塗擦法 的英文怎麼說

中文拼音 []
塗擦法 英文
illinition
  • : Ⅰ動詞1 (抹) spread on; apply; smear 2 (亂寫或亂畫) scrawl; scribble 3 (抹去) cross [blot; s...
  • : 動詞1 (摩擦) rub 2 (用布、 手巾等摩擦使干凈; 揩拭; 抹) wipe; scrub; clean 3 (塗抹; 搽) spre...
  • : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
  1. Test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method

    用傾斜面測試無層書寫紙和印刷紙靜磨系數的試驗方
  2. 05. 01 coefficient of kinetic friction for wax coatings, method of test for

    層的動摩系數的試驗方
  3. Test method for coefficient of static and kinetic friction of uncoated writing and printing paper by use of the horizontal plane method

    用水平面測量非層書寫印刷紙動態和靜態摩系數的方
  4. Standard test method for coefficient of static and kinetic friction of uncoated writing and printing paper by use of the horizontal plane method

    用水平面測試無層書寫紙和印刷紙的靜磨和動磨系數的標準試驗方
  5. Where goods reach their destination in specie, but by reason of obliteration of marks, or otherwise, they are incapable of identification, the loss, if any, is partial, and not total

    貨物以原有品種抵達目的地,只是由於標識之或者其他原因而無識別的,該損失,如果有的話,是部分損失而非全損。
  6. Testing methods for paints - part 5 : mechanical property of film - section 4 : scratch hardness pencil method erratum 2

    料試驗方.第5部分:薄膜的機械特性.第4節:刮硬度
  7. Testing methods for paints - part 5 : mechanical property of film - section 5 : scratch hardness stylus method erratum 1

    料試驗方:第5部分:薄膜的機械特性.第5節:刮硬度
  8. Testing coated fabrics - method 16 - methods for determination of colour fastness to wet and dry rubbing and determination of resistance to printwear

    覆織物試驗.方16 .濕摩和干摩色牢度及印花耐磨損性測定方
  9. Usage : mop hair 80 % dry after shampoo, take adequate amount in the palm and apply it to the hair tail

    :洗發后,將頭發拭至八成干,取適量于掌心均勻抹在發尾上即可。
  10. Standard test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method

    用傾斜面測試無層書寫紙和印刷紙靜磨系數的標準試驗方
  11. Standard test method for determining the abrasion resistance of inks and coatings on membrane switches using the norman tool " rca " abrader

    使用norman工具" rca "磨器測定薄膜開關上墨水和層抗磨性的標準試驗方
  12. Standard test method for static coefficient of friction of polish - coated flooring surfaces as measured by the james machine

    用james機測量拋光覆地板表面靜摩系數的標準試驗方
  13. Standard test method for granule adhesion to mineral surfaced roofing by abrasion

    用磨測試礦物覆屋頂層顆粒粘結性的標準試驗方
  14. Directions : take a little amount of this product, apply it evenly on the face after cleansing, 2 - 3minutes later, rub roundly and lightly, remove the aged cuticle and dead cells, and then cleanse with water

    :潔面后,取適量于面部,待2 - 3分鐘后,在面上徐徐打圈拭將老化角質枯死細胞除,然後用清水洗凈。
  15. The surface orientation technique applied most widely in industrial manufacture of lcd ( liquid crystal display ) is rubbing alignment technology, whose technique is to rubbing the polyimide ( pi ) film laid on glass substrate with rubbing clothes, meanwhile this technique fits to be used in laboratory very much, as its simple flow and good orientation effect

    目前在工業上應用得最廣泛的是摩取向,即用摩布沿一定的方向摩覆在玻璃基片表面的聚酰亞胺薄膜。這種方因為其工藝簡單、取向效果好,非常適合實驗室應用。
  16. Testing coated fabrics - method 34 - method for determination of resistance to scuffing and snagging

    覆織物試驗方.第31部分:方34 :耐劃痕性和粗損性測定方
  17. Usage : apply after washing off. spread appropriate amount all over the face and softly massage for 3 ~ 5 minutes along with the skin line. lastly, wipe it out with tissue or gauze

    :取適量產品均勻于面部,用手指輕輕打圈按摩,然後用卸妝棉拭,一天一次,化妝前、皮膚乾燥時或入睡前按摩效果更佳。
  18. Standard test method for scrub resistance of paints by abrasion weight loss

    磨蝕失重測定料耐磨磨損的標準試驗方
  19. Standard test method for relative hiding power of paints by the visual evaluation of brushouts

    試外規評定料相對遮蓋力的標準試驗方
分享友人