：一種是由塑性應變的累積引起的增量塑性破壞；一種是塑性變形多次反復引起的疲勞破壞，也稱為交變塑性破壞。Abstract : the change in strength, plasticity and relaxation rate of pc steel strand before and after stabilizing has been analyzed by means of fracture and stress relaxation tests. the effect of treatment parameters and tensile stress on the properties was obtained and optimum parameters of stabilizing treatment were also proposed
文摘:通過對預應力（ pc ）鋼絞線穩定化處理及隨后的破斷、應力鬆弛試驗，分析了處理前後強度、塑性、鬆弛率指標的變化趨勢，得出了工藝溫度、張應力對性能指標的影響規律，進而提出了穩定化處理的最佳工藝參數。It is one of mechanisms of plastic distortion, at the same time it is also the beginning of microcosmic damage and rupture before the macroscopical destroying of materials, it representatives a mid - state between materials " macroscopical rupture and bend, it is considered a premonitory that the rupture of polymer material, which get common attention by scholar inside and outside nation. therefore, the research for engineering polymer in mechanic action of non - linearity destroy such as distortion, destroy and depe nd on time and temperature is valuable in theoretic research and actual application, which offer the important theoretic gist for changing complex material ' s capability and actualize polymer ' s perfect application with high quality of capability in engineering
同時，銀紋化和銀紋損傷是高聚物特有的一種現象，細觀層次的銀紋引發、生長和斷裂在聚合物損傷斷裂的整個過程中起著承前啟后的作用，它是溝通宏、微觀變形機制的橋梁，是材料塑性變形的機制之一，同時又是材料宏觀破壞以前微觀上損傷、破壞的開始，它代表材料微觀斷裂和屈服之間的一個中間狀態，可以看作是聚合物材料宏觀斷裂的先兆，受到國內外學者們的廣泛關注。因此，開展工程聚合物變形、破壞以及時間相依和溫度依賴性等非線性力學行為研究，探討聚合物破壞過程中的非線性力學行為，為聚合物及其復合材料的改性、實現聚合物的工程化與高性能化提供重要的理論依據，具有重要的理論研究意義和實際應用價值。分享友人